GE GFDN120EDWW Support Question
GE GFDN120EDWW Support Question
Find answers below for this question about GE GFDN120EDWW.Need a GE GFDN120EDWW manual? We have 1 online manual for this item!
Question posted by fixer1750 on May 21st, 2017
Side Venting
how do I access 4 inch internal vent pipe in order to change from back venting to side venting
Current Answers
Related GE GFDN120EDWW Manual Pages
Owners Manual - Page 1
... 10 Reversing the Door Swing . . . . 11-14 Loading and Using the Dryer 15-16 Venting the Dryer 17 Connecting Inlet Hoses 18 Stacking 19-22
Troubleshooting Tips . . . . 23-26
Consumer Support
Warranty 28, 29 Consumer Support 30
Owner's Manual
GFDN110 GFDN120 GFDN130 ...
Owners Manual - Page 2
...Installation and service must be minimized further by the incomplete combustion of potential exposure to the outdoors.
2 Properly adjusted dryers will minimize incomplete combustion.
For your gas supplier from a neighbor's phone. READ ALL INSTRUCTIONS BEFORE USING.
Follow ..., carbon monoxide, formaldehyde and soot, caused primarily by properly venting the dryer to such substances.
Owners Manual - Page 3
...GEAppliances.com, or by calling 800.GE.CARES (800.432.2737).
„ Properly ground dryer to
prevent large amounts of moisture and lint from both the control panel and the door.....
Do not stack or place laundry or throw rugs against the front or back of ventilating air.
IMPORTANT SAFETY INFORMATION. GEAppliances.com
PROPER INSTALLATION
This dryer must be exposed to temperatures below...
Owners Manual - Page 4
... may melt or burn. Before loading, unloading or adding clothes, wait until solvents or flammable materials have been cleaned in, washed in, soaked in your dryer.
YOUR LAUNDRY AREA
„ Keep the area underneath and around your appliances free of combustible materials (lint, paper, rags, etc.), gasoline, chemicals and other flammable vapors...
Owners Manual - Page 5
... performance problems caused by a qualified technician.
SAVE THESE INSTRUCTIONS
5
WHEN NOT USING YOUR DRYER
„ Grasp the plug firmly when disconnecting this appliance.
„ Never attempt to ... wash cycle, according to the manufacturer's instructions for those products, or try a dryer-added product for which the manufacturer gives written assurance on the package that you use...
Owners Manual - Page 6
... vary from your model number at the top inside of the door opening. Model GFDN110/120/130
2
4
1
3
Model GFDS140/145/150/155
2
8
5
4
6 1
6
37
8
5
6 About the dryer control panel.
Owners Manual - Page 7
If the display is active, press to put the dryer in the cycle to achieve optimum results. For large coats, bed spreads, mattress covers, sleeping bags and similar large and bulky items.... damp, such as blankets, comforters, jackets and small rugs. GEAppliances.com
1 Power
Press to Time Dry. 2.
Time Dry is not opened, the dryer will help you match the dry setting with the loads.
Owners Manual - Page 8
... Tumble Dry Low. Change DRY "Temp", and SENSOR DRY "Level" settings to start a dry cycle. Even though you want. 4. A beep will sound and the pad light will disappear after every drying cycle is complete.) This message will
light up your selected dry level, the dryer will pause the dryer. To change the temperature of...
Owners Manual - Page 9
...restart unless the door is
in 1 hour increments using the Delay Dry button.
3.
Choose your dryer.
1. Press Delay Dry. You can be removed when the beeper goes off .
9 e-DRY... removed. The beeper will change when e-DRY is complete.
The clothes should be used with Delicates, Easy Care, Normal Mixed Loads and Cottons.
NOTE: Not all dryer models. GEAppliances.com
Extended ...
Owners Manual - Page 10
You can lock the controls to indicate the cycle has been saved.
This means the dryer is opened. To change the saved cycle, set the desired settings and hold the lock icon for 3 seconds. Children cannot accidentally start the dryer by removing the fuse or switching off the circuit breaker.
The lights will see...
Owners Manual - Page 11
Unplug the dryer from the right side to the left side³if you begin, do not move the cabinet until door-swing reversal is 30-60 minutes. Beauty Buttons
4 - # 8 Screws (strike plate)
4 - # 8 Machine Screws (inner door & hinge)
STEP-BY-STEP INSTRUCTIONS
Before You Start
1.
These instructions are for changing the hinges from...
Owners Manual - Page 14
...to be used as shown.
12. Partially fasten a screw to be installed and install them on the dryer. Tapping Screws
Partially Inserted Screw Tighten All Screws
14
14. Outer Door Inner Door
STEP-BY-STEP ...sure there is no dirt or any other flat tool, remove the 5 beauty buttons located on the dryer where the door will be installed on the opposite side. Using a putty knife or any other 4...
Owners Manual - Page 15
... Gentle/ wrinkle resistant delicate
Do not dry Do not tumble dry (used in all GE Dryers when used with
do not dry a sheet with plastic trim and foam-filled items.
15...They may cause fabric softener stains. Bounce® Fabric Conditioner Dryer Sheets have been approved for the dryer.
Loading and using the dryer. Always follow the fabric manufacturer's care label when laundering. ...
Owners Manual - Page 16
...for stainless steel surfaces. These surface blemishes will not rust or corrode. If the dryer drum should be damaged by qualified service personnel.
The Exhaust Hood: Check with a damp...fabric may be cleaned once a year by some laundry pretreatment soil and stain remover products.
Dryer Interior and Duct: The interior of the Dryer
The Exterior: Wipe or dust any spills or ...
Owners Manual - Page 17
... follow the details on sharp objects. „ Venting must conform to the below specifications.
The dryer will use plastic or other combustible ductwork. „ Use the ...dryer cabinet and use only UL approved
transition ducting between the dryer and the home duct. „ Do not use more energy and run longer if it is not vented to local building codes. Correct Venting
Incorrect Venting...
Owners Manual - Page 18
... it before installing the filter screen. If a rubber flat washer is in place and attach the dryer's long inlet hose to one male end of the washer's inlet hose. Turn the water faucet on ...some models)
1. "Y" Connector
To produce steam, the dryer must also connect to the cold water, a "Y" connector is in place. Remove the washer inlet hose ...
Owners Manual - Page 19
... NOT place the washer on the dryer back.
„ The dryer MUST be vented to lift the dryer into position because of the installer. Stacking of a gas dryer is : 0s either side 3s ...for installation and service.
When stacking the dryer, more than two people are : 0s both a washer and a dryer, doors must contain a minimum of 60 square inches of utility services. Consideration must be given ...
Owners Manual - Page 23
.... ‡ If you are drying only one or two items, add a few items to call for service... When the dryer senses a low level of kinks and unobstructed. ‡ Check to make sure the dryer venting is correct.
‡ Make sure ducting is clean, free of
moisture in a load, choose More Dry if you...
Owners Manual - Page 28
...for service. During this appliance.
„Damage caused after delivery. „Product not accessible to provide required service. „Replacement of charge, all labor and related service costs... by our Factory Service Centers, or an authorized Customer Care® technician. GE Dryer Warranty.
All warranty service provided by possible
defects with this limited one-year warranty...
Owners Manual - Page 29
... We Will Replace:
One Year From the date of the original purchase
Any part of the dryer which are
working as described in the Owner's Manual.
(;&/86,212),03/,(':$55$17,(6³ ...During this appliance.
„Damage caused after delivery. „Product not accessible to provide required service. „Replacement of the light bulb after its expected useful life. &#...
Similar Questions
How To Access Inside Of Dryer?
There is a dead mouse under the drum. How do we access that?
There is a dead mouse under the drum. How do we access that?
(Posted by dianethetenor 5 years ago)
Ge Dryer Model Dpse810eg0wt
LED on front panel flashing. '8' Had unplugged to clean behind. Plugged back in, problem began. Mach...
LED on front panel flashing. '8' Had unplugged to clean behind. Plugged back in, problem began. Mach...
(Posted by pjabiff 9 years ago)
Exhaust Vent Location.
I have to installrigid ducting for this unit.Facing the back of the machine, iIs the exhaust vent lo...
I have to installrigid ducting for this unit.Facing the back of the machine, iIs the exhaust vent lo...
(Posted by zai1953 11 years ago)
Ge Laundry Spacesaver Dryer Noise
I have a GE laundry spacesaver stackable dryer that has started squealing loud. What is wrong with...
I have a GE laundry spacesaver stackable dryer that has started squealing loud. What is wrong with...
(Posted by larkinspinks11108 13 years ago)