Frigidaire FAFW4011LW Support Question
Frigidaire FAFW4011LW Support Question
Find answers below for this question about Frigidaire FAFW4011LW.Need a Frigidaire FAFW4011LW manual? We have 4 online manuals for this item!
Question posted by klbarnes57 on December 10th, 2012
How To Change Belt On A Stack Washer And Dryer
how to change belt on dryer
Current Answers
Answer #1: Posted by bengirlxD on December 10th, 2012 1:28 PM
bengirlxD
Member since:
November 5th, 2012 Points: 6,395,085
Member since:
November 5th, 2012 Points: 6,395,085
Instructions
-
- 1
Disconnect power to the washer/dryer combo unit.
- 2
Remove two screws from the bottom of the washer front panel. Pull down on the panel to release it from the tabs, then remove if. Set the front panel aside.
- 3
Press in on the idler pulley, then turn the belt and roll it off the pulley. Remove the washer belt. Reverse steps 2 and 3 to install the new washer belt.
- 4
Remove two screws from the access cover. The access cover is the slanted panel above the washer top cover. Pull up on the cover to disengage two locating tabs, then pull the cover off. Set the access cover aside.
- 5
Remove six screws holding the heat shield in place. Remove the heat shield, then set it aside.
- 6
Push the idler pulley to the left to disengage the belt, then remove the belt from the pulley.
- 7
Remove four screws holding the console to the dryer unit. Pull down and out on the console, then let the console hang. Remove two screws from the bottom of the dryer front panel
- 8
Unplug the dryer door switch connector by depressing the connector tab with your fingers, then pulling the connector off.
- 9
Remove four screws holding the dryer front panel to the top frame of the unit. Pull the panel forward, then remove it. Set the panel aside.
- 10
Raise the front of the dryer tub slightly, then slide the belt off. Reverse steps 4 through 10 to install a new dryer belt.
- 11
Connect power to the washer/dryer unit.
- 1
- http://www.ehow.com/how_5637284_change-belts-frigidaire-washer_dryer-combo.html
Feel free to resubmit the question if you didn't find it useful.
Related Frigidaire FAFW4011LW Manual Pages
Installation Instructions (All Languages) - Page 1
All about the
Installation
of your Washer
TABLE OF CONTENTS
Important Safety Instructions 2-3 Installation Instructions 9-10 Installation Requirements 4-5 Accessories 11 Installed Dryer Dimensions 6 Notes 12 Unpacking Washer 7-8 Français 13
137337000A (1003)
Installation Instructions (All Languages) - Page 3
... all occupants. • Immediately call the fire
department. Do not stack washer on top of this manual must conform with rugs, bedspreads, or plastic sheets can become airtight chambers causing suffocation. Children might use any
phone in the vicinity of dryer. do not use them for installation:
OR
OR
AND
AND
Adjustable...
Installation Instructions (All Languages) - Page 4
... the grounding prong.
Power cord with power created by a path of least resistance for laundry hose connection. In situations where a two-slot receptacle is present, it is properly installed... inch (1.9 cm) with all local codes and ordinances or in a risk of your washer's water inlet.
time delay fuse or circuit breaker. Ground requirements
WARNING
ELECTRICAL SHOCK HAZARD Improper...
Installation Instructions (All Languages) - Page 5
... an area exposed to be unobstructed when a door is installed.
Louvered openings should never be necessary. Air openings are installed in a Recess or Closet
If washer and dryer are required to dripping water or outside weather conditions. Floor MUST be located 3 inches (7.6 cm) from bottom and top of 1 inch (2.54 cm). To...
Installation Instructions (All Languages) - Page 6
... supply cord length approximately 60 inches (152.5cm). 3Drain hose length approximately 52 inches (132cm).
6 Upward venting of exhaust on stacked dryer adds approximately 3.75 in . (10.2 cm) to installation depth. INSTALLED WASHER DIMENSIONS
51.4" (131cm) to clear open door
30.3" (77cm)* to front of closed door
water supply connection on rear of...
Installation Instructions (All Languages) - Page 10
...and snap it in place.
2 Place the hook end of the drain hose in a location near the washer for future reference.
Í NOTE
A wiring diagram and technical data sheet are located under any questions during ... hanger (shipped in the enclosure package) to the standpipe, inlet hose, laundry tub, etc.
Secure the drain hose with the cable tie (provided in washer drum) onto the drain hose.
Installation Instructions (All Languages) - Page 11
... Touch Up Pen -
Contact the source where you may be available. DRYER STACKING KIT
P/N 134700400 Depending on the model you purchased, a kit for ease of use of your model did not include a stacking kit or you desire another stacking kit, you purchased your washer. UNIVERSAL APPLIANCE WRENCH
P/N 137019200 A UNIVERSAL APPLIANCE WRENCH is available to elevate...
Complete Owner's Guide (English) - Page 3
... time.
• Do not store or use of all warnings on product labels.
• Before the washer is unpacked. You can become airtight chambers.
• Keep laundry products out of children is necessary when the washer is flammable; These substances give off vapors that has not been used for such a period, before...
Complete Owner's Guide (English) - Page 4
... cord or an adaptor plug. • Follow package directions when using laundry products. Installation instructions are moving. If the washer is equipped with controls. • Do not install or store the washer where it becomes overheated. It may be plugged into the washer while parts are packed in serious personal injuries. The motor will...
Complete Owner's Guide (English) - Page 6
... based on -going sounds may be an indication of these higher spin speeds. DRAIN PUMP Your washer is a normal part of the operation of fiberglass left in your home. WHITES
CASUAL
TOWELS
COLORS
1 Sort laundry into your pump is pumped from durable items. • Do not machine wash items containing fi...
Complete Owner's Guide (English) - Page 7
...of-balance load. The door should not be tightly packed. Add 1 or 2 similar items to washer.
• Brush off lint and dirt.
Large items should close easily.
• See Stain Removal... Guide in a load. • Load large items first. OPERATING INSTRUCTIONS
4 Add laundry load to help balance the load. • Wash a single heavy item such as bras, hosiery
and...
Complete Owner's Guide (English) - Page 8
..., soil level, and options for each cycle will be adjusted for more details. • To change the settings, press the Temp, Spin Speed and Soil Level buttons to scroll to the desired settings...marked with this symbol . • Fill to the dispenser. OPERATING INSTRUCTIONS
Operating Your Washer, continued
5 Add laundry products to the MIN line for small loads or the MAX line for this symbol on...
Complete Owner's Guide (English) - Page 9
...selected.
• Remove items from the washer when the cycle ends and place in dryer, line dry or dry flat ...are pressed. Just turning the cycle selector knob will not change the cycle once the cycle has begun, press Cancel, ...hold both for your laundry, not every setting or option is blinking, press Select. OPERATING INSTRUCTIONS
Operating Your Washer, continued
• To...
Complete Owner's Guide (English) - Page 11
..., Family-Sized Clothes Washers
The Allergy cycle will kill all dust mites and eliminate at the same time and hold until the signal sounds.
Í NOTE
To change the temperature, press ...of reversing tumble wash action for knits and delicates. Cycle Settings
WASH/RINSE WATER TEMPERATURE To change the temperature once the cycle has begun, press the Pause button, make the new selection...
Complete Owner's Guide (English) - Page 12
...Protolcol P172 Sanitization Performance of Residential and Commercial, Family-Sized Clothes Washers
Auto Temp Hot Use this setting for normally soiled white or colorfast...third party testing and certification organization dedicated to gently spin items that cycle.
Í NOTE
To change the options once the cycle has begun, press the pause button, make the new selection and press start again...
Complete Owner's Guide (English) - Page 14
... REFRESH OR CLEAN INSIDE OF WASHER To clean and freshen the washer, perform the System Clean cycle.
DO NOT use both for 10 seconds until the display changes to help clear any residual ... -balance situation that could damage the washing machine. To begin .
IMPORTANT
Items left in washer while performing the System Clean cycle will go through 2 rinse cycles to enter System Clean cycle...
Complete Owner's Guide (English) - Page 20
...the door open for a few hours after the System Clean Cycle.
Í NOTE
If the System Clean cycle is not in washer while performing the System Clean cycle will cause a severe out-of TIDE® WASHING MACHINE CLEANER. CAUTION
ENTRAPMENT and TIP-OVER HAZARD...
Press and hold the Spin Speed and Options buttons simultaneously for 10 seconds until the display changes to enter System Clean cycle.
Complete Owner's Guide (English) - Page 23
... water). Drain any time.
CARE AND CLEANING
IMPORTANT
Do not store or place laundry products on top of warm water and mild detergent. RV
ANTIFREEZE
Follow WINTERIZING INSTRUCTIONS for 1 minute to the floor. Press Start and let the
washer drain for cold weather storage and care.
23
Or, touch residue with...
Product Specifications Sheet (English) - Page 2
... Front Load Laundry - Washer Frigidaire Affinity (L models)Front Load Washers
FAFW4011L B / W 3.47 D.O.E. Ft. / 4.0 I .E.C. (Cu. Cu. Ft.) Controls Washer Drum Interior Interior... Speed / Soil Level Selections Allergen
5 Automatic 5 / 3
Optional Accessories
Dryer Stacking Kit 15" Frigidaire Affinity® Pedestal Drawers
Classic Red (R) Classic Blue ...change. Product Dimensions A - Width C -
Product Specifications Sheet (English) - Page 3
...Dryer Stacking ...Washer Specifications
• Product Shipping Weight (approx.) - 222 Lbs.
• An electrical supply with grounded three-prong receptacle is required. Frigidaire Affinity (All L Models excluding FAFW4221L)
Front Load Washers
FAFW4011L B / W 3.47 D.O.E. each, located 3" from top and bottom of washer's water inlet and MUST be necessary. Printed in area exposed to change...
Similar Questions
Front Load Washer Is Stuck On Sencing
washer will not start panel says sencing
washer will not start panel says sencing
(Posted by elsielikethecow 6 years ago)
How To Stack A Frigidaire Affinity Washer Model Fafw4011lwo
(Posted by auncars 9 years ago)
How To Change The Transmission In A Frigidaire Stacked Washer Dryer?
(Posted by miniLasVeg 10 years ago)
Frigidaire Stacked Washer Dryer
the tub seams to have falled about a inch, what support the washer tube, a bearing or bracket? what ...
the tub seams to have falled about a inch, what support the washer tube, a bearing or bracket? what ...
(Posted by centralmnconsultants 11 years ago)
My Washer Will Not Spin In Normal Cycle
My washer will not spin in normal cycle but will spin if put in spin only cycle
My washer will not spin in normal cycle but will spin if put in spin only cycle
(Posted by Anonymous-82015 11 years ago)