Hoover F7458-900 Support Question
Hoover F7458-900 Support Question
Find answers below for this question about Hoover F7458-900 - Widepath All Terrain Floor Cleaner.Need a Hoover F7458-900 manual? We have 1 online manual for this item!
Question posted by dmb55911 on November 14th, 2015
The Brushes Wont Spin.
our carpet cleaner the brushes wont spin. I cleaned the brushes and screen and checked that the brushes do turn ok when I took it off. I did notice that the square hole that the brushes goes into does not move.
Current Answers
Answer #1: Posted by waelsaidani1 on November 14th, 2015 6:13 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,807
Member since:
May 12th, 2013 Points: 19,501,807
Inspect the belt to see if it is broken, stretched out, or out of place. If the drive belt is broken or stretched out, replace it.
If the brushroll is sticking, it will cause too much friction and put too much strain on the belt. Remove the brushroll and clean all hair, string, and lint from the brushroll bearings. If the vacuum cleaner brush still doesn't spin after you clean the brushroll, consider replacing the brushroll.
Related Hoover F7458-900 Manual Pages
Product Manual - Page 1
Questions or concerns? All rights reserved. #56518217 ID100262-R2
IF USED COMMERCIALLY WARRANTY IS VOID.
©2011 Techtronic Floor Care Technology Limited. For assistance, please call Customer Service at 1-800-944-9200 Mon-Fri 8am-7pm EST.
THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ...
Product Manual - Page 2
...to Clean...10 Tools...13 Maintenance...17 Nozzle...17 Brushes...17 Valve...18 Storage...18 Lubrication...18 Troubleshooting...19 Helpful Reminders 19 Service...20 Cleaning Products......
Manufacturing code
(Label located on bottom of cleaner)
Contents
Important Safeguards 3 Cleaner Assembly...5 How To Use...7
Cleaner Description 7 The Tanks...8 How to the store.
2 Be sure...
Product Manual - Page 3
... around sharp edges or corners. Do not allow carpet cleaner to run appliance over floor electrical outlets. • Do not use in place. • Use extra care when cleaning on stairs.
Do not place carpet cleaner on stairs. • Use carpet cleaner only for use with this Appliance. (See Cleaning Products section of an extension cord is well ventilated...
Product Manual - Page 4
...FLOOR. If it should be used only until they are completely dry. • Store in a dry place. The plug must be used , it will not fit the outlet, have a proper outlet installed by a metal screw. Do not modify the plug provided with the carpet cleaner...temporary adapter is properly grounded. keep free
of electric shock. Check with a cord having an equipment-grounding conductor (C) and ...
Product Manual - Page 5
SpinScrub® Brush Assembly
Remove all parts are located before disposing of ... Hose H Stair/Upholstery Nozzle I
B
E
A
A. NOTE: Phillips screwdriver needed for assembly. Cleaner B. Hose/Cord Hook E. 1. Cleaner ASSEMBLY
Carton contents
1.1
Carpet Upholstery
Cleaner
Bare floor cleaner
PreCleaner
G
C
H
D
F
I . Upper Handle C.
Accessories not included with your model ...
Product Manual - Page 6
... tool caddy
(for storage on wall or in closet.
1.10
Store hose
1.12 Start.
1.13 Wrap.
1.14 Finish. Check tank to make sure it to latch it is removable for storage on cleaner) (Available on hook (C). Use clips (D) to secure hose and solution tube (E and inset).
1.12
1.13
1.14
D
E
E
D
Actual model may...
Product Manual - Page 7
...
11
15. Wheels
DO NOT USE THIS EXTRACTOR ON HARD FLOORS
*Accessories not included with your cleaner from images shown. ON-OFF switch
To turn cleaner OFF, push switch up.
2.2
Rinse ON
OFF
WASH AUTO RINSE
Handle release pedal
Step on both sides of cleaner.
20. Clean Water Tank Handle
8. Cord Hook: rotates for household use...
Product Manual - Page 8
... water above 140°F (60°C).
2.9 - 2.10 Fill detergent container (F) with hot tap water.
!
brushes at maximum speed for use with your SteamVac® cleaner.
brushes OFF for cleaning the
carpet or floor, or used to Fill
Unplug cleaner from images shown. 8 Non-Hoover® cleaning solutions may vary from electrical outlet.
POWER SCRUB - How to rinse the...
Product Manual - Page 9
...purpose.
*OxiClean is a registered
B
A
trademark of tank).
To prevent possible leaking, remove clean water tank by arrows) on the base when the tank is a trademark of contact with eyes... unit. Check tank to make sure it is securely latched.
2.13 There may be emptied (see Automatic Shut-Off section). Detergents contain Anionic and Nonionic Surfactants. G
How to Empty
Turn cleaner off and...
Product Manual - Page 10
...noticeably higher in place. Follow Directions on bottle. g.
When this happens, turn cleaner off and empty Dirty Water Tank before cleaning.
*Available at additional cost if not included with your upholstery does not have a code, seek professional assistance. When cleaning entire floor, move furniture out of the Dirty Water Tank
lid (B). Vacuum thoroughly - For upholstery, check cleaning...
Product Manual - Page 11
..., set Rinse Setting switch to RINSE. Dry hands and plug cord into a properly grounded outlet.
Do not clean over one area. Keep nozzle flat on floor for both forward and reverse strokes. The cleaner rinses the carpet on page 13. It is visible passing through the Dirty Water Tank lid.)
Empty Dirty Water Tank...
Product Manual - Page 12
... the spill remains, place either the stair/ upholstery nozzle or floor nozzle with the SpinScrub® mode selector to pick up small liquid spills on carpet or uholstery. If furniture must be rotating slowly, disconnect cleaner from electical outlet and check and clean this screen.
3.4
3.5
Actual model may also be treated by following the instructions provided...
Product Manual - Page 13
... on small carpet areas, carpeted
A
stairs and upholstery. Push hose into port and lock in connection port. Remove solution tube from port. Remove hose from solution connection port. SpinScrub® Hand Tool (Available on select models only) has rotating brushes for removal. For some spots may vary from moving parts, unplug cleaner.
4.1
A
How to...
Product Manual - Page 14
CAUTION !
Disconnect hose and solution tube from cleaner.
4.7 Drain solution tube by turning cleaner ON and holding nozzle up on the cleaner.
4.7
4.8
Actual model may vary from rack. Using your head.
Do not press trigger.
!
After Using Tool
Drain suction hose by placing round end in sink ...
Product Manual - Page 15
... 12 and "After Using Tool" instructions on stairs. Agitator brushes will not rotate while handle is a loss in upright position. Attach tool to end of stairs to help prevent streaking.
Do not place cleaner on page 10. Turn cleaner ON.
4.9 Pre-spray the carpeted stair by 1/2 inch to clean lower half.
! Pull tool slowly over the...
Product Manual - Page 16
...crisscrossing strokes to check the cleaning code on your cleaner only on ...Clean Water Tank according to instructions for Fig. 2.10.
Turn cleaner ON.
4.11 Gently press the tool onto the fabric. If additional cleaning is necessary, wait until the upholstery is not available during tool use hard floor cleaning solution when cleaning upholstery. When finished cleaning, follow "After Cleaning...
Product Manual - Page 17
...5.4 Align posts (A) on properly. With handle in order for easy cleaning.
! brushes: How to secure it can be in the proper position in upright position, tilt cleaner back so that the square post (C) also aligns with the square hole (D).
B A
Slide nozzle completely onto cleaner. The nozzle must be cleaned under running water.
5.4
A
B
D
B
A
How to Remove
To prevent possible...
Product Manual - Page 18
... (A) counter clockwise and remove. valve:
How to motor bearings.
Replace on a carpeted or wood surface.
Lubrication
The motor is equipped with clean water and let air dry. The addition of the motor. Turn cap clockwise to air dry thoroughly before storing carpet cleaner on cleaner. • Empty Dirty Water Tank, rinse tank and lid
thoroughly with...
Product Manual - Page 19
...-off engaged.
2.
Clean filter screen. 2. Clean screen. Unplug the cleaner before doing any detergent in position.
2. others may vary from images shown.
Make sure lid is securely locked in water tank. Clean Water Tank or detergent container empty.
3. CAUTION ! PROBLEM
POSSIBLE CAUSE
Cleaner won 't rotate during floor cleaning.
1. Remove and clean valve cap...
Product Manual - Page 21
...Hoover® MaxExtractTM Dual V® All Terrain
Hoover
Platinum
Collection®
Hoover® FloorMate®
1 Allergens: pollen, pet dander, dirt, and dust.
2 When cleaning a hard surface, the Hoover® hard surface attachment below must be used : 6 Brush Hoover® part # 36419008 5 Brush Hoover® part # 48417007.
For...
Similar Questions
I Need A Beater Bar End Cap For Hoover Floor Cleaner Model Fh51000
I need a beater bar end cap for Hoover floor cleaner model fh51000
I need a beater bar end cap for Hoover floor cleaner model fh51000
(Posted by scottgrippa 1 year ago)
Hoover Steam Vac All Terrain Wont Spin
(Posted by wintbg3 9 years ago)
Max Extract Dual V Brushes Wont Spin
(Posted by leosu 10 years ago)
Bissell Maxextract All Terrain Carpet Washer Brushes Wont Turn
(Posted by sambocmel 10 years ago)
Hoover Steam Vac #6207-900-how Do I Change The Belt To The Brushes
how to change the belt that drives the brushes on hoover steam vac #6207-900
how to change the belt that drives the brushes on hoover steam vac #6207-900
(Posted by matflip93 12 years ago)