Graco 1757845 Support Question
Graco 1757845 Support Question
Find answers below for this question about Graco 1757845 - Comfort Sport - Marissa.Need a Graco 1757845 manual? We have 1 online manual for this item!
Question posted by tmeronek on October 18th, 2012
Recalls
is there any ecalls on graco carseat m 1757845
Current Answers
Related Graco 1757845 Manual Pages
Instruction Manual - Page 2
...is for:
• ComfortSport 5-Point Newborn/Toddler Child Restraint • ComfortSport Overhead Shield Newborn/Toddler
Child Restraint
Operations and Adjustments 18
•...is LATCH 5 LATCH System 6
c Use
Height & Weight Limits 7 Rear-facing Installation With LATCH 8
Vehicle Seat Belts 26 • Locking Clip 31
Additional Information 32
• Tether Storage • Cup Holder •...
Instruction Manual - Page 3
...c LATCH
This child restraint may be recalled for vehicles equipped with LATCH).
1 c Registration Information
Child restraints could be installed in a vehicle using either the vehicle seat belt or the LATCH system (for safety...8226; TTY: (1-800-424-9153), or http://www.NHTSA.gov
• Call Graco Children's Products Inc.
Fill out the registration card attached to child restraint and mail...
Instruction Manual - Page 4
... 20 lbs. (9 kg) must use for child restraint installation information.
2
If vehicle seat belt does not hold child restraint securely. Never put a child restraint in this child restraint rear-facing....should be used with air bags, refer to age 12 are safer in the back seat. Choose the correct mode of age before being positioned forward facing. The American Academy of vehicle. ...
Instruction Manual - Page 5
...result in injury or ejection.
• Too upright can cause unseen damage and using vehicle seat belt to secure child restraint, LATCH connectors must be stored. (see section "LATCH storage") ...Never attach two LATCH connectors to one vehicle lower anchor point unless specifically allowed by Graco. If using it again! Never leave child unattended, even when sleeping. DO NOT use ...
Instruction Manual - Page 6
...place this car seat after the date molded into the back of Federal Motor Vehicle Safety Standard 213 for use child restraint on rear-facing or side-facing vehicle seats. c ... passengers.
If an air bag inflates, it away after December Year
c Vehicle Seat Protection
Protect vehicle seat.
Look for information about side air bags and child restraint installation. Check vehicle owner...
Instruction Manual - Page 7
... and Tether for use the term ISOFIX to identify the new child restraint anchorage system.
a) or a colored dot. They may be visible at the vehicle seat crease.
If not visible, they may be used in vehicles. The system is equipped with ISOFIX. This child restraint with LATCH can also be identified...
Instruction Manual - Page 8
As a manufacturer, we do not recommend using the LATCH system in a seating Top Tether
position recommended
Anchor
by vehicle manufacturer. Vehicle Lower Anchor Points
(Fig. a) 6
Child Restraint Lower Anchorage
Belt
Point
Child Restraint Top Tether
LATCH is ...
Instruction Manual - Page 9
... restraint is certified for use car seat forward-facing only if child is over 20 lbs.
* (9 kg) and can sit upright unassisted. However, some children approaching 30 lbs. (13.6 kg) may be at special risk in a child restraint. If unable to sit unassisted, use rear-facing.
• Toddlers 30 to 40 lbs. (13...
Instruction Manual - Page 10
...rear-facing. k). a and pages 18 and 19, fig. b) Place rear-facing on vehicle seat equipped with LATCH anchors.
3 For ease of child restraint
while pulling LATCH adjustment belt. (fig....restraint for
secure installation (fig. If necessary, place rolled towels under child restraint, at vehicle seat crease, until entire ball is securely installed and properly leveled; Then re-check level indicator....
Instruction Manual - Page 12
...to vehicle lower anchors
(fig. a
and pages 18 and 19, fig. f). Place forward-facing on vehicle seat equipped with LATCH anchors.
3 For ease of installation, extend LATCH belt
to its maximum length.
4 Hook ...LATCH
1 LATCH belt must be twisted.
2 Adjust car seat to upright position (see fig.
Secure recline stand into Upright Position by pulling adjustment belt (fig. b).
Instruction Manual - Page 14
... installed and properly leveled; REAR-FACING INSTALLATION WITH VEHICLE SEAT BELTS
WARNING
LATCH belt MUST be stored when using vehicle seat belt to install child restraint.
1 Store LATCH belt by pulling adjustment belt.
2 Adjust car seat to recline position
(see fig. b). d). If not secure, see "Vehicle Seat Belts" page 26.
6 Check level indicator on each...
Instruction Manual - Page 15
c)
13 e)
Installation with Lap/shoulder belt
LAPC0110A
(fig. b)
(fig. a)
Recline position (fig. d)
(fig. REAR-FACING INSTALLATION WITH VEHICLE SEAT BELTS
(continued):
Storage Bar
Openings
Tether LATCH (stored)
Towels
Recline Position
Installation with Lap belt only
(fig.
Instruction Manual - Page 16
... should be twisted. If vehicle does not have anchor points to remove excess slack by pushing tabs into Upright Position by pulling adjustment belt.
2 Adjust car seat to check for
secure installation (fig. Periodically check that child restraint is securely installed;
Belt must lay flat and not be stored, see "Tether Storage...
Instruction Manual - Page 17
c)
(fig. a) Lock Position
Storage Bar
LATCH (stored) Upright Position Installation with Lap/shoulder belt
Installation with Lap belt only
Pull to tighten
(A)
(B) (fig. d)
(fig. b)
(fig. e)
15 FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS
(continued):
Tether
Openings
(fig. f)
Upright Position
(fig.
Instruction Manual - Page 22
... Splitter Plate first, then attach Top left strap loop. D Re-attach harness strap loops to remove seat pad from Splitter Plate on Splitter Plate first, then attach left strap loop. e):
• For Infants or Small Toddlers:
Put Top right strap loop on Splitter Plate first, then attach Bottom left strap loop. Overhead...
Instruction Manual - Page 24
... (continued)
8 LATCH Belt Routing:
LATCH belt MUST be flat and tight
(fig. A Remove pad from front of seat area by snapping the three 2-button clips back in center of seat. i)
Rotating LATCH Belt (under seat pad)
B Rotate LATCH belt so that the belt routes through the proper openings depending on lower front edge...
Instruction Manual - Page 25
... LATCH belt through Rear-facing openings for:
• LATCH Rear-facing use . r. or
• LATCH storage with Forward-facing vehicle seat belt use . All belts must be flat and the adjuster belt must be facing out for :
• LATCH Forward-facing use ....)
Route LATCH belt through Forward-facing openings for easy adjustment. or
• LATCH storage with Rear-facing vehicle seat belt use .
Instruction Manual - Page 26
... in, lift connector up and pull out (away from Vehicle Anchor Points:
A Tilt metal tab of adjuster to reduce tension on child restraint compressing vehicle seat cushion to release tension (fig. o). OPERATIONS and ADJUSTMENTS (continued)
9
Removing LATCH from anchor point) (fig.
Instruction Manual - Page 29
... see vehicle dealer for car seat installation requirements.
• If approved for secure installation by pulling child restraint front to back. If child restraint slides forward, DO NOT use with child restraint, install child restraint and check for use these seat belts.
VEHICLE SEAT BELTS (continued)
c Belts Forward of Seat Crease
Vehicle seat belts located forward...
Instruction Manual - Page 37
... same slot with the harness.
Head Support may be machine washed separately in center of car seat with top and middle harness slots only! Use head support in slot ABOVE harness, NOT...For use strap covers,
blankets, cushions, or padding under harness straps or child unless provided by Graco. ADDITIONAL INFORMATION (continued)
c Head Support (available on shoulders and adjusted snugly.
• Do...
Similar Questions
How To Assemble Buckle To Straps
how do you assemble the straps to the safety buckle in the infant sea
how do you assemble the straps to the safety buckle in the infant sea
(Posted by Debdifferding 6 years ago)
Where Can I Get A Base For A Graco Car Seat Model # Is 7b10mlw3
Where can I get a base for a graco car seat model # is 7B10MLW3. Also can you tell me if theany reca...
Where can I get a base for a graco car seat model # is 7B10MLW3. Also can you tell me if theany reca...
(Posted by Courtneyuhrig 11 years ago)
Car Seat Compatibility
Does the Graco 8402L04 base work with the Snug Ride 30 model car seat?
Does the Graco 8402L04 base work with the Snug Ride 30 model car seat?
(Posted by thecrymes 11 years ago)
I Would Like To Order A Car Seat Base, Lapc0214b
I would like to order an extra car seat base, LAPC0214B....how can I do that? I see other car seat...
I would like to order an extra car seat base, LAPC0214B....how can I do that? I see other car seat...
(Posted by cindy59156 11 years ago)
Find Stroller To Matching Car Seat.
I have this car seat Graco 8F09TAN3 and i cannot find the stroller to it can you please help me out...
I have this car seat Graco 8F09TAN3 and i cannot find the stroller to it can you please help me out...
(Posted by dj1515 12 years ago)