Husqvarna LGT2654 Support Question
Husqvarna LGT2654 Support Question
Find answers below for this question about Husqvarna LGT2654.Need a Husqvarna LGT2654 manual? We have 2 online manuals for this item!
Question posted by kristinepayne on October 26th, 2015
Deck Belt/ Pulling System
I just purchased the LGT 2654 in April 2015, with less than 50 hours on it, (brand new from Lowes for approx $2600) ... in the last 3 1/2 months I have replaced the deck belt 4x (at like $60 a piece) and the belt guard, yet the belt guard keeps coming off ,which makes the belt come off and now the new belt guard is bent, again and the new belt, that I just purchased is already started to fray, I wasnt even able to get my entire yard cut without the belt coming off again .... Lowes says that since the extended warranty wasnt purchased, then if they look at it, it would be at my own expense and I would have to bring it there to them..... I am at a loss and still paying on a very expensive lawnmower that there is obviously something going on with the pully/belt system
Current Answers
Answer #1: Posted by BusterDoogen on October 26th, 2015 12:47 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,397
Member since:
October 30th, 2011 Points: 28,565,397
It should still be under warranty.
If you do not know the location of your nearest authorized Husqvarna Servicing Dealer, call Husqvarna, at 1-800-487-5951 during the hours of 8:00 AM
to 8:00 PM Eastern Standard Time, or visit www.husqvarna.com.. Should you require assistance or have questions concerning this Limited Warranty, you
may contact us at 800-487-5951 (US) or 800-805-5523 (Canada) during the hours of 8:00 AM to 8:00 PM Eastern Standard Time or contact us through
the web at www.husqvarna.com..
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Husqvarna LGT2654 Manual Pages
Owners Manual - Page 6
...8226; Lift up and hold . • Pull parking brake lever up adjustment lever (A) and slide...purposes. TO INSTALL MOWER AND DRIVE BELT (See Figs. 3 - 14)
...and battery cable installation see "REPLACING BATTERY" in the "Service and...raise and lower
the mower deck or other people and objects....minimum of one hour at the factory ...in brake position.
ASSEMBLY
Your new tractor has been assembled at 6-...
Owners Manual - Page 7
...(See Fig. 9 - 11)
ANTI-SWAY BAR (S)
TOWARDS TRANSAXLE
TOWARDS MOWER DECK
90° END
INTEGRATED WASHER END
Fig. 9
• From right side ... under
tractor. MOWER SIDE SUSPENSION
ARMS
Q. RIGHT SIDE REAR MOWER
BRACKET E. FRONT GAUGE WHEEL
X. REAR LIFT LINK(S) D. BELT TENSION ROD L. WASHER
Z. 3/8-16 LOCKNUT
Fig. 5
3. RETAINER SPRING C. DEFLECTOR SHIELD S. ASSEMBLE FRONT GAUGE WHEEL (W)...
Owners Manual - Page 9
...deck is in the Operation section of this manual).
9 CAUTION: Belt tension rod is operating properly. Correct tire pressure is in this manual. CHECK FOR PROPER POSITION OF ALL BELTS
See the figures that are shown for replacing motion and mower blade drive belts...section of this manual.
✓CHECKLIST
BEFORE YOU OPERATE YOUR NEW TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE...
Owners Manual - Page 13
...S
Fig. 23
13 Install gauge wheel in same adjustment hole. For healthier and better looking lawns, mow often and after moderate growth. • For best cutting performance, grass over 3" ...lever in place (See Fig. 23).
Gauge wheels then keep the deck in proper position to approximately
2-1/2" during hot months.
NOTE: Adjust gauge wheels with the engine running . These heights...
Owners Manual - Page 17
...
MAINTENANCE SCHEDULE
BEFORE EACH USE
EVERY 8
HOURS
EVERY 25
HOURS
EVERY 50
HOURS
EVERY 100
HOURS
EVERY SEASON
BEFORE STORAGE
Check Brake Operation
T Check Tire Pressure R Check Operator Presence & ROS Systems A Check for loose fasteners. See Cleaning in high ambient temperatures. 2 - GENERAL RECOMMENDATIONS
The warranty on this manual.
Replace blades more often when operating in...
Owners Manual - Page 19
...; To open, pull out on level surface...belts are not broken.
• Slide lower dash cover up to the bottom fitting of this manual.
• Use gauge on dipstick. All oil must meet API service classification SG-SL. • Be sure tractor is used for 50 hours... running low on the...authorized service center/department.
Replace belts if they will drain...-20
0
30 32 40
60
80
100
C -30
-...
Owners Manual - Page 20
... new fuel filter in position in fuel line with automotive type wax. Debris can restrict clutch/brake pedal shaft movement, causing belt...engine or transmission will not run properly using a garden hose or pressure washer to clean your tractor.
ENGINE...hours of operation, whichever occurs first. CLEAN AIR SCREEN
Air screen must be replaced once each mowing season or after every 100 hours...
Owners Manual - Page 21
... with the blade. • Replace broken or missing washout fitting immediately, prior to a dry area, preferably a concrete or paved area. MAINTENANCE
DECK WASHOUT PORT (See Fig. 33)
Your tractor's deck is equipped with the cutting deck engaged until the deck is cleaned. 8. Remove bagger chute or mulch cover if attached.
2. Pull back the lock collar of...
Owners Manual - Page 22
... Install belt onto electric clutch pulley (M). remove retainer spring and washer and pull mower...
B M
A
F E
H
TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 35)
MOWER DRIVE BELT REMOVAL • Park tractor on rod and... lever to highest position. MOWER DRIVE BELT INSTALLATION • Install belt around mandrels and entire upper deck surface.
• Remove belt from spark plug and place wire where...
Owners Manual - Page 23
...ADJUSTMENT (See Figs. 38 & 39) IMPORTANT: Deck must be the same on both sides.
A...PSI shown on level ground or driveway.
NOTE: As desired, you can raise the low side of mower or lower the high side.
• Go to side of mower ...(B) to the ground at side and measure the distance (A) from bottom edge of your lawn and lead you to think the mower is not 1/8" to lower the front mower.
VISUAL...
Owners Manual - Page 24
...BELT INSTALLATION -
1. G
H
B
A
C
D
J
E
TO CHECK BRAKE
If tractor requires more than five (5) feet to stop at the factory and is held in axle groove.
• Replace axle cover.
Pull...3. Tighten securely. 7. Removebeltfromstationaryidler(C)andclutchingidler(D). 5. Install new belt from your local parts dealer. Carefully work belt down and engage parking brake. • Disengage ...
Owners Manual - Page 29
... and connections. Clean underside of drive
1. Check tires for proper air pressure.
6. Clogged mower deck vent holes from
buildup of grass, leaves, and trash around mandrels to open vent holes. Replace bulb(s) or lamp(s). 3. Replace fuse. Replace alternator. Motion drive belt worn, damaged, or broken. 4. Worn, bent or loose blade. 2. Tighten blade bolt. 2. Check wiring...
Owners Manual - Page 32
... improperly installed/removed or modified cutting shields, guards, or safety devices; (m) Any removed/damaged...belts, pulleys, spindle housings, bearings, blades, rods, height adjusters, caster/anti scalp
wheels
are NOT covered:
(a) Abrasion to mower decks, including sand wear;
(b) Damage to cutting equipment by way of purchase...1-800-487-5951 during the hours of gasohol, containing methanol (...
Owners Manual - Page 33
...*
Pump
2 Years
Other Non-Expendable Components
2 Years
All other than Rental Use)
Riding Lawn Tractors:
Frame, Chassis, Front Axle
5 Years
No Warranty
Engine*
*
*
Transmission (if.../Peerless)
3 Years
No Warranty
Transmission (if third party)**
**
**
XLS Models only - stamped deck shell. Armor Protected Limited Warranty
10 Years ***
1 Year Pro-rated 3 Years
* **
10 Years...
Owners Manual - Page 34
...purchased) Accessories (e.g., grass catcher, bumper guard accessories, etc.
1 Year
No Warranty
No Warranty
Parts (e.g., belts, blades, etc.)
30 days
No Warranty
No Warranty
Parts & Accessories (if replaced in Warranty Service) Replacement...Gear Distributor network. RZ - LCT Engines on Tiller tines and Fabricated Deck shell is for the BALANCE of the complete unit's final production, ...
Parts Manual - Page 7
...532 44 82-04 336 532 44 53-09 350 532 44 51-43 - - 532 40 09-44
Console Asm.
Deck Lift Plate Deck Lift Vent Side Hood RH Vent Side Hood LH Vent Asm Hood Top Skirt Hood Side RH Skirt Hood Side LH Bezel RH... Cover Dash RH Cover Dash LH Clip X-mas Tree Kit Bumper
NOTE: All component dimensions given in U.S. MODEL NO. LGT2654 (96045004000), PRODUCT NO. 960 45 00-40
CHASSIS
KEY PART NO.
Parts Manual - Page 9
... 43 54-86 42 532 12 48-72 49 872 11 06-14 50 532 19 43-27 51 873 90 06-00 52 532 19 43-... 09-69 64 532 19 62-00 70 532 43 96-60 73 874 49 05-60 74 532 14 24-32 80 532 44 06-19 99 ... Clutch Anti-Rotation Washer Bushing Brake Shaft Bracket Pulley Idler Reflector RH Retainer Spring Clip Handle Keeper Belt Trans. LGT2654 (96045004000), PRODUCT NO. 960 45 00-40
DRIVE
KEY PART NO. Bolt Hex Flghd 5/16...
Parts Manual - Page 11
... and replacement parts,...performance has been obtained and corrected in a given piece of power equipment (actual "on which engines are ...to -engine variability. Torque values are derived at 3060 RPM; LGT2654 (96045004000), PRODUCT NO. 960 45 00-40
ENGINE
KEY PART...445979) (Order parts from engine manufacturer.) Muffler Keeper Belt Engine Clutch Electric Pulley Engine Tank Fuel 4.0 Cap Fuel...
Parts Manual - Page 13
... 3/8-16 x 3/4 Gear, Sector Plate Washer 9/16 x 2-3/8 x 12 Ga. TRACTOR - LGT2654 (96045004000), PRODUCT NO. 960 45 00-40
STEERING ASSEMBLY
KEY PART
NO. Nut Hex Jam ...Bushing PM Front Axle Nut Lock Flange 7/16-14 Gr. 5 Washer 1.5 x .505 x .118 Bracket Deck Susp. Ring, Clip #T5304-75 Cap, Spindle Washer 25/32 x 1-1/4 x 16 Ga. inches 1... 532 19 47-47 59 532 19 47-48 60 873 97 10-00 61 532 19 47-40...
Parts Manual - Page 15
LGT2654 (96045004000), PRODUCT NO. 960 45 00-40
MOWER DECK
KEY PART NO...x 12 Ga. inches 1 inch = 25.4 mm
15 NO.
1 532 44 50-61 6 532 19 60-66 7 532 19 71-81 8 532 19 30-03 11 532 18 72-... included) Replacement Mower, Complete
NOTE: All component dimensions given in U.S. Top Lock Nut Crownlock 3/8-16 unc Pulley, Idler, Stationary LH Arm, Idler Screw, Thdroll. 1/4-20 x 5/8 Belt Deck Drive Nut...
Similar Questions
Mower Deck Belt Diagram
I'm in need of the belt diagram for a LGT2654
I'm in need of the belt diagram for a LGT2654
(Posted by gscott0925 1 year ago)
Won't Stay Running
bought brand new husqvarna weed trimmer. It won't stay starte
bought brand new husqvarna weed trimmer. It won't stay starte
(Posted by donnanne1960 1 year ago)
I Need A Diagram Of V Drive Belt For Husqvarna Lgt2654 Not The Deck Belt.
Is there a Diagram anywhere that shows the routing for the Ground Drive Belt or V Drive Belt not the...
Is there a Diagram anywhere that shows the routing for the Ground Drive Belt or V Drive Belt not the...
(Posted by anthony8908 1 year ago)
Drive Power Loss In Uphill Maneuvers?
I own a Husqvarna LGT 2654 purchased on 20 May 2015 from Lowes. However, it was actually manufacture...
I own a Husqvarna LGT 2654 purchased on 20 May 2015 from Lowes. However, it was actually manufacture...
(Posted by JJRynk 3 years ago)
Bought Mower Brand New, Hours Were At 0,
Mowed lawn 2.8 hours, went to mow again 1 week later & hours read 49.0?
Mowed lawn 2.8 hours, went to mow again 1 week later & hours read 49.0?
(Posted by shane90850 7 years ago)