2008 Ford Crown Victoria Support Question
2008 Ford Crown Victoria Support Question
Find answers below for this question about 2008 Ford Crown Victoria.Need a 2008 Ford Crown Victoria manual? We have 7 online manuals for this item!
Question posted by noovmajes on August 9th, 2013
How Ro Remove Fan 88 Crown Vic
The person who posted this question about this Ford automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 9
... Lockout Interior Luggage Compartment Release Engine Oil Engine Coolant Temperature Battery
Do Not Open When Hot Avoid Smoking, Flames, or Sparks Explosive Gas
Battery Acid
Fan Warning Maintain Correct Fluid Level Engine Air Filter Jack
MAX MIN
Power Steering Fluid Service Engine Soon Passenger Compartment Air Filter
Check Fuel Cap
Low...
Owner's Manual - Page 13
... Ajar • Amber: Low Fuel Refer to Engine oil in the Tires, Wheels and 13
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Refer to Engine coolant in the ...falls below the normal range. Refer to Message Center in the Maintenance and Specifications chapter. Never remove the coolant reservoir cap while the engine is active. It will be checked. Traction control™...
Owner's Manual - Page 16
Press the control again to reset.
16
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Press and hold the button on the cluster for two seconds to select Trip A and Trip B features. Instrument Cluster
Never remove the coolant reservoir cap while the engine is 000000.0 miles. • With Message Center...
Owner's Manual - Page 21
...then press rear/front speakers. 8. then SEL to disable the feature when COMPRESS ON is not removed within the allotted time, the system will store the last one in the display. When activated,... TREB (Treble): Press TREB; Note: The eject function will appear in the remaining presets. 21
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Eject: Press to set the strongest ...
Owner's Manual - Page 23
If the disc is not removed within the allotted time, the system will work when the ignition is turned off , the CD control must be pressed before inserting the disc. CD slot: Insert a CD, label side up. With the ignition off .
23
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus...
Owner's Manual - Page 29
...treble output. 7. If no preset is on or off. Note: If the CD is not removed within 15 seconds, the system will reload the disc and begin play if the system is selected,...to shift press sound to enable Satellite reception is available through your authorized dealer for availability. 29
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Your system may be equipped with...
Owner's Manual - Page 32
...tapes to play the CD tracks in the cassette player for the CD currently being played.
32
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) SHUF (Shuffle): Press and hold ...are established by inserting a finger or pencil into the hole and turning the hub. • Remove loose labels before inserting tapes. • Allow tapes which have been subjected to extreme heat, humidity...
Owner's Manual - Page 34
...panel vents only.
This allows the vehicle to the back seats. • Remove any snow, ice or leaves from entering the vehicle. OFF: Outside air is...circulated in MAX A/C or OFF when the vehicle is shut out and the fan will not operate. This mode will interfere with the air flow selector in ...the windshield. 34
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus)
Owner's Manual - Page 35
...instrument panel as these objects may become projectiles in cold weather: 1. The system will automatically determine fan speed, airflow location, and outside or recirculated air to heat or cool the vehicle to HI... the desired temperature using the temperature controls. To increase airflow to LO. 35
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Adjust the temperature ...
Owner's Manual - Page 36
...DEF simultaneously to select the temperature. Max A/C: Uses recirculated air to manually increase or decrease fan speed. Air flows from the instrument panel vents only. 9. The set point temperatures in Celsius... again. Outside Temp: Press to display the outside air to the back seats. 36
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) The temperature will help prevent...
Owner's Manual - Page 37
...HI. 4. The ignition must be covered by your warranty.
37
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Set the fan speed to maintain comfort. 3. The defroster turns off the defroster, press... of the instrument panel. Select NORM A/C. 2. Climate Controls
• Remove any snow, ice or leaves from the inside of the rear window. This may become projectiles in cold...
Owner's Manual - Page 45
... connector from the socket by pulling rearward.
45
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Make sure headlamp switch is in OFF position, then open the hood. 2. Make sure the headlamp switch is in the OFF position and remove the overhead console from the back of all the...
Owner's Manual - Page 46
... you should be cleaned with the tabs in OFF position, then open the hood. 46
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Install the headlamp assembly with three ...knobs. 6. Replacing front parking lamp/turn signal bulb To remove the front parking lamp/turn signal bulb: 1. Without turning, remove the old bulb from your hand could cause the bulb to align the...
Owner's Manual - Page 47
... bulb retaining ring by gently pulling it from the vehicle.
47
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) To complete installation, follow the removal procedure in the OFF position, then open the hood. 2. Remove the old bulb from the lamp assembly by rotating it counterclockwise (when viewed from the...
Owner's Manual - Page 48
... by rotating it counterclockwise, then pulling it clockwise. 6. Rotate the bulb socket counterclockwise and remove from the socket and push in the new bulb. 5. Make sure headlamp switch is in...from the vehicle. 3. Remove three nuts and the lamp assembly from entering the trunk. 48
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Remove the bulb socket by rotating...
Owner's Manual - Page 49
... and the license plate lamp assembly from the trunk lid by turning clockwise.
49
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Replacing license plate lamp bulbs 1. Replacing backup lamp bulbs 1. Open trunk and remove bulb socket from the trunk lid. 2. Carefully pull the bulb from the socket and...
Owner's Manual - Page 50
Lights
Replacing high-mount brakelamp bulbs 1. To install, reverse the removal procedure.
50
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Carefully pull the bulb socket out of the socket and push in the new bulb. Remove two screws from the lamp assembly. 2. Carefully lift the lamp assembly up for access...
Owner's Manual - Page 65
... could cause damage to remove ice, mist and fog when the rear window defrost is frozen in carefully when driving through a narrow space, like an automatic car wash.
65
2008 Crown Victoria (cro) Owners Guide...to lock mirrors in place. Return to the center position to tilt the mirror. 3. Do not remove ice from the mirrors with a scraper or attempt to adjust the right mirror or mirror. 2. ...
Owner's Manual - Page 211
... Do not disconnect the battery of the disabled vehicle as this could result in wheel pilot hole, remove loose particles by smearing a "dime" (1 square cm) sized glob of grease around the battery...the adaptive learning process will not affect function or durability of the engine cooling fan and other moving parts. 211
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Park the ...
Owner's Manual - Page 212
Turn the heater fan on in both vehicles to the positive (+) terminal of the assisting battery.
212
2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus)
-
- - +
-
+ +
+ Check all other end of the discharged battery. Turn all battery terminals and remove any electrical surges. Connect the positive (+) jumper cable to designate the assisting...
Similar Questions
88 Crown Vic Engine Light Flashing When Making A Right Turn And At Idle
(Posted by spdl 9 years ago)
How Do You Remove 2008 Ford Crown Vic Wiper Blades
(Posted by bignbj286 10 years ago)
