2009 GMC Yukon Support Question
2009 GMC Yukon Support Question
Find answers below for this question about 2009 GMC Yukon.Need a 2009 GMC Yukon manual? We have 1 online manual for this item!
Question posted by sdccyberb on March 2nd, 2014
Can You Drive With Engine Light On And Stabilitrak Light On In Denali
The person who posted this question about this GMC automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 114
...vehicle. 2. There are other conditions which can extend the engine run out of the following:
/ (Remote Start):
This button will turn signal lights flash. However, the range may run time by... button for two to extend the engine running . When the vehicle starts, the parking lamps will turn the key to RUN to drive the vehicle. The engine will automatically shut off .
•...
Owner's Manual - Page 115
...remote start ready feature. After the key is an emission control system malfunction and the check engine light comes on page 3-74 for 15 minutes. Vehicles that have the remote vehicle start with...are shipped from the ignition, the vehicle can be enabled or disabled through the DIC. Also, the engine will turn off during a remote vehicle start . Once two remote starts, or a single remote ...
Owner's Manual - Page 130
... If the engine will not start the engine. Insert the new key to be programmed and turn it to brake or slow the vehicle.
• Avoid making hard stops for service. 3. The security light will perform ...mph (88 km/h) or less for
the first 500 miles (805 km).
• Do not drive at any one constant speed, fast or
slow, for the trailer towing capabilities of turning the ignition to ...
Owner's Manual - Page 131
... The key can bind with the engine off, the battery could cause damage to drain for driving.
Use the correct key, make sure... If this position when the engine is in the ignition. 2-25
To shift out of time. When the engine starts, release the key....the radio and the windshield wipers operate while the engine is the position that starts the engine. Notice: Using a tool to force the key...
Owner's Manual - Page 143
... to shift into Four-Wheel-Drive Low will stay on page 4-6. See StabiliTrak® System on when the shift is normal.
2-37 You can send the engine's driving power to the last chosen ...Four-Wheel Drive
If the vehicle has four-wheel drive, you can choose among five driving settings: Indicator lights in the switches show you which setting you are in. An indicator light will return...
Owner's Manual - Page 145
.../h). If the knob is turned to stop flashing before the Four-Wheel Drive Low indicator light has stopped flashing could damage the transfer case. After 30 seconds the ...Neutral) while the engine is engaged, vehicle speed should be stopped or moving less than 3 mph (5 km/h) with the transmission in gear and/or moving, the Four-Wheel Drive Low indicator light will flash ...
Owner's Manual - Page 146
...the Four-Wheel Drive Low position. Then slowly release the dial to Two-Wheel Drive High. 6. The preferred method for shifting out of Four-Wheel Drive Low
To shift from N (Neutral) while the engine is running. .../h) and the transmission is in gear and/or moving, the Four-Wheel Drive High, AUTO or Two-Wheel Drive High indicator light will flash for 30 seconds but will come on page 2-42 ...
Owner's Manual - Page 147
...the desired position. Start the engine and shift the transmission to LOCK/OFF.
3. Turn the ignition to stop flashing before the Four-Wheel Drive Low indicator light has stopped flashing .... Place the transmission shift lever in this mode for up to D (Drive) for the Four-Wheel Drive Low indicator light to ACC/ACCESSORY, which will go out. 4. To help avoid damaging ...
Owner's Manual - Page 185
... ...3-36 Tachometer ...3-36 Safety Belt Reminders ...3-36 Airbag Readiness Light ...3-37 Passenger Airbag Status Indicator ...3-38 Charging System Light ...3-39 Voltmeter Gage ...3-40 Brake System Warning Light ...3-40 Antilock Brake System (ABS) Warning Light ...3-42 StabiliTrak® Indicator Light ...3-42 Engine Coolant Temperature Gage ...3-43
Instrument Panel Overview ...3-4 Hazard Warning...
Owner's Manual - Page 196
Cruise control can be maintained without erasing the set speed. See StabiliTrak® System on slippery roads.
T (On/Off): This button can cause excessive wheel slip, and you cannot drive safely at speeds below about 25 mph (40 km/h) or more can be dangerous on page 4-6. Cruise control does not work at a steady...
Owner's Manual - Page 208
...you could cut or damage the warming grid, and the repairs would not be turned off the engine. h (Recirculation): Press this button to show that recirculation is activated. The defogger can be ... mode is on to turn the recirculation mode on . Do not drive the vehicle until all the windows are clear. An indicator light comes on . The air conditioning compressor will heat to turn the...
Owner's Manual - Page 212
... reduce the time it takes for air conditioning to be effective, the air conditioning light turns off recirculation and runs the air conditioning compressor unless the outside temperature is close...engine. Air is directed to the windshield and side window vents, with some directed to the floor vents.
Do not drive the vehicle until all the windows are clear.
3-28
An indicator light...
Owner's Manual - Page 213
...clear fog or frost from the surface of those modes, the indicator light flashes three times and then turns off . Do not drive the vehicle until all the windows are clear. These actions may ... turned off by turning off the ignition. It can also be covered by turning off the engine. Repairs would not be turned off by your warranty. See Rear Air Conditioning and Heating System...
Owner's Manual - Page 226
... off . Then start the engine again to assist the driver with the regular brakes. If the light comes on and stays on while driving, there could be a problem with a Driver Information Center (DIC), see DIC Warnings and Messages on , the vehicle still has brakes, but not antilock brakes. See StabiliTrak® System on , turn...
Owner's Manual - Page 228
.... This sequence repeats with this indicates that might not run as good, and the engine might not be a problem with the Tire Pressure Monitor System. Being aware of the light can prevent more information. Malfunction Indicator Lamp
Check Engine Light
A computer system called OBD II (On-Board Diagnostics-Second Generation) monitors operation of the...
Owner's Manual - Page 230
...vehicle will not pass this inspection if the check engine light is on with the engine running, or if the key is in ON/RUN and the light is warmed up , stalling when the vehicle is...could prevent getting a vehicle registration.
The diagnostic system can check the vehicle. A few driving trips should turn the light off. • If the vehicle has been driven through a deep puddle of the ...
Owner's Manual - Page 254
...StabiliTrak and this message displays, it means there is a problem. then start the engine again. You should see this message displays, the system will not limit wheel spin. The tire pressure light... (TCS). Stop; The vehicle is not working properly. SERVICE SUSPENSION SYSTEM
If your driving accordingly. SERVICE THEFT DETERRENT SYSTEM
This message displays when there is a problem with the...
Owner's Manual - Page 256
...light is re-learning the tire positions on . See Filling the Tank on page 3-44. A loose or missing fuel cap allows fuel to driving conditions.
• The message displays if an engine ...TIGHTEN GAS CAP
This message may display along with the check engine light on page 3-40.
• The message could occur if
StabiliTrak activates continuously for more information.
• The message also ...
Owner's Manual - Page 257
... the vehicle. After this message clears, the TRAILER GAIN/OUTPUT display appears in the vehicle gets hot. See StabiliTrak® System on page 4-6 for more information. TRANSMISSION HOT IDLE ENGINE
Notice: If you drive your vehicle while the transmission fluid is overheating and the transmission temperature warning is displayed. This message displays...
Owner's Manual - Page 330
...retailer for normal driving conditions, but it may also be necessary to spin excessively while the StabiliTrak, ABS and brake warning lights and any of the StabiliTrak system. If ... the StabiliTrak light will automatically disengage. Traction control limits wheel spin by reducing engine power to the wheels (engine speed management) and by the vehicle warranty. The engine speed...
Similar Questions
Service Engine Light
Usually when add Lucas oil sel goes away, but hasn't worked this time. I was told to add to oil, but...
Usually when add Lucas oil sel goes away, but hasn't worked this time. I was told to add to oil, but...
(Posted by kdk1960now 7 years ago)
Reasons Why An Engine Light Comes On A 2008 Gmc Yukon
(Posted by ammarhann 9 years ago)
Gmc Yukon Stabilitrak Light Flashes On When Slowing Down
(Posted by rfdc4shawbe 10 years ago)
2009 Gmc Yukon Getting Service Stabilitrak Light On, Check Engine Light
Engine on 2009 GMC Yukon stalling out, getting SERVICE STABILITRAK light on, check engine light on.....
Engine on 2009 GMC Yukon stalling out, getting SERVICE STABILITRAK light on, check engine light on.....
(Posted by StevenMotz 12 years ago)