Home » Frigidaire » Laundry Washers » Frigidaire FFTW1001PW

Frigidaire FFTW1001PW Support Question

Find answers below for this question about Frigidaire FFTW1001PW.
Need a Frigidaire FFTW1001PW manual? We have 1 online manual for this item!

Frigidaire Overview Questions Manuals Reviews Videos Research

Question posted by jamesmarion1234 on November 22nd, 2017

Sensing Light And Beeps

The washer will start but then the sensing light starts blinking and beeps. What could it be causing that?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by waelsaidani1 on November 22nd, 2017 5:06 PM

This answer was accepted by the poster of the original question.

waelsaidani1

Member since:
May 12th, 2013

Points: 19,501,797

1,100
points

This is possibly caused by Wash load unevenly distributed in tub and out of

balance condition has occurred.

solution

Open washer lid, redistribute load. Close lid and press START to

resume @257;nal spin.

Related Frigidaire FFTW1001PW Manual Pages

Use and Care Guide - Page 1

All about the Use & Care of your Washer TABLE OF CONTENTS Important Safety Instructions 2-4 Operating Instructions 5-11 Care and Cleaning 12 Avoid Service 13 Warranty 14 Français 15 Español 29 www.frigidaire.com USA 1-800-944-9044 www.frigidaire.ca Canada 1-800-265-8352 A00092301 (1211)

Use and Care Guide - Page 2

Common sense and caution must be practiced when installing, operating and maintaining any appliance. Obey all instructions ...throughout this manual are labeled with a WARNING or CAUTION based on the serial plate located at the back of your washer. Model Number Serial Number Deﬁnitions This is used to alert you to potential personal injury hazards. WARNING WARNING...

Use and Care Guide - Page 3

You can become airtight chambers. • Keep laundry products out of children's reach. This will release any other appliance. • Failure ...wash items that could result in serious personal injuries. 3 If the hot water system has not been used near the washer. PROTECT CHILDREN • Do not allow children to ﬁre or serious injury. These substances give off vapors ...

Use and Care Guide - Page 4

... fumes which can cause serious injury or death. Use only authorized factory parts. • Do not tamper with controls. • Do not install or store the washer where it checked and...when using laundry products. Never ground the washer to support weight. • To reduce the risk of the washer must be plugged into the washer while parts are packed in the washer for installer...

Use and Care Guide - Page 5

... the drum may transfer to fabrics in other loads and cause skin irritation and/or damage to fabrics. 2 Prepare items... your washer. • Place delicate and small items such as bras, hosiery and baby socks in a mesh bag. 1 Sort laundry into loads...towels, rugs, and bedspreads. • Separate heavily soiled items from lightly soiled items. • Separate lacy, sheer, loosely knit, or...

Use and Care Guide - Page 6

...beep. • To add a forgotten item to the wash tub, press the pause button to be dried. 6 After the lid is ready to operate. • After making your selections, press START to "wake" the washer...softener occurs, clean with the detergent. OPERATING INSTRUCTIONS Washing Procedures, continued 6 Add laundry load to fabric softener dispenser. You will unlock at as directed by fabric ...

Use and Care Guide - Page 7

...or fabric tote bags. bedding This cycle is attempted after the cycle starts, the indicator lights will ﬂash and a signal will beep, but cold water is running, turning the selector knob to be ... Use this cycle to normally soiled cottons, towels, shirts, denims and mixed loads. The washer will not change the cycle. Cycle Selection Turn the cycle selector in a regular cycle. ...

Use and Care Guide - Page 8

... your model has status lights, the "sensing" indicator will be lighted during the cycle: • sensing • add a garment • wash • ﬁnal spin • clean Out of Balance Protection Your model is selected by the washer. If changes are attempted after the cycle starts, the lights will ﬂash and a signal will beep, but the cycle...

Use and Care Guide - Page 9

... utensils used. • Do not combine stain removal products, especially ammonia and chlorine bleach. Dangerous fumes can explode on unknown stains as hot water can cause serious injury or death. For best results Follow the fabric care label instructions on stain removal products. • Keep stain removal products in the stain...

Use and Care Guide - Page 11

...Unfastened zippers, hooks, buckles. • Rips, tears and broken threads. • Overloading the washer. • Degradation of detergent. • Add nonprecipitating water conditioner to wash water to remove ... ball up and cling to empty tub. Stiff, harsh fabrics. Rinse. • If caused by The Soap and Detergent Association. pills. PREVENTIVE MEASURES • Add detergent to fabric.)...

Use and Care Guide - Page 12

..., a dirty residue may develop in items left in the washer. • Dry the washer top, the area around the lid opening, and the un- Start the cycle and let the washer drain for cold weather storage and care. derside of fabric ...a nonabrasive household cleanser. CARE AND CLEANING Cleaning Instructions IMPORTANT Do not store or place laundry products on the tub.

Use and Care Guide - Page 13

...washer will not operate when the lid is usually normal. Status lights are not completely open. Load is open . Washer lid is incorrect height. Water supply faucets are blinking and washer beeps 3 times every 30 seconds. Do not overload washer.... did not occur. OCCURRENCE POSSIBLE CAUSE SOLUTION NOISE Rattling and clanking noise. Washer is ﬁlling. Foam shipping support...

Use and Care Guide - Page 14

... that has been transferred from its original owner to repair or replace appliance light bulbs, air ﬁlters, water ﬁlters, other consumables, or ...AND EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL BE PRODUCT REPAIR OR REPLACEMENT AS PROVIDED HEREIN. Damages caused by: services performed by unauthorized service companies; In Canada, your appliance. 9. MAJOR APPLIANCE WARRANTY...