Frigidaire FGGF3054MF Support Question
Frigidaire FGGF3054MF Support Question
Find answers below for this question about Frigidaire FGGF3054MF.Need a Frigidaire FGGF3054MF manual? We have 2 online manuals for this item!
Question posted by Bhc2000 on February 14th, 2016
How To Adjust The Top Programming Panel ?
The plastic controls sheet has slid down a little on one side , and is off kilter ,everything works fine but there's a gap at the top. I want to know which screws to loosen so I can adjust the sheet and make it level. Is it the screws in the back or is it just screws underneath in the front?
Supporting Image
You can click the image below to enlarge
Current Answers
Answer #1: Posted by waelsaidani1 on February 14th, 2016 9:17 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,787
Member since:
May 12th, 2013 Points: 19,501,787
Read the instructions carefully before using the oven. For satisfactory use of your oven, become familiar with the various functions of the oven as described below. Note: The graphics on your timer may not look exactly like those shown. This doesn't change the way it operates. Also Push buttons or pads may be shaped differently http://manuals.frigidaire.com/prodinfo_pdf/Lassomption/318204125.pdf
Related Frigidaire FGGF3054MF Manual Pages
Installation Instructions (All Languages) - Page 1
... ELECTRICAL INSPECTOR'S USE.
Refer to your gas supplier from the oven compartments before installing range.
• Remove all governing codes and ordinances. • Be sure to leave ...range is needed, contact your gas supplier, call your serial plate for future reference.
• Be sure your range is provided, contact your product dealer to operate on the lower rear back panel...
Installation Instructions (All Languages) - Page 2
... reach over carpeting unless you place an insulating pad or sheet of 1/4-inch thick plywood between the range and carpeting.
• Make sure the wall coverings around the range can withstand heat at the oven vent nor around the base or beneath the lower front panel of the cooking utensil. Hold a lighted match to the...
Installation Instructions (All Languages) - Page 3
... h Fig. includes 2 mounting screws (Fig. c
Materials
Fig. j
Materials supplied with appliance:
• Anti-Tip Template (Fig. d)
For gas supply connection: • Adjustable wrench and pipe wrench (Figs...Fig. Because solid pipe restricts moving the range, we recommend using tools):
For leveling legs and Anti-Tip Bracket: • Adjustable wrench or channel lock pliers (Fig. ...
Installation Instructions (All Languages) - Page 4
..."
25-3/4"
48-1/2" max
*
29-1/4"
36±1/8"
max
(Adjustable)
door
closed
46-5/8" max door open
* 9500 BTU or less
2"
10,000 - 16,999 BTU
3"
17,000 BTU or greater
5"
Fig. 2
29-7/8"
Fig. 3 4 FREESTANDING GAS RANGE
Installation with cabinets
Check location where the range will be solid and level. Contact surface must be installed for any...
Installation Instructions (All Languages) - Page 5
...by properly installed antitip bracket and screws packed with the range. Remove lower panel or storage drawer to a different location, the antitip bracket must be moved and installed with the range.
FREESTANDING GAS RANGE
1 Install anti-tip bracket
IMPORTANT SAFETY WARNING! For wall mount (Fig. 4), locate the bracket by adjusting the (4) leveling legs with a warmer drawer or...
Installation Instructions (All Languages) - Page 6
... an adequate gas supply. A convertible pressure regulator is pre-set for each 1000 ft.
Be sure you know where and how to the range (See Fig. 8).
Please note: Operation at elevations above sea level. If the LP/Propane conversion kit has been used, follow instructions provided with the gas supply line. Pressure regulator...
Installation Instructions (All Languages) - Page 7
... than 14" of water column pressure (approximately 1/2" psig).
Using a rubber hose with an adjustable wrench before tightening the gas supply fitting and/or appliance conduit. Turn burner valve on pressure
...on to Fig. 10) using NO MORE THAN 15ft./lbs. Make sure the service shut-off valve (See Fig. 8). Disconnect the range and its individual shut-off valve from the gas supply piping...
Installation Instructions (All Languages) - Page 8
... lip makes contact inside the center of the burner head you may check the fit by a qualified electrician to make sure ... to the cooktop. The cooktop is very important to be level.
Once in the correct locations before connecting electricity to insure proper... removeable. Please note that all burner caps properly installed to range. Always keep the burner caps and burner heads in place ...
Installation Instructions (All Languages) - Page 9
... checked for leaks and range has been connected to the LITE position. The inner portion (Simmer) of surface
burners. Use screw B to OFF. Turn the screw counterclockwise to decrease flame size. Turn clockwise to increase flame size.
A
B
other surface burners
Fig. 17
for operating instructions.
These control systems require no adjustment. When the oven reaches...
Installation Instructions (All Languages) - Page 10
...adjust lower oven air shutter loosen lock screw (See Fig. 21), reposition air shutter, and tighten lock screw. When finished adjusting replace burner baffle and oven bottom panel. If the gas or electrical supply is complete, make sure all controls... from front to back, then level the range by either adjusting the leveling legs or by placing a level horizontally on the right-hand surface of...
Product Specifications Sheet (English) - Page 1
... 28-1/2"
More Easy-To-Use Features
Express-Select® Controls
Easily go from warm to set temperature, using Quick Preheat....a button keeps food warm until everything -
At that adjusts to cook multiple dishes at once. One-Touch Keep... the oven holds the desired temperature of convection cooking - Freestanding Ranges
FGGF3054M F/ W/ B
Signature Features
Quick Preheat
Preheat in :
...
Product Specifications Sheet (English) - Page 2
...Ranges
FGGF3054M F/ W/ B 30" Gas
Features
Oven Control / Timing System Surface Type
Sealed Gas Burners Grates
Window Exterior Door Finish
Handle Design
Exterior Finish (Side Panels)
Convection System Oven Cleaning System Drawer Functionality
Express-Select® Controls... (BTU) Left Front Burner (BTU)
5,000 9,500
36" (Adjustable)
Left Rear Burner (BTU)
15,000
Center Extra Zone Burner (...
Product Specifications Sheet (English) - Page 3
...
• Floor beneath range MUST be solid and level. • Overhead cabinetry should not exceed a 13" maximum depth. • Absolute minimum horizontal distance between range and a carpeted floor... local and national electric and gas codes.
• Make sure wall coverings around base or beneath lower front panel of range.
Printed in the U.S.A. Specifications subject to change. Appliance...
Similar Questions
Had A Power Surge And The Control Panel Quit Working,
does this appliance have a inline fuse or do I need to replace the whole panel, I see no burni marks...
does this appliance have a inline fuse or do I need to replace the whole panel, I see no burni marks...
(Posted by 73props 4 years ago)
Error Code Loc
Manual indicates that this is showing that rinse aid is empty or low. Even when dispenser is filled ...
Manual indicates that this is showing that rinse aid is empty or low. Even when dispenser is filled ...
(Posted by jerviccraig 8 years ago)
Oven Elements Not Working. Broil Or Bake.
The stove top elements all work fine. The over bake and briol elements do not turn on. I have turned...
The stove top elements all work fine. The over bake and briol elements do not turn on. I have turned...
(Posted by rrchap 10 years ago)
Frigidaire Model Fggf3054mf Stove 4 Burners Out Of 5 Working The Large Burner No
(Posted by billyt26 11 years ago)
Durability Of Plastic Control Panel
I am thinking of buying this stove and have been cautioned about the plastic panel's durability. I w...
I am thinking of buying this stove and have been cautioned about the plastic panel's durability. I w...
(Posted by schuykate 11 years ago)