2004 Hyundai Sonata Support Question
2004 Hyundai Sonata Support Question
Find answers below for this question about 2004 Hyundai Sonata.Need a 2004 Hyundai Sonata manual? We have 1 online manual for this item!
Question posted by mikelhigg on February 7th, 2023
Hood Latch Will Not Fully Engage
The hood latch on my 2004 Hyundai Sonata will not latch shut. I can see that it is closing part way, but it does not fully lock into place. I have adjusted the bumpers as low as they will go, but it still does not close into the locked position.
Current Answers
Answer #1: Posted by SonuKumar on February 7th, 2023 8:53 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,617,810
Member since:
May 9th, 2021 Points: 16,617,810
https://youtu.be/E4Qx8RM1gv8
There are a few potential causes for a hood latch not fully engaging, including a damaged or misaligned latch mechanism, a damaged hood, or a problem with the hood release cable. It is recommended to have the issue inspected by a mechanic to determine the cause and the necessary repair.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Manual Pages
Owner's Manual - Page 4
As a result, you may be carried out. This manual applies to all Hyundai Sonatas and includes descriptions and explanations of optional as well as standard equipment. However, Hyundai reserves the right to make changes at the time of publication. OWNER'S MANUAL
A030A04Y-AAT
Operation Maintenance Specifications
HEF-080A
All information in this Owner's ...
Owner's Manual - Page 15
... not be recorded in a place where it can contribute to the economical operation and durability of your Hyundai by observing the following recommendations ...locks. NOTE:
Before leaving your vehicle. o Use moderate acceleration.
o Whether going to drive your Hyundai. FEATURES OF YOUR HYUNDAI
B010F01A-AAT
1- 3
Operation in Foreign Countries
If you are switched to the "LOCK" position...
Owner's Manual - Page 17
... the switch is not visible, then close the door and push the lock switch to lock the door with the ignition key left in the vehicle. The light will be used. When this way, be careful not to the "LOCK" position.
o The driver's door can be locked without a key. NOTE:
o When locking the door this is done, neither...
Owner's Manual - Page 19
...HYUNDAI
B070B03Y-AAT B070C03L-AAT
1- 7
Armed Stage
Park the car and stop the engine.
CAUTION:
Avoid trying to indicate that the engine hood and trunk lid are closed and latched. 3) Lock the doors using the key. 3) The engine hood... key from the ignition switch. 2) Make sure that the system is disarmed. Unlock Lock
! HEF-218
The alarm will sound for 30 seconds (This happens 3 times). ...
Owner's Manual - Page 22
... lock release lever upward. B080B01A-AAT
Adjusting Seat Forward and Rearward
HEF-179
To move it locks into the desired position and cannot be operated for their safety.
! To revert to the "ACC" or the "LOCK" position.
This will stop and cannot be operated.
(1) Be careful that someone's head, hands and body are not trapped by a closing...
Owner's Manual - Page 25
... close to the airbag to the desired position. Seat Back Reclining Control Knob 2.
WARNING:
o Never attempt to adjust the seat while the vehicle is locked...HYUNDAI
B090A01Y-AAT B090B01Y-AAT B090C01Y-AAT
1- 13
POWER DRIVER'S SEAT (If installed)
The driver's seat can be adjusted appropriately by using the control knob. CAUTION:
1 2
HEF-180 HEF-182
Do not operate two knobs at that position...
Owner's Manual - Page 27
... (located on the top of an accident or sudden stop. FEATURES OF YOUR HYUNDAI
B110A01Y-AAT B120A01Y-AAT
1- 15
FOLDING REAR SEATBACKS (If installed)
! This could result in serious injury or death in the "LOCK" position when the rear seatbacks are available for use. In this is designed to fold the rear seatback...
Owner's Manual - Page 30
... will extend and let you move around your Hyundai Dealer. The seat belt automatically adjusts to lock the anchor into an appropriate position. To raise the height adjuster, pull it down while pressing the height adjuster button.
It will also lock if you will lock into the buckle. To adjust the height of the seat belt in an accident...
Owner's Manual - Page 42
...HYUNDAI
The airbag modules are not hazardous. Passenger's Airbag Passenger's Airbag
!
After complete inflation, the airbag immediately starts deflating, enabling the driver to the "LOCK" position...air freshener inside a vehicle, do not place it near the instrument cluster nor on ... the ignition key is in the "ON" position.
A fully inflated airbag in combination with a properly worn seat...
Owner's Manual - Page 48
...location off the engine and check under the hood. After the engine is turned to a complete...closed and latched. If the light comes on page 6-18 by your Hyundai dealer.
The warning chime only sounds whenever the key is in the "LOCK" position...place. WARNING:
If you suspect brake trouble, have your car with dual-diagonal braking systems. This means you not to a dealer by a Hyundai...
Owner's Manual - Page 55
... weather, be varied from approximately 2 to 10 seconds by turning the interval adjuster barrel. To use the intermittent wiper feature, place the wiper switch in mist, push the MIST operation switch at a time ...the wiper/ washer lever toward the steering wheel. o In areas where water freezes in this position, the interval between wipes can be sure the wiper blades are not frozen to the glass ...
Owner's Manual - Page 66
...wish to program is also recommended that the ignition switch to be turned to the "ACC" position to program and/or operate HomeLink system. It is rolling-code equipped, proceed to the "Rolling... from the bottom of the mirror. 1- 54 FEATURES OF YOUR HYUNDAI
Programming
Your vehicle may require that a new battery be placed in the handheld transmitter of the device being programmed to HomeLink for...
Owner's Manual - Page 68
...latch) is in the "LOCK" position when the trunk lid is closed while the vehicle is in the "ON" or "START" position. 1- 56 FEATURES OF YOUR HYUNDAI
B530A01A-AAT B540A01S-GAT B540B04Y-AAT
PARKING BRAKE
TRUNK LID Remote Trunk Lid Release
Trunk Lid Knob Lock (If installed)
HEF-154
B540B03Y HEF-132
Always engage... be sure that the parking brake is fully released and the indicator light is in ...
Owner's Manual - Page 71
... YOUR HYUNDAI
B570A01L-GAT
1- 59
o Do not "TOP-OFF" after the first nozzle shut off when refueling. WARNING:
If the fuel filler lid cannot be tightened at least 3 clicks, otherwise " " light will illuminate. Pull the release knob to be damaged. HXG115
!
o Do not move the vehicle with the hood in the raised position, as...
Owner's Manual - Page 115
...or a place with a low height clearance, be extended when the radio power switch is turned "ON" while the ignition key is in order to the "LOCK" position.
!
o If the antenna is fully tightened to... The antenna will automatically be sure that no one is a removable type. FEATURES OF YOUR HYUNDAI
B870A01A-AAT B870B01Y-AAT
1- 103
ANTENNA Fixed Rod Antenna (If installed)
Power Antenna (If...
Owner's Manual - Page 118
... be sure the parking brake is engaged. 3. To remove the key, always confirm that all appropriate warning lights are clean and in position. 5. It will not start the engine, you should not be sure that are in their proper positions. 6. Check your Hyundai is equipped with a manual transaxle, place the shift lever in neutral and...
Owner's Manual - Page 119
...closed or poorly ventilated area any longer than is needed to the "LOCK" position. 2. Turn the ignition key counterclockwise from the "ACC" position to the "LOCK" position. 3. To Remove the Ignition Key
ACC LOCK
STARTING
LOCK... position. The key can be removed in position. The key can be removed in the "LOCK" position. (If your car in or out of the area. 2- 4
DRIVING YOUR HYUNDAI
...
Owner's Manual - Page 120
...fully depressed when starting attempts to protect the starter from fifth gear to shift into reverse, rest the lever in premature wear of the engine may cause the engine speed to increase to placing... the clutch is engaged. When downshifting from overheating. Press the clutch pedal back down, and then shift into the reverse position. CAUTION:
HEF-238
Your Hyundai's manual transaxle has...
Owner's Manual - Page 136
... the clamps of the engine away from the hood, stop the engine. Then attach the other .... Do not connect the cable to the positive (+) post or cable of the booster battery...fully charged. If the fan is operating. Start the engine in the car with a sponge or cloth.
If this procedure exactly: 1. Place... 2. o The gas produced by your Hyundai dealer. If the booster battery is on...
Owner's Manual - Page 195
... is dangerous! Always replace your tires with bias-ply tires, they must meet Hyundai's dimensional specifications may fit poorly and result in damage to check the wheel nut...of the recommended size. The original tires on your Hyundai were balanced before being reinstalled on the road.
! Wear indicator
! After rotating, adjust the tire pressures and be installed in . (1.6 ...
Similar Questions
How To Replace Crankshaft Position Sensor 2004 Sonata 2.7
(Posted by mpukber 10 years ago)
2004 Sonata Tail Lights Leak - 2004 Hyundai Sonata
(Posted by jphillips80 11 years ago)
Wire Coloring For A 2004 Sonata 2.7 Litter V6 Engine Ignition Coil
Need to know what color from the female connector to the male adaptor on the ignition coil pack. 200...
Need to know what color from the female connector to the male adaptor on the ignition coil pack. 200...
(Posted by 4aurum 11 years ago)