Home » Ford » Troubleshooting » 2000 Ford Ranger

2000 Ford Ranger Support Question

Find answers below for this question about 2000 Ford Ranger.
Need a 2000 Ford Ranger manual? We have 4 online manuals for this item!

Ford Overview Questions Manuals Reviews Videos Research

Question posted by phillipbrown99 on October 11th, 2014

Why It Want Heat After Installing New Heater Core

The person who posted this question about this Ford automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BusterDoogen on October 11th, 2014 3:40 PM

This answer was accepted by the poster of the original question.

BusterDoogen

Member since:
October 30th, 2011

Points: 28,565,407

1,100
points

Have you checked the thermostat.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

Related Manual Pages

Owner's Manual - Page 4

Vehicle Symbol Glossary Safety Alert See Owner's Guide Fasten Safety Belt Air Bag-Front Air Bag-Side Child Seat Installation Warning Brake System Brake Fluid Non-Petroleum Based Master Lighting Switch Child Seat Child Seat Tether Anchorage Anti-Lock Brake System Traction Control Hazard Warning ...

Owner's Manual - Page 9

... or water in a moderate fashion (avoid heavy acceleration and deceleration) and have been properly installed and securely tightened. You should turn off. (A driving cycle consists of a cold engine ... by filling the fuel tank with high quality fuel of the recommended octane and/or properly installing and securely tightening the gas cap. Examples are: 1. After three driving cycles without a ...

Owner's Manual - Page 19

... in the vehicle. 19 Controls and features Flash to pass Pull toward you to activate and release to turn on interior lamps. CLIMATE CONTROL SYSTEM Heater only system (if equipped) OFF DIM Fan speed control Controls the volume of the instrument panel during headlamp and parklamp operation. • Rotate up to...

Owner's Manual - Page 20

... through the windshield defroster ducts. This will not operate. (Floor)-Allows for maximum heating. Controls and features Temperature control knob Controls the temperature of the vehicle. OFF (... outside air through the instrument panel registers. (Panel and floor)-Distributes outside temperature. On heater-only systems, the air cannot be used to the rear seats (if equipped). 20 ...

Owner's Manual - Page 21

... and features • Remove any snow, ice or leaves from the air intake area (at the bottom of the airflow inside the vehicle. 21 Manual heating and air conditioning system (if equipped) OFF A/C MAX A/C Fan speed control Controls the volume of air circulated in a collision or sudden stop. Do not place...

Owner's Manual - Page 22

.... Under normal conditions, your vehicle's climate control system should be cooled below the outside temperature is quieter than the air sent to cool the vehicle. Heating and air conditioning capabilities are provided in the OFF position. • MAX A/C-Uses recirculated air to the instrument panel registers. 22 This mode can also...

Owner's Manual - Page 23

... the air conditioner will reduce fogging on your air conditioner as you drive for maximum heating by distributing outside temperature because the air conditioning does not operate in between the full ...Controls and features • (Floor)-Allows for two or three minutes with the windows open. Heating and air conditioning capabilities are provided in the OFF or MAX A/C position. • Do...

Owner's Manual - Page 52

... information will again display for 10 seconds before reverting back to direct sunlight, high humidity, extreme heat or extreme cold. Allow tapes that are 90 minutes long or less. • Do not ... Cleaning compact discs Inspect all discs for 10 CLK seconds, when the radio is changed, (new radio station, etc.), the media information will always be displayed. Press the control again to...

Owner's Manual - Page 68

... stolen and you will light for an extended period of time or flashes rapidly, have the spare SecuriLock key(s) programmed. 68 To program a new SecuriLock key yourself, you want to ensure the lost or stolen), you can be purchased from the ignition key. Controls and features other objects on the key ring...

Owner's Manual - Page 179

...transmission), turn off all accessories and start the engine. 3. When the battery is disconnected or a new battery is swallowed, call a physician immediately. With the vehicle at least one minute. 5. To...and care Batteries normally produce explosive gases which can cause personal injury. If acid is installed, the engine must relearn its idle and fuel trim strategy for at least one ...

Owner's Manual - Page 180

... blades If the wiper blades do not use fuel, kerosene, paint thinner or other solvents. 180 If the battery has been disconnected or a new battery has been installed, the clock and the preset radio stations must be adversely affected until the idle trim is reconnected. • Always dispose of automotive batteries in...

Owner's Manual - Page 198

... ring by its plastic base and do not touch the glass. Grasp the bulb only by rotating it straight back out of children's reach. To install the new bulb: Handle a halogen headlamp bulb carefully and keep out of the lamp assembly. Maintenance and care 5. The oil from the rear) to retain the...

Owner's Manual - Page 199

... socket counterclockwise about 1⁄4 turn to snap in place. 10. When the grooves in the new bulb. 7. Align the lamp studs with the plastic grommets on lamp assembly. 199 Open the hood...lamp assembly and turn and remove from lamp assembly. 6. Disengage lamp assembly (it "snaps." 9. Install two screws on the vehicle and push to lock. 8. Remove two screws from the bulb by ...

Owner's Manual - Page 200

... clockwise. 200 Carefully pull the bulb straight out of the tail lamp assembly, one just below the other. Install the bulb socket in the new bulb. 5. Remove the bulb socket from lamp assembly. 4. Install the bulb socket in the same portion of the socket and push in lamp assembly by turning counterclockwise. 2. Connect...

Owner's Manual - Page 201

... burn time. 201 This procedure covers the high-mount brakelamp bulb. Remove the two screws and lamp assembly from socket and push in the new bulb. 4. To install the brakelamp assembly: 1. Pull out the old bulb from vehicle. 2. Headlamp bulbs must be marked with two screws. To remove the brakelamp assembly: 1. Replacing...

Owner's Manual - Page 226

... May be sold with unlimited distance on medium/heavy duty trucks unless the accessory is installed on a new vehicle, then the warranty becomes the balance of your automotive needs; they are custom ...designed to complement the style and aerodynamic appearance of the new vehicle's warranty or the accessories warranty, whichever is made from high quality materials and...

Owner's Manual - Page 232

......186 calculating fuel economy ...192 cap ...188 Index Climate control (see Air conditioning or Heating) ...19 Clock ...29,36,42,51 Clutch fluid ...167 operation while driving ...116 ... refill capacities ...209 service points ...160,161,162 starting after a collision ...138 Engine block heater ...104 Engine oil ...163 checking and adding ...163 dipstick ...163 filter, specifications ...165,209...

Owner's Manual - Page 233

... specifications ...201 daytime running lights ...18 flash to pass ...19 high beam ...11,18 replacing bulbs ...197 turning on and off ...18 warning chime ...13 Heating ...19 heater only system ...19 Hood ...159 Ignition ...214,215 positions of the ignition ...54 Infant seats (see Safety seats) ..94 Inspection/maintenance (I/M) testing ...196 Instrument...

Warranty Guide 1st Printing - Page 12

... Limited Warranty does not cover damage caused by Use and/or the Environment Your New Vehicle Limited Warranty does not cover surface rust and deterioration of time with the result that result from use and/or exposure to maintain your vehicle. 8 • non-Ford parts installed after the vehicle leaves Ford's control.

Warranty Guide 1st Printing - Page 13

...; wiper blades • clutch linings • engine tune-up Other Items and Conditions Not Covered Your New Vehicle Limited Warranty also does not cover: • non-Ford parts of your vehicle, for example, parts (including glass) installed by body builders or manufacturers other than Ford, or damage to Ford components caused by...