Hoover UH70120 Support Question
Hoover UH70120 Support Question
Find answers below for this question about Hoover UH70120 - WindTunnel T-Series Rewind Bagless Upright.Need a Hoover UH70120 manual? We have 1 online manual for this item!
Question posted by katrumble on March 27th, 2013
Power Cord Problem
The power cord on my Hoover Wind Tunnel (only about two months old) is stuck and won't pull out all the way. Can you help?
Current Answers
Related Hoover UH70120 Manual Pages
Manual - Page 1
...
Español - For assistance, please call Customer Service at 1-800-944-9200 Mon-Fri 8am-7pm EST. Questions or concerns? página E1
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE.
IF USED COMMERCIALLY WARRANTY IS VOID.
©2010 Techtronic Floor Care Technology Limited.
Manual - Page 2
... video instructions for choosing a HOOVER® product.
Thank you for...Vacuum Description 6 On-Off Switch 6 Suction Only Mode 6 Cord Rewind and Storage 6 Folding Handle 6 Carpet Height Adjustment 7 Tools ...7 Select Proper Tool 7 Removing Hose 7 Attach Wand And Tools 7 Stair Cleaning 8 How To Clean Tools 8 Maintenance...8 Dirt Cup...9 Filters...9 Brushroll...11 Hose...11 Powered...
Manual - Page 3
...all controls before connecting Powered Hand Tool. &#...8226; Operate vacuum only at ...rewinding (cord rewind available on select models only). • Unplug before unplugging. • Use extra care when cleaning on cord, or pull cord...upright position, unless the cleaner is necessary when used as a handle, close a door on stairs. Do not use outdoors or on cord. Not intended for use cord...
Manual - Page 4
...of electric shock, this product, as they may cause damage. • Store in upright
position. PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE.
4 Always put the ... DAMAGE:
• Avoid picking up hard, sharp objects with this appliance has a polarized plug (one way. IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. Questions or concerns? For assistance, please call Customer Service...
Manual - Page 5
...per model
Remove all parts are located before disposing of packing materials. Vacuum ASSEMBLY
Carton contents
A. Vacuum Base C. Powered Hand Tool* D. Push down firmly.
1.3 Using a Phillips screwdriver, fasten (1) screw behind handle into vacuum base.
1.2
1.3
Attach dirt cup
1.4 Place bottom of Powered
Hand Tool and pivot into clip until instruction 1.3
1.2 Insert handle section into...
Manual - Page 6
...
and Carbon Filter* Access 13. Hold plug when rewinding onto cord reel. A
IMPORTANT When pulling on A bare floors, brushroll
should be turned off. Actual model may vary from cord reel until red tape is visible on the cord, the cord has reached its allowable extended length. HOW TO USE
Vacuum Description
1. Carry Handle 5. Folding Handle Release*
2.1 1 2
15...
Manual - Page 7
...when handle is used in tight spaces, corners and along edges in upright position unless vacuum is desired, while maintaining good cleaning performance. D. Crevice Tool may vary...pull hose end out.
Select Proper Tool
(Tools may be used for cleaning surfaces above tools. Removing Hose
Attach Wand and Tools
3.2
To remove hose for reaching hard to your hose.
Powered...
Manual - Page 8
...NOTICE ! Actual model may continue. Never leave the vacuum standing on stairs. Use extra care when cleaning on ...2. If the thermal protector continues to back. When using .
4. PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
If System Check 1. reference pg. 9
3. ... when not cleaning.
3.4
3.5
3.5 Use the Hose and Powered Hand Tool (Tool varies per model) for 30 minutes, ...
Manual - Page 9
... line (A).
Do not use vacuum without dirt cup or filters in Fig. 4.3.
4.6 Pull up to 24 hours.
Close dirt cup door (C).
IMPORTANT
Allow filter to dry completely before servicing.
To reduce the risk of injury from water and squeeze a final time to secure at least every two months under running water for two...
Manual - Page 10
...; Part No. 902404001. Your Carbon Filter is available at Hoover.
Additional filter is located on vacuum.
!
Do not use vacuum without dirt cup or filters in place.
4.9
A
4.10
Remove dirt cup as described in slots, pull filter frame (A) straight out. C
4.11 Place the filter assembly on the dirt cup,
A
aligning (3) tabs (A) on filter with...
Manual - Page 11
... the three tabs along front edge of injury from moving parts, unplug vacuum before servicing.
4.18 Turn tool so bottom faces up . Rotate red...nozzle. Rotate back into hose tube until you hear a click.
4.17
A
Powered Hand Tool: How to clean out hose as they can cause damage. To ...! Do not use , press the hose release button (A) and pull hose end out. To lock back into place, push hose into...
Manual - Page 12
Ask for Hoover® Part No. 27313-107.
4.22 4.23
belt
! To check the belt, refer to replace
4.24 Turn vacuum over so bottom side is facing up. removing ...
4.26 Lift off lens. installing bulb
4.22 Pull old bulb straight out of electrical shock, unplug vacuum before servicing.
4.24 A
The belt is located under the bottom plate of the vacuum and should be checked from motor shaft (metal...
Manual - Page 13
... back into nozzle making sure that the brushroll end caps are in place, pull and slide brushroll into position.
HOOVER® part No. 562289001 or AH20065.
Slide red lower latch to Lock ... -
If desired, additional belts can be purchased at Hoover.com or 1-800-944-9200
4.28 With lettering on outside of nozzle guard with your vacuum. When purchasing a new belt for models with Brushroll ...
Manual - Page 14
...solved quite easily when the cause is found by an authorized service representative.
! unplug vacuum before servicing. Power cord not firmly plugged 1. into outlet.
2. Thermal Protector activated.
3. with HEPA media ... authorized Hoover® dealer.
1. Bulb burnt out.
1. PROBLEM
Vacuum won't run
System Check Indicator has turned red or Vacuum won't pick up or Low suction
Cord Rewind does...
Manual - Page 15
....
15 This will only result in Glenwillow for service. Customers) or hoover.ca (Canadian customers). Do not send your vacuum by :
• Checking the Yellow Pages under "Vacuum Cleaners" or "Household". • Visit our website at hoover.com (U.S. Follow the service center link to Hoover®, Inc., Company in delay. Mon-Fri 8am-7pm EST...
Manual - Page 16
... cover pick up, delivery, transportation or house calls. This Warranty shall be paid one way.
Military Exchange and outside the country in which the product was initially purchased and resales ...your product to misuse, acts of God, nature, vandalism or other acts beyond the control of Hoover®, owner's acts or omissions, use of Ohio. This warranty does not cover products purchased from...
Similar Questions
Hoover Windtunnel T-series Rewind Upright Vacuum Bagless Uh70120 Motor Wont
work
work
(Posted by rexadria 9 years ago)
Wont Turn On Hoover Windtunnel T-series Pet Rewind Plus Upright Vacuum Bagless
uh70210
uh70210
(Posted by rerecjrot 10 years ago)
Hoover Windtunnel T Series Rewind, Cord Wont Pull Out
(Posted by paulstaba 10 years ago)
My Hoover Windtunnel T-series Pet Rewind Bagless Upright Vacuum Wont Turn On.
I cleaned out underneath and emptied it and it won't turn on. Plugged into different plugs and still...
I cleaned out underneath and emptied it and it won't turn on. Plugged into different plugs and still...
(Posted by megancorgan 11 years ago)
Cord Problems With T Series Rewind
The cord on my Hoover T Series Rewind vacuum cleaner will no longer come out; however, it will retra...
The cord on my Hoover T Series Rewind vacuum cleaner will no longer come out; however, it will retra...
(Posted by tristaaustin 13 years ago)