2012 Ford F550 Cab Support Question
2012 Ford F550 Cab Support Question
Find answers below for this question about 2012 Ford F550 Cab.Need a 2012 Ford F550 Cab manual? We have 2 online manuals for this item!
Question posted by shawo on August 15th, 2014
Ford F550 How To Program A Ignition Key
The person who posted this question about this Ford automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by BusterDoogen on August 15th, 2014 4:18 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,397
Member since:
October 30th, 2011 Points: 28,565,397
Go here for the procedure.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Manual Pages
Diesel Supplement 3rd Printing - Page 43
... engine may require the fuel filter to purge any trapped air from the fuel system after DFCM and engine mounted fuel filter replacement Turn the ignition key to on for 30 seconds, then turn it to lock it in a row to be purged of the filter. Make sure the drain is entering...
Diesel Supplement 3rd Printing - Page 66
... fuel in the electrical system or the fuel system. Reset the system by turning the ignition key to off and then back to the starter motor. • Check the fuel gauge... fan drive. • Driving with fuel and not on an empty tank. • Leaving the ignition key turned to Jump starting difficult because the glow plugs will cease activation. Maintenance and Specifications
• Try...
Owner Guide 4th Printing - Page 57
... fault is in use and the ESC cannot be deactivated. Refer to MyKey in the Driving chapter. COULD NOT PROGRAM INTEGRATED KEY - MYKEY SETTING - Displayed when an attempt is turned on integrated key, refer to or from 4X4 LOW. For more information. Displayed when the vehicle speed requirement for the electronic locking...
Owner Guide 4th Printing - Page 76
... is working properly. not available at this time on this channel. Channel no longer available. If the channel was one of time, or with an ignition key cycle, your authorized dealer for the disappear shortly. Subscription not Contact SIRIUS at available for that preset button. The system is working properly. Tune...
Owner Guide 4th Printing - Page 103
... to keep the inverter on - For an overheating condition, let the system cool off, then turn the ignition key off then on . POWER WINDOWS (IF EQUIPPED) WARNING: Do not leave children unattended in the on ....point is in fault mode Note: The 110V AC power point will turn the ignition key off after 13 minutes if the ignition is not in the vehicle and do not let children play with the power ...
Owner Guide 4th Printing - Page 114
...even more important for vehicles with the Upfitter option package which will only operate while the ignition is , however, recommended that the engine remain running or not. These switches will provide... instrument panel. The relays are also draining battery power when the ignition key is running to the Navigation System and SYNC supplements. If your authorized dealer for a...
Owner Guide 4th Printing - Page 123
Note: If equipped with a tailgate lock designed to help prevent theft of the tailgate. • Insert ignition key and turn to the right to engage lock. • Turn ignition key to the left to vehicle occupants or others. Tailgate Removal WARNING: Always properly secure cargo to prevent shifting cargo or cargo falling from vehicle, which...
Owner Guide 4th Printing - Page 133
... key (push button start) • It is not compatible with non Ford-approved aftermarket remote start systems. If you either enter the vehicle or shift the vehicle into the ignition ...with traditional keys may help customers who choose to use a non Ford-approved remote start system. Vehicles equipped with traditional keys When using a remote start fob. 3. To program a non Ford-approved ...
Owner Guide 4th Printing - Page 135
...; Key in the ignition is already a MyKey. • Key in the ignition is the last remaining admin key (there always has to be at least one admin key). • SecuriLock passive anti-theft system is disabled or in unlimited mode. • Vehicle has been started using a non Ford-approved remote start system that is programmed as...
Owner Guide 4th Printing - Page 136
...;. • Vehicle is equipped with a non Ford-approved remote start system. Refer to Using MyKey with remote start systems section. • Unknown key has been programmed to Using MyKey with push button start
MyKey programmed total includes one additional key
Admin keys programmed total includes one additional key
MyKey distance does not accumulate
136...
Owner Guide 4th Printing - Page 145
...Note: Replacement of the battery will shut off the interior lamps 30 minutes after the ignition has been turned to operate. How to reprogram your Integrated Keyhead Transmitters reprogrammed because you ..., or would like to have been turned on the keyless entry keypad are required to Programming spare keys in the battery housing cavity. 5. The dome lamp control (if equipped) must not be...
Owner Guide 4th Printing - Page 149
...the ignition is used to purchase gasoline or similar items, or a second coded key on position. The authorized dealer can program your keys and lock all objects on how to program the coded key.... Note: Do not leave a duplicate coded key in vehicle starting problems and a loss of security protection. Your vehicle comes with non-Ford aftermarket remote start " condition. Locks and ...
Owner Guide 4th Printing - Page 150
... for timely implementation of eight keys can be very costly. Insert the first previously programmed coded key into the ignition and turn the ignition from the vehicle in the 3 (on ) position (maintain ignition in a safe place to an authorized dealer. Replacement keys If your vehicle towed to help prevent any inconveniences. Programming spare keys A maximum of each step in...
Owner Guide 4th Printing - Page 151
... Steps 1 through 5. If failure repeats, bring your vehicle to your new key to aid in the 3 (on ) position (maintain ignition in the event of removing the first coded key, insert the second previously programmed coded key into the ignition and turn the ignition from the ignition. 5. When unauthorized entry occurs, the system will flash the park/turn the...
Owner Guide 4th Printing - Page 152
...the above , otherwise the alarm will return the vehicle to disarm the alarm system using the key or the remote entry transmitter.
152
2012 F-250/350/450/550 (f23) Owners Guide, ... the transmitter. • Turn the ignition to the on position with a programmed coded ignition key. • Unlock the doors by using your keyless entry pad. • If using a key in the driver's door to unlock the...
Owner Guide 4th Printing - Page 159
... seat cushion. Move the rear of the control up or down to Auxiliary power point (12VDC) in the directions shown to the compartment. Use the ignition key to program the lock to move the seat forward or backward.
159
2012 F-250/350/450/550 (f23) Owners Guide, 4th Printing USA (fus) Refer to...
Owner Guide 4th Printing - Page 190
...the switch in a proper position can increase the risk of the switch, always remove the ignition key from a deploying passenger airbag. WARNING: In order to avoid inadvertent activation of serious injury... the passenger air bag switch is in the OFF position and the ignition switch is in the OFF position while removing the key. 2. Failure to OFF position and hold in on, have the passenger...
Owner Guide 4th Printing - Page 191
... back on The passenger airbag remains off until you turn the switch to ON. 2. Insert the ignition key and turn it back on. 1. When you turn OFF your airbag, you not only lose the...pass airbag off" light is illuminated when the passenger airbag switch is in the ON position and the ignition switch is turned to on , have been specifically designed to work with the airbags in the NHTSA/Transport...
Owner Guide 4th Printing - Page 286
... of the shroud. 6. Remove the three fasteners under the column that secure the lower shroud half to 1 (off), then remove the key. 2. Perform Steps 4 through the slot in reverse order, making sure to clear the hazard flasher button, then pull straight rearward toward .... 286
2012 F-250/350/450/550 (f23) Owners Guide, 4th Printing USA (fus) Turn the ignition key to the column.
7.
Owner Guide 4th Printing - Page 398
...Maintenance (I/M) testing Some state/provincial and local governments may have Inspection/Maintenance (I/M) programs to inspect the emission control equipment on or the bulb does not If ... the on ready for at least four 30-second idle periods. Once started, do not turn the ignition key to On-board diagnostics (OBD-II) in this inspection could prevent you from getting a vehicle registration....
