Honeywell RTH2310B Support Question
Honeywell RTH2310B Support Question
Find answers below for this question about Honeywell RTH2310B.Need a Honeywell RTH2310B manual? We have 1 online manual for this item!
Question posted by baker35932 on September 8th, 2012
Can I See An Rth2310b Manual With A Windows Machne??/ I Have A Mac
how do i look at an rth2310b manual with a mac?
Current Answers
Related Honeywell RTH2310B Manual Pages
Owner's Manual - Page 1
Quick Installation Guide
RTH2310
Programmable Thermostat 69-2214EF-04
Owner's Manual - Page 2
... easy installation. Do you need assistance?
Just follow the simple step-by-step instructions in the following pages.
1) Identify your system type. 2) Remove your old thermostat. 3) Identify the wires. 4) Mount the new wallplate. 5) Connect the wires. 6) If the wire labels don't match. 7) Specify the furnace type. 8) Install the batteries. 9) Install the...
Owner's Manual - Page 3
...
If you are not sure of your system type or if you have any other questions, call us toll-free at 1-800-468-1502. This thermostat is compatible with the following systems:
• Gas, oil or electric furnace • Central air conditioner • a hot water system with heat pumps or multi...
Owner's Manual - Page 4
... local waste management authority for instructions regarding recycling and proper disposal.
3
Do not remove wallplate yet. Quick Installation Guide
2 Remove Old Thermostat
2.
1) Turn power off at the heating/cooling system.
2) Remove old thermostat, but leave wallplate with wires attached.
Contact your old thermostat in the trash if it contains mercury in a sealed tube.
Owner's Manual - Page 5
RTH2310 Programmable Thermostat
3 Identify Wires
3. Wrap the bare metal end of each wire.
Wrap the wires around a pencil to ... wallplate only after all wires are attached to a terminal marked C or C1, they will not be connected to your new thermostat.
IGNORE WIRE COLORS: Use terminal screw designations to prevent them from falling though the wall opening.
4
If any wires are...
Owner's Manual - Page 6
Quick Installation Guide
4 Mount New Wallplate
4.
1) Remove coverplate.
2) Loosen screw (the screw remains captive on wallplate).
3) Remove thermostat.
4) Mark and drill appropriate mounting holes (or use existing holes). Pass wires through opening of wallplate and secure wallplate to the wall using provided screws.
5 Insert plastic anchors.
Owner's Manual - Page 7
... with the terminal having the same letter.
2) Loosen the terminal screws using a screwdriver, insert the wires, then tighten the screws.
3) Push any terminal on the thermostat, see next page.
6 Labels don't match? RTH2310 Programmable...
Owner's Manual - Page 9
HE Place the jumper to the G terminal. J2 jumper
HG Leave the jumper in this position if you have an electric furnace.
8
RTH2310 Programmable Thermostat
7 Specify Furnace Type
6. Set the Jumper J2, on the back of the thermostat, if you have connected a wire to this factory-set position if you have a gas or oil furnace.
Owner's Manual - Page 10
Afterwards, the screen displays the actual temperature. The thermostat will hear a clicking
sound. By default, the setpoint is installed on the ...shown. It is normal that the displayed temperature be higher than the ambient temperature if you are installed, the thermostat performs a series of tests for approximately 5 seconds. Observe the
polarity. 3) Reinstall the battery cover. You ...
Owner's Manual - Page 11
RTH2310 Programmable Thermostat
9 Install thermostat
8.
1) Mount the thermostat on the wallplate.
2) Tighten the screw and install the coverplate.
3) Turn power back on at the heating/cooling system.
10
Owner's Manual - Page 12
Rev. 03-11 Printed in bold and underlined.
2 See page 3 of Operating Manual.
3 Use the system switch to switch between the two parameters.
4 For optimal heating control, use the setting that matches your system as follows: 2=30 min (...
Owner's Manual - Page 13
Guide d'installation rapide
RTH2310
Thermostat programmable 69-2214EF-04
Similar Questions
How To Use On A Honeywell Rth2310b Thermostat Manually
(Posted by fsasMariem 9 years ago)
How To Hold Temp Thermostat Rth2310b Manual
(Posted by demdigio 9 years ago)
How To Change Honeywell Thermostat Rth2310b Manual From C To F
(Posted by admgraf 10 years ago)
The Window Of My Thermostat Does Not Show Info. The # On The Back Is T8601d2019
(Posted by behrendsshetek 11 years ago)