Frigidaire FARG4044MW Support Question
Frigidaire FARG4044MW Support Question
Find answers below for this question about Frigidaire FARG4044MW.Need a Frigidaire FARG4044MW manual? We have 5 online manuals for this item!
Question posted by hiroshinop on June 11th, 2016
Dryer Does Not Work Fine
My name is Casey.I have Gas Model Dryer. It worked fine yesterday. But today it does not. Dryer runs but won't heat. Gas supply valve is Okay, Air supply looks fine. Any advice to check ?
Current Answers
Answer #1: Posted by Odin on June 11th, 2016 8:23 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Frigidaire FARG4044MW Manual Pages
Complete Owner's Guide (English) - Page 3
... place laundry or throw rugs against the front or back of the dryer.
...air. Some rubber materials, when heated, can occur.
• Do not obstruct the flow of lint around the opening and remove any circumstances, cut, remove, or bypass the grounding prong.
(fused 30 amp)
Power cord with the basic warnings listed below. IMPORTANT SAFETY INSTRUCTIONS
240 v Electric Dryer
120 v Gas Dryer...
Complete Owner's Guide (English) - Page 4
...can become airtight chambers.
• Keep laundry products out of a gas dryer must be practiced when installing, operating and...limiter switch after the dryer is removed from the electrical supply before reaching into a ...dryer where it checked and reinstalled by the use an extension cord or an adaptor plug.
• ALWAYS disconnect the dryer from service or discarded, remove the dryer...
Complete Owner's Guide (English) - Page 5
... the combustion tube. Dryer heat may be some sounds associated with the gas flame. fasten hooks and Velcro®-like fasteners. B. C. GAS BURNER (Gas models only.) When the ...valve opens and closes to fire or serious injury. AIR FLOW SYSTEM Your dryer is normal and can vary with a high volume air handling system. This could be a thumping or rolling sound when the dryer...
Complete Owner's Guide (English) - Page 8
... and sheets. normal Select this cycle to reduce allergens as work wear and overalls.
kids wear Select this Auto Dry cycle where... to select a dryness level.
8 Items prone to heat damage are not active and dryer will not be able to dry knits and delicates.
...rubber-backed bath mats. Use a Timed Dry cycle and the air dry setting.
delicates Select this Auto Dry cycle for any load,...
Complete Owner's Guide (English) - Page 10
...the cycle (and periodically during delay start to select a drying time convenient to your laundry in the selector knob again to simulate hanging your schedule or during wrinkle release.
delay... a few minutes without heat to pause the cycle, make the new selections and push in a summer breeze combined with the dryer's automatic moisture sensors and heat is selected. When chime...
Complete Owner's Guide (English) - Page 13
...the filter.
• Occasionally a waxy build-up may form on the filter restricts air flow, which causes longer drying times. Remove cleanser residue before drying the next load.
•... water.
• Before moving the dryer, place a strip of warm water and mild detergent. IMPORTANT
Do not store or place laundry products on top of dryer at the bottom of lint build-up...
Complete Owner's Guide (English) - Page 15
...air supply to make sure supply valve is restored. Dryer is not securely plugged in or plug Make sure the plug fits tightly in INSTALLATION INSTRUCTIONS. Drying temperature too high. Electrical power cord is overloaded. may turn but won't heat. See INSTALLATION INSTRUCTIONS for replacement. burner flame (gas models). Dryer should heat when utility service is open (gas models...
Installation Instructions (English, Español, Français) - Page 2
...work • 3-wire or 4-wire 240 volt cord kit
(electric dryer) • 4 in. (102 mm) clamp
• Gas line shutoff valve (gas dryer) • ½ NPT union flare adapters (x2)
and flexible gas supply line (gas dryer...other appliance. These conditions will obstruct clothes dryer airflow and increase the risk of life. This dryer is unpacked. Flexible venting materials are ...
Installation Instructions (English, Español, Français) - Page 3
...-to-back ‰ Cabinet is setting solid on all corners
Gas Supply (Gas Dryer)
‰ Manual shutoff valve present in supply ‰ All connections sealed with approved sealer
and wrench tight ‰ Conversion kit for function
Electrical Power
‰ House power turned on ‰ Dryer plugged in
Final Checks
‰ Installation Instructions and Use and Care Guide read...
Installation Instructions (English, Español, Français) - Page 4
... CONNECTION - Electrical requirements for sale in Canada have factoryinstalled, 4-wire power supply cord (NEMA 14-30R).
4
IMPORTANT
This dryer is internally grounded to be used when the appliance is in the installed position. branch circuit fused with power created by gas powered generators, solar powered generators, wind powered generators or any other generator...
Installation Instructions (English, Español, Français) - Page 5
... MUST be constructed of 1/2 psig (3.45 kPa).
7 The dryer MUST be disconnected from the gas supply piping system during any pressure testing of the gas supply piping system at test pressures in excess of stainless steel or plastic-coated brass.
4 The gas supply line MUST have an individual shutoff valve installed in Electrical Installation section.
plugged tapping, accessible...
Installation Instructions (English, Español, Français) - Page 7
...become caught in the screen, on the screws or rivets, clogging the duct work and creating a fire hazard as well as increase drying times. Use an approved vent ... m) duct length.
7 Do not exhaust dryer into the laundry area. If the dryer is not exhausted outdoors, some fine lint will be installed downstream with the flow of air. All male duct pipe fittings MUST ...
Installation Instructions (English, Español, Français) - Page 8
...dryer and the point the exhaust connects to the dryer.
2 Set the dryer timer and temperature to down ) and start the dryer...dryer vent elbow directly to meet minimum installation depth of free-standing dryer...Dryer vent elbows are available through a roof may expose the exhaust system to air fluff (cool down drafts causing an increase in vent restriction.
• Running... the dryer is ...
Installation Instructions (English, Español, Français) - Page 10
...Dryer Dimensions
27" (68.5 cm)
50" (127 cm) to clear open door
37" (94 cm)
43" (109 cm)
1.6" (4 cm)
electrical supply on rear of unit1
gas supply pipe on rear of gas... unit
3.75" (9.5 cm)
13.50" (34.5 cm) to center of rear vent
1Power supply cord length on gas...DRYER...EXPLOSION HAZARD Do not install the dryer where gasoline or other fl...
Installation Instructions (English, Español, Français) - Page 11
... power supply cord having an equipment-grounding conductor and a grounding plug that matches you 've installed on the appliance.
11 INSTALLATION INSTRUCTIONS
Electrical installation
The following are in doubt as to whether the appliance is not attached, the cord can be pulled out of the dryer and can be run with this dryer. WARNING...
Installation Instructions (English, Español, Français) - Page 12
...3 DO NOT modify the plug provided with this appliance.
Check with all local codes and ordinances. Gas dryer (USA and Canada)
1 The dryer is equipped with a three-prong (grounding) plug for ...equipped with a power supply cord having an equipment-grounding conductor and a grounding plug, the plug must be grounded. For a grounded, cord-connected dryer: 1 The dryer MUST be plugged ...
Installation Instructions (English, Español, Français) - Page 13
... (1.27 cm to dryer
Shutoff Valve Open position
from gas supply
4 Check for the connection. Manual Shutoff Flare Valve Union
GAS FLOW
Flare Union
Closed Nipple
Open
Flexible Connector
Inlet Pipe on the back of the dryer. This valve should be located in the same room as the dryer and should be in the gas supply line to allow gas to move through...
Installation Instructions (English, Español, Français) - Page 17
... swing area before servicing could result in the door opening opposite the hinges. REVERSING DOOR
Your dryer is designed so the door swing may need a screw driver with a #2 square
bit and...
Tools needed:
Screwdriver with a soft cloth or towel.
ELECTRICAL SHOCK HAZARD
3 Protect flat work surface, such as top of the hinge on a towel (front side down) to prevent scratches ...
Product Specifications Sheet (English) - Page 2
Dryer
Top Load Laundry - Ft.) Controls Dryer...Adjustable Leveling Legs
Frigidaire Affinity (M models)
7.0
Express-Select®
Stainless ...Gas Connection
Rear
Power Cord Location
Rear
Voltage Rating
120V / 60Hz / 15A
Connected Load (kW Rating) @ 120 Volts2 1.0
Amps @ 120 Volts
9.0
Heating..., Inc. Dryers (Electric FARG4044M W & Gas) 7.0 Cu. Ft. Height
43"
B -...
Product Specifications Sheet (English) - Page 3
...air.
• For garage installation, dryer MUST be located minimum 18" above floor.
• Floor MUST be solid with 120V 3-wire power supply cord, approx. 60" long.
• Always consult local and national electric & gas codes.
• Dryer can be 1/2" pipe and MUST have individual shutoff valve.
• Leveling legs supplied to level dryer... venting run possible.
• Gas supply line ...
Similar Questions
Will Not Start Pause Is Displayed When You Push The Center Knob And Will Not Sta
(Posted by jkkerrigan 10 years ago)
My Gas Dryer Turns, But No Heat.
My gas dryer will not heat, the drums turns.as normal. I did replace the igniter but itwillnot turn ...
My gas dryer will not heat, the drums turns.as normal. I did replace the igniter but itwillnot turn ...
(Posted by rel51 10 years ago)
My Dryer Runs But Shuts Off At 102 Minutes Left Or 51 Minutes Left. Restarts Ok
tried changing from timer to other options, tried different heats, tried different times. Still rand...
tried changing from timer to other options, tried different heats, tried different times. Still rand...
(Posted by svalentino 10 years ago)
Frigidaire Gleq2152es Electric Dryer Runs A While, Heats On Then Stops After 10m
(Posted by thespen691 13 years ago)