Garmin echo 150 Support Question
Garmin echo 150 Support Question
Find answers below for this question about Garmin echo 150.Need a Garmin echo 150 manual? We have 2 online manuals for this item!
Question posted by schmack1234 on April 17th, 2012
Swivel Base Detachment
I need to know how to detach base from the swivel so I can mount the base to a piece of wood? Does it just snap apart?
Current Answers
Related Garmin echo 150 Manual Pages
Installation Instructions - Page 1
...• Masking tape • Number 2 Phillips screwdriver • Marine sealant • Hardware for optimal performance.
• Mount the transducer as close to the center of the 10-32 x...Needed
• Drill and drill bits • 3/8 in the path of the various components. February, 2011
190-01312-02 Rev. About the echo Mount The echo device can be mounted using the included swivel-mount...
Installation Instructions - Page 2
...mm) bit, drill a pilot hole approximately 3/8 in . (10 mm) on fiberglass, place a piece of tape over the hole and the cable, with the opening pointing downward.
5. Avoid routing the ... the hole and the cable.
4. Wipe away any excess marine sealant.
2
echo Installation Instructions Use a 5/8 in . (25 mm) deep at the selected mounting location on fiberglass hulls or 3/8 in . (10 mm)...
Installation Instructions - Page 3
...wood screws, either size #8 or a diameter of the trolling motor,
but do not overtighten). 7. Selecting a Swivel-Mount Location Select a location to install the swivel mount...;.
5. echo Installation Instructions
3 Properly align the gasket between the transducer mount and the...Swivel Mount
1. Separate the swivel base from a compass (page 6).
Installing the Transducer on the transducer mount...
Installation Instructions - Page 4
... it using
the appropriate screws or bolts ➋.
3. Apply marine sealant to the 5/8 in the upward position, place the echo
100/150/300c device ➋ or the echo 200/500c/550c cradle ➌ into the swivel mount (page 4).
➌
5. Place the swivel mount on the swivelmount base, but do not need to
fit only in . (16 mm) center hole you...
Installation Instructions - Page 5
...location on the cradle ports to identify the
➊
correct port.
2. echo Installation Instructions
5 Place the base of the cradle ➋.
2. Because water is severely degraded, note the ... Test the transom mount transducer installation in place by a locking bracket. Repeat steps 1 and 2 until
the echo device ➋ is correctly installed. Tilt the echo device forward and ...
Installation Instructions - Page 6
... trademarks of Garmin Ltd. Specifications
Specification Device
Size
echo 100/150/300c
echo 200/500c/550c
Weight (without bail mount)
Weight (with bail mount)
Display
echo 100/150/300c echo 200 echo 500c echo 550c echo 100/150/300c echo 200 echo 500c echo 550c echo 100/150
echo 200
echo 300c echo 500c
echo 550c
Case
echo 100/150/200/300c/ 500c/550c
Measurement
W × H ×...
Owner's Manual - Page 1
echo™ 100 and echo 150
owner's manual
Owner's Manual - Page 2
... are trademarks of Garmin. or its subsidiaries. © 2011 Garmin Ltd. or its products and to make changes in the USA and other Garmin products. echo™ is subject to change without the express prior written consent of Garmin Ltd. Garmin reserves the right to change or improve its subsidiaries, registered...
Owner's Manual - Page 3
...questions about this manual, the term "select" is highlighted, and then press ENTER. echo 100 and echo 150 Owner's Manual
1
When you should press MENU, press or until Pause is used ... you are instructed to www.garmin.com/support and click Contact Support
for the echo™ 100 and echo 150 fishfinders.
Registering Your Device
Help us better support you should highlight a series of...
Owner's Manual - Page 4
... the units in which to cycle through options or changes settings. Select or . 3. Select ENTER. Press and quickly release . 2. Scrolls through the brightness settings.
2
echo 100 and echo 150 Owner's Manual From the Sonar screen, select MENU > Setup > System > Contrast. 2. Turning On and Turning Off the Device
Press and hold . Repeat to measure...
Owner's Manual - Page 5
... and your previous screen is applied.
Setting the Beeper
You can quickly return to the Sonar screen, select or .
After returning to the setting options.
echo 100 and echo 150 Owner's Manual
Getting Started 3
Owner's Manual - Page 6
... shows the screen depth as the screen scrolls from 5 feet deep to adjust the range automatically based on the screen.
➌
➍
➋
Adjusting the Range of the Depth Scale
You...example, if you would like to the left side of the screen. Using the echo 100 and echo 150
Using the echo 100 and echo 150
Sonar Screen
The sonar screen shows a full-view graph of the depth scale ...
Owner's Manual - Page 7
... gain setting until you select a span of the screen, then slightly decrease the gain.
1. Adjusting the Zoom on the Alarms screen.
5
echo 100 and echo 150 Owner's Manual
Using the echo 100 and echo 150
Setting the Gain to decrease the gain. Select an option:
• To display the sonar screen with lower sensitivity and less...
Owner's Manual - Page 8
... better detail, has a narrower beam, and is typically used to cover a larger area.
1. Configuring the Appearance of Suspended Targets
You can select a frequency for the echo 150
When using a dual frequency transducer. Select an option:
• To show suspended targets as symbols, select . • To show suspended targets as symbols with target...
Owner's Manual - Page 9
... with the cloth.
Apply the liquid to 70°C) 10 in. (250 mm)
echo 100: 200 kHz echo 150: 77 kHz or 200 kHz 10-20 Vdc
AGC/3AG - 3.0 A echo 100: 600 ft. (183 m) echo 150: 1300 ft. (396 m) echo 100: 300 ft. (91 m) echo 150: 500 ft. (152 m)
Appendix
Viewing System Information
From the Sonar screen, select MENU...
Owner's Manual - Page 10
...ECHO 150, YOU AGREE TO BE BOUND BY THE TERMS AND CONDITIONS OF THE FOLLOWING SOFTWARE LICENSE AGREEMENT. You acknowledge that the Software in Garmin and/or its subsidiaries ("Garmin") grant you a limited license to human readable form the Software or any part thereof or create any derivative works based... other applicable country.
8
echo 100 and echo 150 Owner's Manual You further acknowledge...
Similar Questions
How Do I Go Into Simulation Mode On A Garmin Marine Gps Modle741xs
how do I use simulation mode on a garmin 741xs marine ver
how do I use simulation mode on a garmin 741xs marine ver
(Posted by Curthupp 6 years ago)
My Echo 150 S.n.27v019012,less Than One Year Old Dont Start Up With Normal Tens
Failure Start Up My Echo 150 Correctly Alimenteded s.n.27v019012
Failure Start Up My Echo 150 Correctly Alimenteded s.n.27v019012
(Posted by dameliomario 9 years ago)
Y Garmin Echo 150 Was Plugged In For The First Time And Believed To Be Functioni
My new Garmin echo 150 is not giving right depth readings, while in around 5 to 7 feet of water it w...
My new Garmin echo 150 is not giving right depth readings, while in around 5 to 7 feet of water it w...
(Posted by iclausman 10 years ago)
541s Marine Gps. Depth Not Reading Out.
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
(Posted by therad50 10 years ago)
In Accurate Reading On Echo 150
My ECHo 150 started not reading accurately. It reads 38 ft and 72 degrees constantly
My ECHo 150 started not reading accurately. It reads 38 ft and 72 degrees constantly
(Posted by johnyankosky 11 years ago)