Honeywell CT31 Support Question
Honeywell CT31 Support Question
Find answers below for this question about Honeywell CT31.Need a Honeywell CT31 manual? We have 1 online manual for this item!
Question posted by avabec on August 1st, 2014
How To Install A Honeywell Manual Thermostat Ct31a
The person who posted this question about this Honeywell product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Honeywell CT31 Manual Pages
Owner's Manual - Page 1
Registered Trademark. Copyright © 2005 Honeywell International Inc. All rights reserved. Patents pending.
Owner's Manual
CT31
Low-voltage Thermostat
Getting started
Check to make sure your package includes the following items:
CT31 thermostat
Cover plate
Wire labels
Caution card
Wall anchors and mounting screws (2 each)
Before you begin, make sure you have:
• Screwdriver...
Owner's Manual - Page 2
...waste management authority for advice. Stop installation and call 1-800-468-1502 for instructions regarding recycling and proper disposal. Do you purchase right thermostat?
Count wires to the next page... Old thermostat
Cover
MERCURY NOTICE: Do not place your old thermostat.
If the total (not counting C or C1) is 4 wires or less, proceed to check. Owner's Manual
Remove ...
Owner's Manual - Page 3
... mounting position
1 Pull wires through base (and cover plate if desired).
2 Level base or cover plate if desired.
3 Mark positions of both screw holes.
3
CT31 Low-voltage Thermostat
Label wires and remove old wallplate
Use a screwdriver to let loose wires fall into the wall opening !
IGNORE WIRE COLORS: Use only letter designations...
Owner's Manual - Page 4
... if desired, then tighten screws.
If labels do not match letters on terminal.
2 Use a screwdriver to : Terminal "R" Terminal "W" Terminal "Y" Terminal "G" Stop!
Labels don't match? Owner's Manual
Mount thermostat base
1 Drill holes at pencil-marked locations (3/16" holes for drywall, 7/32" holes for plaster).
2 Use hammer to tap anchors into the wall opening.
Owner's Manual - Page 5
...Hot water system
0.8
Gas/oil steam or gravity system
1.2
Finish installation
Base (shown with optional cover plate)
Thermostat
Cover
5
1 Mount thermostat on base and tighten three mounting screws.
2 Align the 3 tabs... system, or at the fuse/ circuit-breaker panel.
CT31 Low-voltage Thermostat
Set adjustment lever
1 Separate cover from thermostat, and remove the plastic insert.
2 Use a pencil...
Owner's Manual - Page 6
... only the cooling system.
• Heat: Thermostat controls only the heating system.
• Off: Heating and cooling systems are off. Fan switch
• On: Fan runs ... CAUTION: EQUIPMENT DAMAGE HAZARD. To prevent possible compressor damage, do not operate cooling system when outdoor temperature is on. Owner's Manual
Operation
Temperature setting Move lever to adjust desired indoor temperature.
Owner's Manual - Page 7
... rights which vary from state to state. If at any questions concerning this warranty, please write Honeywell Customer Relations, 1985 Douglas Dr, Golden Valley, MN 55422 or call Honeywell Customer Care at Honeywell's option). CT31 Low-voltage Thermostat
Limited Warranty
Honeywell warrants this product to be free from defects in the possession of a consumer.
Customer Care...
Owner's Manual - Page 8
...10% post-consumer paper fibers.
® U.S. Registered Trademark. © 2005 Honeywell International Inc. on recycled paper containing at 1-800-468-1502
Automation and Control Solutions
Honeywell International Inc. All rights reserved. 69-1809EF Rev. 03-2005 Need Help? Patents pending.
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North
35 Dynamic Drive
Golden Valley...
Similar Questions
Ct30 Manual Thermostat
Installed new ct30 manual thermostat it was working now won't turn furnace on
Installed new ct30 manual thermostat it was working now won't turn furnace on
(Posted by nancyayanicki 1 year ago)
We Are Trying To Find 0.3 On Themostar For Electric Furnace. The Thermostat Is
ct31 a where is 0.3 for electric furnac
ct31 a where is 0.3 for electric furnac
(Posted by winnieraines 3 years ago)
New Ct31 Installed. Won't Start Or Stop Furnace Automatically.
Thermostat is set to heat. Heat selector set to 18. House temp 16 or lower. Furnace does not start u...
Thermostat is set to heat. Heat selector set to 18. House temp 16 or lower. Furnace does not start u...
(Posted by Hornby819 5 years ago)
Installing The Thermostat
i'm installing the Thermostat and for the RH terminal I have 3 wires and they are C L O witch one do...
i'm installing the Thermostat and for the RH terminal I have 3 wires and they are C L O witch one do...
(Posted by marthasbng40 12 years ago)
How Do I Adjust My New Ct31a1003 Honeywell Thermostat
What do I do with the 2 sideways screws inside the cover of my thermostat?
What do I do with the 2 sideways screws inside the cover of my thermostat?
(Posted by svhadley58 12 years ago)