Husqvarna GT48XLSi Support Question
Husqvarna GT48XLSi Support Question
Find answers below for this question about Husqvarna GT48XLSi.Need a Husqvarna GT48XLSi manual? We have 2 online manuals for this item!
Question posted by sturgonon on August 10th, 2020
Smart Switch
mower starts and runs great for about 5 minutes then just shuts off, all the lights on the switch go out a minute later they come back on and the mower starts back up and quits after about 5 minutes of mowing, now the elec- pto switch quit i bypassed lt from the smart switch and it works. the battery light started blinking and wont quit, the amp guage is showing i charge and not draining the battery, i however installed a new battery but its doing the same thing. i even changed the oil and filter thinking mabey there is a oil sensor switch still no change.
Requests for more information
Request from sturgonon on August 10th, 2020 12:00 PM
the battery is not going dead, its like turning the switch off. no power at the smart switch, 1 minute later power comes back on at the smart switch, will start and run for 5 minutes then shuts back off
the battery is not going dead, its like turning the switch off. no power at the smart switch, 1 minute later power comes back on at the smart switch, will start and run for 5 minutes then shuts back off
Current Answers
Answer #1: Posted by Odin on August 10th, 2020 7:33 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,630
Member since:
April 10th, 2010 Points: 41,236,630
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Husqvarna GT48XLSi Manual Pages
Owners Manual - Page 2
...mower deck to stabilize the machine by the blades.
• Ensure the area is clear of California to neutral and coast downhill. • Avoid starting, stopping, or turning on it, do not mow... bystanders before turning. Shut off blades, set...• Never leave a running machine unattended. If you ...in daylight or good artificial light.
• Do not ...for all parts to come to roll over the ...
Owners Manual - Page 3
...light such as necessary.
Mow up and down and behind before operating a riding lawn mower.
Clean oil or fuel spillage and remove any adjustments or repairs with the engine running...starting, stopping, or turning on a truck or
•
trailer bed with manufacturer's recommended parts, when necessary.
• Mower... children, even with the blades shut off . Repair, if necessary,...
Owners Manual - Page 6
... are properly inflated. (For shipping purposes,
the tires were overinflated at the factory).
✓ Ensure mower deck is adjusted comfortably and tightened securely. ✓ All tires are routed correctly. Follow proper starting and transmission purging instructions (See "TO START ENGINE" and "PURGE TRANSMISSION" in safe operating condition. ✓ Ensure Operator Presence System and...
Owners Manual - Page 7
..., serious injury and/or property damage. REVERSE
NEUTRAL
HIGH
LOW
COLD WEATHER FAST STARTING POSITION
SLOW
SMARTSWITCH™ IGNITION
ENGINE OFF REVERSE OPERATION
SYSTEM (ROS)
ENGINE ON
ENGINE START
PARKING BRAKE
MOWER HEIGHT
LIGHTS ON
FUEL BATTERY
REVERSE FORWARD CRUISE CONTROL
MOWER LIFT CLUTCH/BRAKE PEDAL
15
15
ATTACHMENT
ATTACHMENT
CLUTCH DISENGAGED CLUTCH ENGAGED
DANGER...
Owners Manual - Page 8
... voltage or a charging system fault.
(J) CRUISE CONTROL LEVER - Indicates hours of the battery.
(Y) DIFFERENTIAL LOCK SWITCH - Used to raise and lower mower or other attachments mounted to tractor.
(EE) BLADE SWITCH SYMBOL - Used for braking the tractor and starting /stopping engine and communicating status updates.
(G)* REVERSE OPERATION SYSTEM (ROS) - OPERATION
KNOW YOUR TRACTOR
READ...
Owners Manual - Page 9
.... TO CONTINUE MOWING
• Return to place attachment clutch switch in the "ENGAGED" position without the operator first being in this possibility, always stop mower blades, place attachment clutch control in operating position, depress brake pedal and set parking brake before the operator leaves the seat, the engine will immediately shut off the engine...
Owners Manual - Page 10
...only.
For healthier and better looking lawns, mow often and after moderate growth.
&#...with the engine not running. Other conditions such as trimming ...differential lock switch to desired height. TO ADJUST MOWER CUTTING ...HEIGHT (See Fig. 10)
The position of damage, avoid engaging differential lock while vehicle is controlled by the forward and reverse drive pedals. • Start...
Owners Manual - Page 11
...switch. REVERSE OPERATION SYSTEM (ROS) (See Fig. 13)
Your tractor is strongly discouraged. WARNING: Backing up or down and behind before starting up with the attachment clutch engaged while mowing is equipped with tractor on mowers... button (G) will stop mower blades.
Ensure the transmission is running , depress brake pedal...children or other bystanders will shut off the engine. Install ...
Owners Manual - Page 14
... release the SSI button once more to start the engine. • Once engine starts, move throttle from a few seconds to a minute depending upon conditions and temperature. • Leave throttle control in fast position ( ) while mowing. Wait until all the following starting in poor engine performance and spark plug fouling. STARTING
The Briggs & Stratton Endurance engine equipped...
Owners Manual - Page 15
...reverse drive pedal to full reverse position, hold for best mowing performance.
Have the cut area to the right of manual... tractor seat, start engine. Sitting in the tractor seat, start engine. After the engine is running.
See "TO LEVEL MOWER HOUSING" in...onto the area
that will discharge away from dried clippings. Shut- Drive tractor forward for approximately 5 feet (1,5 m) ...
Owners Manual - Page 17
...disengaged position. BLADE REMOVAL (See Fig. 22)
• Raise mower to highest position to allow access to shift in reverse should NOT ...-55 Ft.
BLADE
• The engine should not start unless the parking brake is engaged, and the attachment ... by the operator to leave the seat should shut off the engine.
• With the engine running , the SmartSwitch Ignition
(SSI) button (F) ...
Owners Manual - Page 19
...whichever occurs first. CLUTCH/BRAKE PEDAL CLEAN TOP SIDE
STEERING PLATE
STEERING SYSTEM, DASH, FENDER AND MOWER NOT SHOWN
Fig. 27
• Keep finished surfaces and wheels free of the engine are covered... Operating the engine with automotive type wax.
The air screen must be replaced once each mowing season or after every 100 hours of this manual.
SPARK PLUGS
Replace spark plugs at ...
Owners Manual - Page 20
IMPORTANT: Ensure the tractor's discharge chute is directed AWAY from your garden hose to a level, clear spot on the tractor,
re-start the engine and place the throttle lever in the Fast " " position. Remain in the operator's position on your lawn, near enough to using mower again.
20 Turn the water off . Drive the tractor...
Owners Manual - Page 29
...3. Dirty fuel filter. 5. Engine valves out of mower housing.
4. Check all wiring. 4. Brake pedal not depressed. 2. Faulty ignition switch. 8. Loss of grass, leaves, trash under mower. 3. Build-up of power
1. Excessive vibration
1. Replace blade. Dirty fuel filter. 6. Wait several minutes before attempting to start
1. Empty fuel tank and refill tank with fresh, clean...
Parts Manual - Page 3
GT48XLSi ...SEAT SWITCH (NOT OCCUPIED)
BLACK
M
ELECTRIC DIFFERENTIAL ACTUATOR
NO
REVERSE SWITCH (NOT IN REVERSE)
1 GRN/WHT 2 YEL/WHT 3 BLACK 4 RED 5 BLACK 6
FUEL SHUT-OFF...CONNECTOR (MATING SIDE)
3
6
2
5
1
4
7
ELECTRIC DIFFERENTIAL SWITCH CONNECTOR
(MATING SIDE)
3 PIN NUMBER)
RED-11
SMART IGNITION SWITCH (S.I.S.)
-DO NOT OPEN! -PERMANENT DAMAGE CAN RESULT IF PROPER DIAGNOSTIC ...
Parts Manual - Page 5
NO. Switch Seat Switch Ign Smart Harness Ign....Battery Bolt Hex Hd 1/4-20 unc x 3/4 Battery Box Switch Interlock Harness Socket Light Cable Battery Cable Starter Fuse Nut Keps Hex 1/4-20 unc ... Switch PTO Screw Thdrol 5/16-18 x 3/4 Outlet 12-Volt Harness chassis Switch Cover Terminal Battery Strap Battery Screw Hexwsh Thdrol 1/4-20 x 3/4 Washer 9/32 x 7/8 x 16 Ga. MODEL NO. TRACTOR - GT48XLSi...
Parts Manual - Page 7
...Screw Hxwsh Thdr 3/8-16 x 5/8 Clevis .375 x 2.42 Nylon Spacer .375 x .4375L Plug Light Switch Kit Guard Brush
NOTE: All component dimensions given in U.S. Deck Lift Plate Deck Lift Vent Side ... Fender Nut Center Lock 5/16-18 unc LED Light LH Insert Reflect. Net Nut Push Chassis Dash Lower Bolt 5/16-18 x 1-1/4 Screw 5/16-18 x 3/4 Insert Reflect. GT48XLSi (96043017700), PRODUCT NO. 960 43 01-77...
Parts Manual - Page 15
... 5/16 x 3-1/2 Spring Ball Bearing Pulley Clip Retainer Rod Anti-Sway Washer 13/32 x 13/16 x 12 Ga. GT48XLSi (96043017700), PRODUCT NO. 960 43 01-77
MOWER DECK
KEY PART NO. NO.
1 574 80 89-02 2 539 11 21-70 3 532 18 76-90 4 ..., 3/8-16 Hex Jam Nyloc Nose Roller Rod Roller Nose Pin Cotter 5/16 Bow Tie Lock Washer, 3/8 x 7/8 x 14 Ga. Mower Deck Complete
NOTE: All component dimensions given in U.S.
Parts Manual - Page 16
MODEL NO. GT48XLSi (96043017700), PRODUCT NO. 960 43 01-77
MOWER LIFT
LIFT TEX?
KEY PART NO.
Front Mower Nut Jam 7/16-20
NOTE: All component dimensions given in U.S. DESCRIPTION
...574 82 25-01 114 873 36 07-00
Link Lift Susp Mower Rear Bushing Spherical Screw 3/8-16 x .75 Link Lift Susp. NO. inches 1 inch = 25.4 mm
16...
Parts Manual - Page 18
GT48XLSi (96043017700), PRODUCT NO. 960 43 01-77
DECALS
16
15
17 16
14 14
4 9
1 7
6
3
2 10
5
8
KEY PART NO. Decal, Pedal Decal, HV Decal, Battery Dnge/...-01 7 532 41 86-00 8 532 44 81-21 9 532 14 50-05 10 586 06 62-01
DESCRIPTION
Decal, Operator's Decal, No Step Decal, Mower Schematic Decal, Warning Decal, Fuel Selector Decal, Eng. H.P. MODEL NO. TRACTOR -
Similar Questions
Totally Frustrated With My Husqvarna Riding Mower!
When I needed a new riding lawn mower, I went to a local dealer, which I was told was the best place...
When I needed a new riding lawn mower, I went to a local dealer, which I was told was the best place...
(Posted by beachgirllynda 6 years ago)
Smartswitch Will Not Turn Green And Start
Smartswitch will not turn green and start. Followed all troubleshooting in manual with no success.Se...
Smartswitch will not turn green and start. Followed all troubleshooting in manual with no success.Se...
(Posted by aylorr 9 years ago)
Mower Will Not Go Into Gear
how do u replace a motion drive belt on a yth2042
how do u replace a motion drive belt on a yth2042
(Posted by lindakbrown 9 years ago)
