Get support for 2012 Ford Fusion

2012 Ford Fusion Support Question

2012 Ford Fusion Support Question

Find answers below for this question about 2012 Ford Fusion.
Need a 2012 Ford Fusion manual? We have 3 online manuals for this item!
Question posted by overmmer on January 22nd, 2014

What Lights Or Gauges Operate When The Key Is Turned To The On Position On The

2012 ford fusion?

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner Guide 3rd Printing - Page 12

...lights and gauges can alert you start your vehicle's functions. Service engine soon: The service engine soon indicator light illuminates when the ignition is ready for I/M testing. Normally, the service engine soon light...is first turned to the on after the engine is occurring which could 12 2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) If any light remains on position to check ...
Owner Guide 3rd Printing - Page 16

... indicators flash faster, check for the first time. Key-in-ignition warning chime: Sounds when the key is left on , the ignition is off , lock or accessory position and the driver's door is opened . Turn signal on warning chime: Sounds when the turn signal or the hazard lights are on for an extended period of time...
Owner Guide 3rd Printing - Page 54

...2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) The engine must be adjusted as desired. An indicator light on the Press R button will automatically default to single zone operation and set the temperature to the accessory position... to operate the rear window defroster. REAR WINDOW DEFROSTER R The rear defroster control is equipped with both . The rear window defroster turns off ...
Owner Guide 3rd Printing - Page 57

... more information. OFF 57 2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) Lights 4. The fog lamps will illuminate when the fog lamps have been turned on . 5. Wait the desired amount of the following positions: • Parking lamps • Low beams • Autolamps (when active) The fog lamp indicator light will not operate when the high beams...
Owner Guide 3rd Printing - Page 58

... to the full on position to activate the "dome on the interior courtesy lights. WARNING: Always remember to activate your headlamps at the first position the top or bottom of...lamp operation. • Tap the top or bottom of the control to deactivate. Daytime running lamps (DRL) (if equipped) Turns the headlamps on position, • the headlamp control is pressed. 58 2012 Fusion (fsn...
Owner Guide 3rd Printing - Page 61

... temperature is in pressure. When normal condensation occurs, a thin film of this design. Ambient lighting (if equipped) Illuminates footwells, storage bins and cupholders with a choice of the front doors are : • Water puddle inside the lamp 61 2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) Examples of acceptable condensation are vented to...
Owner Guide 3rd Printing - Page 62

... * Headlamp high beam 2 * Headlamp low beam 2 Front sidemarker lamp 2 * Front park/turn signal 2 lamp * Rear sidemarker lamp N/A Stop/tail/turn lamp 2 Backup lamp 2 License plate lamp 2 * High-mount brake lamp N/A Fog lamp...dealer. 62 2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) Slide on the interior of the lens Take your authorized dealer. To replace all instrument panel lights - The ...
Owner Guide 3rd Printing - Page 65

...next time the headlamps are operated. 8. Low beam bulb replacement For passenger side replacement of the low beam bulb, do not touch the glass. The oil from the splash shield. 65 2012 Fusion (fsn) Owners Guide, ...-apply pressure around the housing to align it again. Turn the headlamps on and make sure the protective cover is in the off position, then open the hood. 2. Lights 6.
Owner Guide 3rd Printing - Page 66

... discard the old bulb socket. Re-apply pressure around the housing to break the next time the headlamps are operated. 6. Remove the bulb socket by rotating it counterclockwise, then pull it again. 66 2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) WARNING: Handle a halogen headlamp bulb carefully and keep out of the...
Owner Guide 3rd Printing - Page 93

.... position, circle "R." 93 2012 Fusion (fsn...light above the selected button will turn... on to confirm that your Car2U௡ system by pressing the button you programmed to activate the opener. When a switch is in the garage. To program units with the vehicle in the middle, neutral, or 0 position... on, or + position, circle "L." Open the... device or home lighting, repeat Steps 1...
Owner Guide 3rd Printing - Page 94

... indicator lights will turn on L L L L or + Middle, neutral M M M M or 0 Down, R R R R off or - The indicator lights will blink slowly. Immediately (within 1 second) release the button once the garage door moves. Press and hold the button from left ; Most garage doors open quickly. Within 2.5 minutes enter your garage door opener does not operate following these positions into...
Owner Guide 3rd Printing - Page 113

.... The interior lights will not turn off the lights if: • the ignition is turned to the on because one of the vehicle doors or the trunk was opened . Note: At least two IKTs are closed and • 25 seconds elapse, or • the key is opened , the battery saver will shut off position. 113 2012 Fusion (fsn...
Owner Guide 3rd Printing - Page 117

... must have two previously programmed coded keys (keys that operates all the locks and starts the vehicle, as well as a remote keyless entry transmitter. The theft indicator will need to have the spare key(s) programmed. 117 2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) If the theft indicator stays on position. only four of integrated keyhead...
Owner Guide 3rd Printing - Page 118

... light may repeat Steps 1 through 8. Wait 20 seconds and you begin. 1. Remove the newly programmed coded key from Step 1. 118 2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) If failure repeats, bring your vehicle to the 1 (off ) position, insert the second previously coded key into the ignition. 2. After three seconds but within 20 seconds of turning...
Owner Guide 3rd Printing - Page 142

... has safety belt height adjustments at the front outboard seating positions. The safety belt warning light and warning chime turn off . 2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) WARNING: Position the safety belt height adjusters so that the belt rests across the middle of operation If...The driver's safety belt is not buckled before the...
Owner Guide 3rd Printing - Page 210

... not store the key in the ignition after 10 minutes of fire or other damage. 210 2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) Don't press the accelerator before driving at high engine speeds can produce very high temperatures in this chapter. Then, turn the engine off . Start- Normal operating temperature is normally reached...
Owner Guide 3rd Printing - Page 225

... OPERATION Understanding the gearshift positions of R (Reverse). 225 2012 Fusion ...(fsn) Owners Guide, 3rd Printing USA (fus) When you leave your foot off the accelerator pedal and the vehicle begins to slow down, the torque converter clutch locks up and aggressively shuts off position and remove the key whenever you take your vehicle. Turn...
Owner Guide 3rd Printing - Page 233

Shift into the neutral position. 2. This is not fully engaged, press the clutch pedal down , then shift into 1 (... by pushing the knob down and shift to reverse. Turn the ignition off position, and remove the key. 233 2012 Fusion (fsn) Owners Guide, 3rd Printing USA (fus) WARNING: Do not park your vehicle 1. Removing the key Turn the ignition to select 1 (First). If R (Reverse...
Owner Guide 3rd Printing - Page 246

...operating temperature or damage to the pavement. Driving If your vehicle goes off the edge of the pavement • If your vehicle goes off position and remove the key whenever you turn...turn the steering wheel too sharply or abruptly. • It often may be your primary concern. Do not rock the vehicle if the engine is latched in each gear. Press lightly.... 246 2012 Fusion (fsn)...
Quick Reference Guide 2nd Printing - Page 2

... fusion 2012...close from a venting position: Press and hold the...Ford Motor Company Customer Relationship Center | P.O. should be perceived as open the trunk without a key...operating and safety information, please consult your color options and turn the feature off until the glass stops moving . Box 6248 | Dearborn, MI 48121 1-800-392-3673 (FORD...Lighting (if equipped) repeatedly to Press turn...

Similar Questions

Ask a New Question
Use the box below to post a new question about this Ford automobile .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Ford Manuals

Find free 2012 Ford Fusion manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Ford Reviews

View thousands of Ford user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Ford customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Ford customer service rankings, employee comments and much more from our sister site.

Ford Recalls

Find comprehensive Ford recall information updated hourly on RecallOwl.com.