Hotpoint GSM2260NSS Support Question
Hotpoint GSM2260NSS Support Question
Find answers below for this question about Hotpoint GSM2260NSS.Need a Hotpoint GSM2260NSS manual? We have 4 online manuals for this item!
Question posted by myrthmaker on June 27th, 2011
Installing A Ge Gsm2260nss Under Sink Dishwasher With Gpf97 Double Bowl Sink.
I am installing a New GE GSM2260NSS Under Sink Dishwasher with the GPF97 Double Bowl Sink. I am running into a couple road blocks. Does anyone have this setup and if so will you send photos of how everything is supposed to look under the sink? What I am doing does not seem to be matching up with either of the installation instructions. I am doing this for my wife who is severely disabled. Any help would be greatly appreciated.
Current Answers
Related Hotpoint GSM2260NSS Manual Pages
Installation Instructions - Page 1
...instructions. The dishwasher MUST be worn.
See the Owner's Manual for future reference.
• Skill Level - READ CAREFULLY. Observe all CAUTIONS and WARNINGS shown throughout these instructions with your dealer or builder. Proper installation is not covered under the GE Appliance Warranty. Product failure due to Installer - Optional Accessories - New installations require more...
Installation Instructions - Page 2
... SUPPLIED
IN INSTALLATION PACKAGE:
■ Two #8-18 x 5/8" Phillips special head screws, to secure dishwasher to underside of countertop
■ Junction box cover ...;ushing the line
15/16" Socket
■ 15/16" socket (optional for skid removal)
■ Gloves
For New Installations Only:
■ Tubing cutter ■ Drill and appropriate bits ■ Hole saw set
Flashlight
Gloves
2
Level
...
Installation Instructions - Page 3
..., incendio o lesiones a personas, el instalador debe asegurarse de que el lavaplatos esté completamente cerrado en el momento de la instalación.
• The dishwasher must be installed so that drain plug has been removed.
Figure B. NOTE: Air gap must not support any part of the enclosure. DETERMINE DRAIN METHOD
The type...
Installation Instructions - Page 4
... extension cord or adapter plug with plug must be run with the circuit conductors and be connected to 18...sink cabinet rear wall, 6" min. NOTE: Power cords with this appliance. Hole (Max.)
24" from Wall
3" from the rear wall. • For power cord connections, install... that the appliance is installed and grounded in a risk of dishwasher. • For permanent connections the ...
Installation Instructions - Page 5
... electrical cable and drain hose. Or, cut an additional 1-1/2" diameter hole to begin dishwasher installation.
5 Install the hot water inlet line, using no less than 3/8" copper tubing.
If power ...8226; The hot water supply line pressure must not pass through the same hole as under the sink. (Optional, but strongly recommended and may pass through power cord hole.
1-1/2" Dia. Route the...
Installation Instructions - Page 6
... I
Toekick
Remove 2 Toekick Screws
Figure G
Tip: Make sure door opens and closes smoothly. Check to the installation location and lay
it gently drops from a 1/2 open easily or falls too quickly, check spring cable routing. Dishwasher Installation
CAUTION:
Do not remove wood base until you are ready to correct balance. Si se quita la...
Installation Instructions - Page 7
... screw kit set aside in contact with thread seal tape. Position clamp so screw is approximately
78" long.
Dishwasher Installation
STEP 5: INSTALL POWER CORD
Skip this step if dishwasher will be purchased from an authorized GE appliance dealer. Prevent drain hose damage and
possible leaks. Be sure wires are
threaded through small hole in Step...
Installation Instructions - Page 8
... end through the opening a few inches at a time.
4"
6"
6"
Water House Line Wiring
Figure M
STEP 9: INSTALL DRAIN HOSE, THROUGH CABINET
• Position dishwasher in front of dishwasher and components under dishwasher. Insert drain hose into the opening under or behind the dishwasher.
8
Figure O
Do not push against front panel
with knee. Start with base of cabinet...
Installation Instructions - Page 9
...Correct Alignment
Figure Q
Incorrect Alignment will likely result .
• The dishwasher is in Step 1.
• Install side-mount brackets if underside of countertop is wood or
wood-like ...Cabinet Frame
Bend back and forth at the notches until they break off. Dishwasher Installation
STEP 12: INSTALL GPF65 SIDE-MOUNT
BRACKETS
Skip this step if underside of countertop is
granite or...
Installation Instructions - Page 10
...the dishwasher by ...dishwasher .... Verify dishwasher is wood, use ...dishwasher must not hit cabinets or countertop. • Fasten the dishwasher...dishwasher.
10
Method 2 Secure dishwasher to cabinet sides. The dishwasher must not hit cabinets or countertop. • Fasten the dishwasher...Method 1 Secure dishwasher to Figure U....dishwasher in Figure S.
• The dishwasher.... Dishwasher must...
Installation Instructions - Page 11
.... • Determine size of inlet port. • Cut drain hose connector on the marked line, if required,
to fit the inlet port.
Cutting Line
1"
5/8"
Method 2 - Dishwasher Installation
STEP 16: CONNECT WATER SUPPLY
Connect water supply line to 90° elbow. • Slide compression nut, then ferrule over end of water line. •...
Installation Instructions - Page 12
...aprobados por UL. Check to be sure it does not roll back or forward on the sink hot water faucet and verify water temperature. If door drops or closes when released, adjust spring...Steps 14 and 15.
■ Pull lower rack out, about halfway. If door hits cabinet, reposition dishwasher. Dishwasher Installation
STEP 18: CONNECT POWER SUPPLY
If a power cord with plug is not 2-wire with ground, a ...
Installation Instructions - Page 13
... two toekick attachment screws.
See Steps 7 and 17.
■ Open dishwasher door and make sure it is against adjacent cabinets. See Step 17.
■ Press Start/Reset pad once again and run dishwasher through another "Rinse Only" cycle. Check drain lines. Dishwasher Installation
STEP 20: DISHWASHER WET TEST
■ Turn on .
■ Check for leaks under...
Quick Specs - Page 1
... recommended. Inlet water pressure required-15 to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at dishwasher. For answers to 120 lbs./sq. GSM2260N
GE Spacemaker® Under-the-Sink Dishwasher
Dimensions and Installation Information (in accordance with ground must be installed. inch. All plumbing and electrical work must be in inches...
Quick Specs - Page 2
...Hot water Valve to shut off water to dishwasher
Hot water supply to dishwasher Dishwasher drain hose
Dishwasher water inlet Electrical valve junction box (on dishwasher)
6" Double-bowl stainless steel sink
GFC290/300/700 Disposall® unit 1-1/2" Directional flow tee
Sink strainer assembly
Countertop 25" deep 1-1/2" thick
Spacemaker® dishwasher
1-1/2" Close elbow
Cold water Hot water...
Quick Specs - Page 3
... be provided by Underwriters Laboratories
Specification Created 10/07
350512 to dishwasher is less than 20-1/2" maximum specified distance form the wall, or if the base cabinet is installed in the front view illustration. B
24
12"
24 MIN. When using double bowl sink.
A
C FRONT VIEW
FRONT VIEW 6" MAX. thick
7-1/2 7-1/2
C Toe kick area Toe kick
3/4"
34...
Quick Specs - Page 4
Runs quietly and efficiently to any space, providing a roomy
area for dependable
performance every time • Model GSM2260NSS - Brings a ...GE Spacemaker® Under-the-Sink Dishwasher
Features and Benefits • Stainless Steel Door - Provides convenient space and capacity to clean
silverware efficiently and effectively • QuietPower™ Motor - Stainless steel
GSM2260NSS...
Use and Care Manual / Warranty - Page 2
...be properly installed and located in this manual.
Check with
is connected to a
I On dishwashers with your dishwasher, you are in Anti-bacterial mode, if
I If your dishwasher unless it...- SAVE THESE INSTRUCTIONS
WARNING!
I Connect the dishwasher/appliance to the
I Dispose of the dishwasher may be hot to run an equipment-grounding conductor with the heating element and...
Use and Care Manual / Warranty - Page 12
... models)
You can be ordered and installed when the door panel weighs four lbs. Air gap
Does Your Dishwasher Have an Air Gap? It is not a part of your dishwasher by your GE Appliance dealer to get the correct kit for securing the dishwasher:
I GPF375/GPF475
NOTE: The GPF100 dishwasher door spring kit must also be...
Use and Care Manual / Warranty - Page 13
... Tips Save time and money!
Power is turned off
• In some installations, power to the dishwasher is reached.
Wrong detergent was spilled • Always wipe up rinse agent spills immediately.
minerals
• Run dishwasher with a Dial: Close and latch the dishwasher.
Pump out water by iron deposits
in water
White film on inside •...
Similar Questions
Owner Wants To Replace With Ge # Gdf510pgd D/w
Owner wants to replace this with a GE # GDF510PGD built-in dishwasher; is it going to fit?
Owner wants to replace this with a GE # GDF510PGD built-in dishwasher; is it going to fit?
(Posted by mc67322 11 years ago)
Dishwasher Will Not Pump Out The Water To The Drain
I recently purchased the model HDA2100VWW dishwasher. It will not pump the water out of the tub.
I recently purchased the model HDA2100VWW dishwasher. It will not pump the water out of the tub.
(Posted by kelliot9 11 years ago)
Dishwasher Racks Are Rusting. Are They Under Warranty Or Can They Be Replacerd
Dishwasher is 6 years old and works fine.
Dishwasher is 6 years old and works fine.
(Posted by 22stuart 11 years ago)
Under The Sink Dishwasher
(Posted by Anonymous-48550 12 years ago)
Dishwasher Runs Through Cycle But Makes A High Pitched Whining Noise.
Dishwasher is a Hotpoint, model HDA2000TBB
Dishwasher is a Hotpoint, model HDA2000TBB
(Posted by mgs61 12 years ago)