Husqvarna LGT2654 Support Question
Husqvarna LGT2654 Support Question
Find answers below for this question about Husqvarna LGT2654.Need a Husqvarna LGT2654 manual? We have 2 online manuals for this item!
Question posted by 143dlewis on October 2nd, 2023
How Do I Set The Throttle Cable Properly At The Engine, A 26hp Kohler
The person who posted this question about this Husqvarna product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by SonuKumar on October 2nd, 2023 9:37 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,622,390
Member since:
May 9th, 2021 Points: 16,622,390
https://www.manualslib.com/manual/74406/Husqvarna-Lgt2654.html
To properly adjust the throttle cable on a Husqvarna LGT2654, follow these steps:
Park the mower on a level surface and engage the parking brake.
Turn the key to the "OFF" position and remove it from the ignition.
Locate the throttle cable adjustment screw at the carburetor end of the cable. It is usually a small screw with a locknut around it.
Loosen the locknut.
Turn the adjustment screw clockwise until there is no slack in the cable. Be careful not to overtighten the cable, as this can damage it.
Tighten the locknut.
Start the engine and check the throttle response. The engine should respond immediately to throttle changes. If it does not, adjust the cable again.
Here are some additional tips for adjusting the throttle cable on your Husqvarna LGT2654:
Make sure that the cable is properly routed through all of the guides and pulleys.
Check the cable for any signs of damage or wear. If the cable is damaged, it must be replaced immediately.
Lubricate the cable with a silicone spray to help keep it from fraying or binding.
Adjust the cable regularly, especially if you notice any changes in the throttle response.
If you are not comfortable adjusting the throttle cable yourself, you can take your mower to a qualified service technician.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Husqvarna LGT2654 Manual Pages
Owners Manual - Page 2
...down and behind before turning.
• Never leave a running machine unattended. WARNING
Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals ...times.
• Only allow the mower deck to a complete stop engine, and remove keys before storage. Shut off blades, set parking brake, stop before operating. Operation on the slopes slow and ...
Owners Manual - Page 3
... CHILDREN CAN BE INJURED BY THIS EQUIPMENT. Check their proper operation regularly.
• Keep machine free of the ...
the ground away from your view of age before operating a riding lawn mower. Never carry children, even with manufacturer's recommended parts, when...
• Never remove gas cap or add fuel with the engine running .
• Check grass catcher components and the discharge chute...
Owners Manual - Page 4
... a regular schedule in maintaining, caring for and using your tractor properly.
TABLE OF CONTENTS
SAFETY RULES 2-3 PRODUCT SPECIFICATIONS 4 CUSTOMER RESPONSIBILITIES ...engine and should be used , it should not be maintained in shorts and/or open toed footwear.
• Always let someone know you cannot easily remedy, please contact your purchase of this manual.
• Wear proper...
Owners Manual - Page 6
...this manual for charging instructions).
• For battery and battery cable installation see "REPLACING BATTERY" in the "Service and Adjustments" ... (See Fig. 1)
• Lift hood to ensure proper tightness.
Ignition must be on label (label is in ...release parking brake lever. TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will hold . • Pull parking brake lever up adjustment lever...
Owners Manual - Page 7
... UNDER TRACTOR (See Fig. 8) • Bring belt forward and check belt for proper routing in transaxle bracket (T), located near left as far as it is centered under
...8226; Turn steering wheel to the left rear tire in front of tractor with deflector shield (Q) to the right. FRONT Q
ENGINE
TRANSAXLE
02965
BACK
Fig. 6
Q. INSTALL ANTI-SWAY BAR (S) (IF EQUIPPED) (See Fig. 9 - 11)
ANTI-SWAY...
Owners Manual - Page 9
....
✓ Become familiar with all belt keepers.
✓ Check wiring. See that the belts are routed properly around pulleys and inside all controls, their location and function. Follow proper starting and transmission purging instructions (See "TO START ENGINE" and "PURGE TRANSMISSION" in the "Service and Adjustments" section of this manual. See "TO LEVEL...
Owners Manual - Page 11
... mower or other attachments mounted to your tractor.
(F) IGNITION SWITCH - Used for starting and controlling engine speed.
(E) ATTACHMENT CLUTCH SWITCH - Used for the engine and mower.
(Q) 12-VOLT POWER PORT - Locks clutch/brake pedal into the brake position.
(D) THROTTLE/CHOKE CONTROL - Turns the headlights on and off .
(P) SERVICE REMINDER/HOUR METER -
Disengages transmission...
Owners Manual - Page 12
.... • Pull parking brake lever (C) up and hold tractor secure.
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE(See Fig. 17)
Your tractor is standing idle with an operator presence sensing switch. ENGINE • Move throttle control (D) between half and full speed (fast) position, before leaving the operator's position. OPERATION
The operation...
Owners Manual - Page 13
...terrain or hills. • Select desired height of grass being mowed. • The average lawn should be assembled so they are approximate and may vary depending upon soil conditions, height of grass...to the blade tip with the engine not running and the attachment clutch engaged will shut off the ground. You must remain fully and centrally positioned in proper position to desired height. TO...
Owners Manual - Page 14
...8226; When use if you to slowest setting. • Make all turns slowly. NOTE: Service reminder runs when the ignition key is in the "STOP" position when engine is not running , turn the ignition... from damage when transporting your tractor on hills. • If slowing is necessary, move throttle control lever to
slower position. • If stopping is absolutely necessary, push clutch/brake
...
Owners Manual - Page 15
... depress clutch/brake pedal and set parking brake.
• Place motion control lever in neutral position.
• Move attachment clutch to "DISENGAGED" position.
• Move throttle control to fast position, wait... filler neck. Do not mix oil with the throttle control in the choke position until the engine runs roughly, then move throttle control to the
fast position.
• The attachments...
Owners Manual - Page 16
...
After one or two rounds, mow in this procedure with engine off engine and set .
2. off and parking brake set parking brake.
6. Engage transmission by placing freewheel control in ... To ensure proper operation and performance, it should be purged before mowing.
• Always operate engine at full throttle when mowing to assure better mowing performance and proper discharge of...
Owners Manual - Page 17
... operating in this manual. See Cleaning in the Service and Adjustments section of this tractor does not cover items that have been subjected to properly maintain your engine run better and last longer.
LUBRICATION CHART
➀ SPINDLE ZERK
➀ SPINDLE ZERK
➀ FRONT
WHEEL BEARING ZERK
➀ STEERING
SECTOR GEAR TEETH
➀...
Owners Manual - Page 18
... is in the disengaged position.
TIRES
• Maintain proper air pressure in the
SERVICE AND ADJUSTMENTS section of the..."leak" power.
• Disconnect BLACK battery cable first then RED battery cable and remove battery from your tractor is in... feet to leave the seat without first setting the parking brake should shut off the engine.
BLADE CARE
For best results mower blades...
Owners Manual - Page 20
MAINTENANCE
AIR FILTER
Your engine will not run properly using a garden hose or pressure washer to clean your tractor. Clean the cooling fins and ...cooling fins, and/or cooling shrouds removed will shorten the useful life of all times.
Spark plug type and gap setting are reinstalled. We do not recommend using a dirty air filter. Clean with arrow pointing towards carburetor.
• ...
Owners Manual - Page 21
... lawn, near enough to a water spigot for your garden hose to reach. Turn the water off . While sitting in the operator's position on the tractor,
re-start the engine and place the throttle lever...to using mower again. • Plug any holes in the "DISENGAGED" position, set the parking brake, and stop the engine.
3. Pull back the lock collar of its deck wash system.
WARNING: A ...
Owners Manual - Page 26
.... TO REPLACE FUSE
Replace with bolt and nut as shown.
If your engine does not operate properly due to suspected carburetor problems, take your tractor to run poorly, stop running... • Unsnap headlight wire connector. • Stand in front of tractor.
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be purged after ...
Owners Manual - Page 28
...filter. 5. Replace fuel filter. 5. Brake pedal not depressed. 2. Faulty solenoid or starter. 9. Corroded battery terminals. 3. Clean battery terminals. 3. Throttle in fuel.
8. Excessive vibration
1. Engine not "CHOKED" properly. 3. Dirty fuel filter. 7. CORRECTION
1. Replace spark plug. 5. Contact an authorized service center/department. Hard to start
CAUSE 1. Loose or...
Owners Manual - Page 29
...Place freewheel control in "FAST" position.
2. Engine throttle control not set between half and full speed (fast) position before stopping engine.
1. If not corrected, contact an authorized ... stopping engine.
1. of grass, leaves, trash under mower. 7. Blown fuse.
1.
See "CLEANING" in transmission during shipment
or servicing. 5. Bent blade mandrel. 5. Check tires for proper air...
Owners Manual - Page 31
...is not authorized to the appropriate manufacturer or as throttle cable, belt guides adjustments; All such claims must cease ...) for by Briggs & Stratton, Honda, Kawasaki, or Kohler (with the exception of models equipped with the product at...-Commercial Use. Owner's (Your) Responsibilities. Set-up and pre-delivery service, and engine tune-ups;
b. and
c. Preventative maintenance ...
Similar Questions
How Do I Run A New Throttle Cable On A Husqvarna 326 Ls I Have The New Cable But
(Posted by selenabambi2 1 year ago)
Husqvarna Lgt2654 Riding Mower
what would cause the mower to shut down when the pto is engaged? have already replaced the pto and a...
what would cause the mower to shut down when the pto is engaged? have already replaced the pto and a...
(Posted by markw1960 2 years ago)
Riding Lawn Mower
I'm trying to find torque specs for riding mower itself
I'm trying to find torque specs for riding mower itself
(Posted by Linwoodwebb4 3 years ago)
Fuel Solenoid Info.
I have an LGT2654...Kohler 26hp 7000 Series KT 745-3011 with a KEITIN carb. Fuel solenoid has failed...
I have an LGT2654...Kohler 26hp 7000 Series KT 745-3011 with a KEITIN carb. Fuel solenoid has failed...
(Posted by ridgewayjoseph 7 years ago)
Throttle Spring?
hi,how i put the throttle spring of husqvarna 3120xp?
hi,how i put the throttle spring of husqvarna 3120xp?
(Posted by husqvarnahania 9 years ago)