Hoover FH40010 Support Question
Hoover FH40010 Support Question
Find answers below for this question about Hoover FH40010.Need a Hoover FH40010 manual? We have 1 online manual for this item!
Question posted by imjanedough2 on October 6th, 2013
Leaky Tank & Loose Gasket
I have the Max Extract 77 and the solution was leaking from the tank. Was troubleshooting w/ Customer Service & they determined it was the tank. Tried new tank and still leaks. Appears that rubber gasket is not seated properly. 1) Anyone else fix their leak problem, 2) how do I seat the gasket right?
Current Answers
Related Hoover FH40010 Manual Pages
Manual - Page 1
...;gina E1
FloorMate™ SpinScrub® Hard Floor Cleaner
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. IF USED COMMERCIALLY WARRANTY IS VOID.
©2009 Techtronic Floor Care Technology Limited. All rights reserved. #960009623 ID100507-R0
For assistance, please call Customer Service at 1-800-944-9200 Mon-Fri 8am-7pm EST...
Manual - Page 2
...Cleaner Description 6 ON/OFF Switch...6 Handle Release Pedal 6 Transporting...7 Mode Selector Dial 7 The Tanks ...8 Filters...9 How To Clean...10 Recommended Cleaning Sequence 10 Cleaning Floors 10 Picking Up Spills 10 Maintenance...11 Nozzle...11 Brushes...12 Storage...12 Lubrication...12 Troubleshooting...13 Service... to speak with a customer service representative; Verification of date...
Manual - Page 3
...8226; Always install float before any time. • Keep hair, loose clothing, fingers, feet and all controls before servicing the cleaner. • Unplug cleaner when not in use cord as a toy or to a properly ...extra care when cleaning on cord. Do not place cleaner on cord or pull cord
around sharp edges or corners. Do not use without tanks in areas where they may be present. •...
Manual - Page 4
...grounding plug that is properly installed and grounded in accordance with a qualified electrician or service person if you are in the instructions. • WARNING: This product contains chemicals...adapter is not working as it to a Hoover Sales and Service Center or Authorized Hoover® Warranty Service Dealer. • Use cleaner only for machine applica- The temporary adapter should , has...
Manual - Page 5
...all parts are out. Make sure all parts from squeegee area on underside of cleaner.
Remove cardboard packing insert from carton and identify each item shown. Turn brushes slightly...
1.2 Rotate bottom handle support (A) up to lock in upright
1.4
B
position. Tilt cleaner back so that it snap in place.
1.2
A
Install brushes and nozzle
1.4 To install brushes, place handle in place...
Manual - Page 6
... a single position, but "floats" to
2.1
2
release cleaning solution
1
4. ON/OFF Switch 3. Clean Water Solution Tank
Release
6
8. Nozzle
11
13. Dirty Water Tank: collects dry
debris as well as dirty cleaning solution 11. Squeegee (underneath nozzle)
12 14 13
14. HOW TO USE
Cleaner Description
1. Bumper
Operate cleaner only at voltage specified on data plate on...
Manual - Page 7
... .
2.7 For dry debris pickup, turn the dial to room, put handle in upright position, tilt cleaner back on rear wheels and push forward.
2.5 The cleaner may also be lifted using the carrying handle (A) on the front of the cleaner.
2.4
2.5
A
Mode selector dial
2.6 The Mode selector dial (A) turns the brushes on and off the...
Manual - Page 8
... using water to prevent leaking.
2.14 Slide tank straight into tank (C). Fill tank to serve as shown.
2.13 Replace cap.
Rotate cap clockwise until latch snaps in place. Cap must be dispersed onto the surface being cleaned. The Clean Water Solution Tank holds detergent and water that is to Fill
Place carpet cleaner handle in place for...
Manual - Page 9
... Tank (lower tank)
Automatic "Shut Off"
An automatic suction shut-off is built into cleaner body until snapped in place.
Empty tank.
2.15
G
filters
The tank lid contains a washable, reusable filter. Remove loose ...Dirty Water Tank, place bottom of the motor will also collect on release button (G) and pull tank straight out.
2.16 Remove tank lid (H). Check the Clean Water Solution Tank also....
Manual - Page 10
...of these conditions exist. Repeat cleaning motion. Fill Clean Water Solution Tank with brushes turned ON, turn the dial to the WASH ...Cleaner to: • VACUUM: Vacuum to
help prevent streaking. Set Mode selector dial to release solution as needed.
To greatly enhance drying of the floor surface.
The cleaner's suction will provide light agitation to remove loose...
Manual - Page 11
...servicing should be in depth) on cleaner.
4.5 While holding nozzle in place.
4.1
A
4.3
4.5
4.2
B A
4.4
EF D
C D
11 To reduce the risk of injury from squeegee (C) and wipe with these home maintenance tasks as proper use the cleaner to the WASH position and release the trigger.
Picking up spills
Your cleaner...nozzle: How to Clean
Your carpet cleaner is equipped with opening (F) on non...
Manual - Page 12
...cleaner to upright position. Replace tanks.
4.8 D
C
4.10
4.7 B
A
4.9
FG E
E
StorAGE
Before storing cleaner:
Turn cleaner OFF and disconnect from moving parts,
unplug cleaner before servicing...solution and Dirty Water Tanks. Remove tanks to motor bearings.
12 Set aside.
4.6 Pull the two nozzle release buttons (A) out.
Do not add lubricant to prevent leaking.
The addition of cleaner...
Manual - Page 13
...ON/OFF switch to turn cleaner OFF. (2) Unplug the cleaner. (3) Wait one minute. (4) Plug the cleaner into outlet.
2. Refill Clean Water Solution Tank.
1. Replace fuse/reset breaker in place.
2. Tanks not in place.
2. Tanks not in place. 4. Make sure Dirty Water Tank is found by an authorized service representative.
! Blown fuse or tripped breaker.
1. TROUBLESHOOTING
If a minor...
Manual - Page 14
... the complete model number when requesting information or ordering parts. (The model number appears on the bottom of authorized service outlet locations call 1-800-944-9200. Always identify your vacuum to find the service outlet nearest you need further assistance: To speak with a customer service representative call1-800-263-6376; Mon-Fri 8am-7pm EST. 6.
Manual - Page 15
... internal component damage, use only Hoover® cleaning products and Hoover® hard surface attachments intended for use Hoover® brand
detergents, wipes, and spot cleaners available at
Hoover.com and retailers nationwide.
15 7.
Manual - Page 16
...have others that vary from a party that is not as maid, janitorial and equipment rental services), improper maintenance of the product, damage due to correct any such defect in products purchased in... may not be extended by the original owner. Some states do not allow the exclusion of warranty service outlets, phone the Hoover® Consumer Response Center, Phone 1-800-263-6376, Mon-Fri 8am...
Similar Questions
Water Leaking Where Tank Sits In Machine.
Water is leaking out of the bottom of the tank only when it is seated in the machine....making the w...
Water is leaking out of the bottom of the tank only when it is seated in the machine....making the w...
(Posted by callawaytonya 10 years ago)
Hoover Max Extract 77 Power Problems
I was given the machine when a friend got a new one & cleaned it well, brushes turn easily etc.. Plu...
I was given the machine when a friend got a new one & cleaned it well, brushes turn easily etc.. Plu...
(Posted by Dawnagin 10 years ago)
Hoover Floormate Fh40010 Making Noise.
My Hoover Floormate FH40010 is making a loud grinding noise. What could that be? Is it something I c...
My Hoover Floormate FH40010 is making a loud grinding noise. What could that be? Is it something I c...
(Posted by Traceywolkin 10 years ago)
Which Is The Newest Model? Model Fh40010 Or Model Fh40010b
which is the newest model? model FH40010 or model FH40010B
which is the newest model? model FH40010 or model FH40010B
(Posted by cxwillia87 11 years ago)
Max Extract 77 Leaks From The Clean Water Tank, Straight To The Floor
(Posted by muffe444 11 years ago)