Hayward Aqua Solar GL-235 Support Question
Hayward Aqua Solar GL-235 Support Question
Find answers below for this question about Hayward Aqua Solar GL-235.Need a Hayward Aqua Solar GL-235 manual? We have 1 online manual for this item!
Question posted by trump421 on September 26th, 2012
The Old Style Actuators Did Not Have Plugs They Have To Be Wired In Separately
how do you wire in the old style actuator
Current Answers
Related Hayward Aqua Solar GL-235 Manual Pages
Model: GL-235 - Page 1
...been altered in any of the cost incurred in removal or reinstallation of Hayward Pool Products with Hayward. Years 1-3: Years 4-5
Charges
no faults or problems are not...For more than the warranty period are detected. Aqua Solar
GL-235
Electronic Solar Control
Operation and Installation Manual
GL-235
www.haywardnet.com Hayward warrants its solar products and IS IN LIEU OF ALL OTHER ...
Model: GL-235 - Page 2
...actuator...wiring. Grounding Refer to the input wiring diagram (Figure 1) on next page. In general, a separate ground conductor must be used. To use the GL-235 with older 12VAC valves, move jumper J4, located on the pool...less than pool or pool cooler than limit, off at back of pools, spas, and...than pool and pool hotter than high limit. Low Voltage (LV) output: Solar Valve The GL-235 ...
Model: GL-235 - Page 3
... failure and the GL-235 will have to be replaced. Remove the sensor from the unit, measure the resistance of the pool sensor as the valve actuator wires or any 120/240V circuit. For older actuators with the pool sensor. If the valve operates opposite to the way it to the normal low voltage solar valve. If the...
Model: GL-235 - Page 4
...; The GL235 High Voltage Output must be wired for Timer Override function.
4
Measuring Voltage of Pool Sensor (Use the same method to measure the Solar Sensor)
Figure 5
9 Placement of the snap switches at the collector sensor, it is cooler than the high limit setting. The GL-235 will circulate water when the collector temperature AND...
Model: GL-235 - Page 5
..." LED indicator will blink for Booster Pump Figure 4
8
5 The GL-235 will stop heating (return valve to pool loop) when the two sensor temperatures get to solar loop) when the collector (solar) sensor temperature is higher than the pool/spa sensor temperature by 4ºF or more AND the pool/spa temperature is being used for approximately 10 seconds while...
Model: GL-235 - Page 6
Basic Installation of GL-235 Figure 2 6
GL-235 high voltage output used for Timer Override Figure 3 7
Similar Questions
Solar Sensors Changed My Sensors Now All My Lights Stay On On Manuel An Auto
(Posted by donapplegate728 6 months ago)
Cover Blew Away During Hurricane
can a replacement cover be purchased anywhere for the gl 235
can a replacement cover be purchased anywhere for the gl 235
(Posted by rwkristoff 1 year ago)
How Can I Get A Good Manual Or Wiring Diagram For An Aqua Solar Gl Dash 235 Unit
(Posted by Toiful 2 years ago)
My Aquastar Gl235-x244 Is Current Overheating The Pool.
Temp is set at 80 and water temperature is high 90's. Suggestions on how and what to replace
Temp is set at 80 and water temperature is high 90's. Suggestions on how and what to replace
(Posted by roben8307 5 years ago)
Goldline Aqua Solar Tc Will Not Start Pool Pump In Auto Setting
Goldline Aqua Solar TC will not start pool pump in auto setting but works in manual
Goldline Aqua Solar TC will not start pool pump in auto setting but works in manual
(Posted by csrranch 8 years ago)