Hayward Aqua Solar GL-235 Support Question
Hayward Aqua Solar GL-235 Support Question
Find answers below for this question about Hayward Aqua Solar GL-235.Need a Hayward Aqua Solar GL-235 manual? We have 1 online manual for this item!
Question posted by BRWiese1 on August 24th, 2015
Thermostat Not Working
What can cause the thermostat to not work?
Current Answers
Answer #1: Posted by techyagent on August 25th, 2015 6:36 AM
techyagent
Member since:
June 17th, 2014 Points: 4,799,790
Member since:
June 17th, 2014 Points: 4,799,790
Related Hayward Aqua Solar GL-235 Manual Pages
Model: GL-235 - Page 1
...the product and also coded on the outside the USA and Canada. Hayward warrants its solar products and IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING A ...behalf of Hayward Pool Products with Hayward. Elizabeth, NJ 07207
092007G RevH Copyright © 2010 Hayward Inc. Aqua Solar
GL-235
Electronic Solar Control
Operation and Installation Manual
GL-235
www.haywardnet.com
Model: GL-235 - Page 2
...older systems with sensor disconnected from the control the sensor will cause permanent damage to be a minimum of pools, spas, and hot tubs. WARNING: Applying 240VAC to the chart...pool and pool hotter than limit, off at back of the sensor using an ohmmeter.
Description
The GL-235 is a differential temperature control for solar heating of 5 feet (horizontally) from the pool or spa...
Model: GL-235 - Page 3
... there is supposed to the pool/spa actuators. If the voltage is an internal short and the unit must be replaced. Remove the sensor from the weather. The GL-235 is very important if recirculate ...use and ensure that the actual pool temperature, and the solar sensor is close to blink. For long runs or runs near the solar collector array. The GL-235 turns on, the valve output will...
Model: GL-235 - Page 4
... wired in the diverter of a positive seal valve to allow circulation of relatively warm water from the pool to measure the Solar Sensor)
Figure 5
9 Alternatively, the GL235 control can be enabled/disabled via a jumper on a GL-235, either : • The filter pump must be set for extended periods. Freeze Protection If you use of...
Model: GL-235 - Page 5
... is dissipating excess heat.
If the valve(s) positions are working in reverse, follow the instructions in section marked "Low Voltage (LV) : Solar Valve" to within 1.5ºF OR the pool/spa sensor is above the "Desired Temperature" setting. The GL-235 will stop heating (return valve to pool loop) when the two sensor temperatures get to correct.
The...
Model: GL-235 - Page 6
Basic Installation of GL-235 Figure 2 6
GL-235 high voltage output used for Timer Override Figure 3 7
Similar Questions
Solar Sensors Changed My Sensors Now All My Lights Stay On On Manuel An Auto
(Posted by donapplegate728 6 months ago)
Cover Blew Away During Hurricane
can a replacement cover be purchased anywhere for the gl 235
can a replacement cover be purchased anywhere for the gl 235
(Posted by rwkristoff 1 year ago)
Aquastar Ii Gl-235-x244. Valve Malfunction
Valve stays in Closed solar position. Even if placing valve manually in solar heating position, valv...
Valve stays in Closed solar position. Even if placing valve manually in solar heating position, valv...
(Posted by k7vk 1 year ago)
How Can I Get A Good Manual Or Wiring Diagram For An Aqua Solar Gl Dash 235 Unit
(Posted by Toiful 2 years ago)
Goldline Aqua Solar Tc Will Not Start Pool Pump In Auto Setting
Goldline Aqua Solar TC will not start pool pump in auto setting but works in manual
Goldline Aqua Solar TC will not start pool pump in auto setting but works in manual
(Posted by csrranch 8 years ago)