2008 Dodge Avenger Support Question
2008 Dodge Avenger Support Question
Find answers below for this question about 2008 Dodge Avenger.Need a 2008 Dodge Avenger manual? We have 1 online manual for this item!
Question posted by Snowbunnee77 on December 13th, 2011
What Could Cause The Starter To Stay Engaged And Not Start In An 08 Avenger?
we have an 08 avenger and we have been having some problems with starting it here lately. at first we go to start the car everything turns on but wont start we have to take key out and repeat like 2-5 times then car starts. well the other nite we went to start it and when i turned the key over the starter stays engaged and car dosent start. we have to turn key off n take out to make it stop. need help. could the fuel pump cause the starter to do this?
Current Answers
Related Manual Pages
Owner's Manual - Page 17
...
seconds), it indicates that there is physically held against the ignition key being shut off in the electronics. NOTE: • The Sentry Key Immobilizer System is a problem with this occur, have been programmed to start the engine. All of these conditions will not cause a key-related (transponder) fault unless the additional part is a fault in two...
Owner's Manual - Page 19
... cause harmful interference.
2 Operation is programmed. After 10 seconds, a chime will stop flashing. The new Sentry Key is subject to be reprogrammed. Turn the ignition switch to the ON position within 15 seconds. Turn the ignition switch to have a programmed Sentry Key , contact your vehicle. Turn the ignition switch to the ON position within 60 seconds.
Repeat...
Owner's Manual - Page 20
.... Remove the keys from the ignition switch and get out of the visual signals after 3 minutes, turn off all doors.... 3. REARMING THE SYSTEM: If something triggers the alarm, the system will rearm itself. 18 THINGS TO KNOW BEFORE STARTING...turned ON, or the power door locks are unlocked in any interference that may be received, including interference that may cause ...
Owner's Manual - Page 24
...this feature to return this manual for at the same time. 3. Release both buttons at least four seconds, but not longer than ten seconds. The turn on a programmed transmitter for details.
• For vehicles... Key Unlock, Driver Door/All Doors First This feature lets you want to its previous setting. Then, press and hold the LOCK button on . 22 THINGS TO KNOW BEFORE STARTING YOUR...
Owner's Manual - Page 25
...cause the alarm to sound. Repeat these steps if you are locked or unlocked with the Security Alarm activated will cause the turn signal lights to return this manual for at the same time. 3. Press the UNLOCK button to deactivate the Security Alarm. This feature can be turned... THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 23
Alarm.... key removed. 4. Opening a door with ...
Owner's Manual - Page 26
... of this manual for at the same time. 3. Sound Horn with the transmitter. Then, press the PANIC button while still holding the LOCK button. 2. The turn signal lights will flash and the horn will cause the horn to chirp when the doors ...vehicles not equipped with the ignition in Section 4 of this feature to return this manual. Repeat these steps if you want to its previous setting.
Owner's Manual - Page 27
...will stay on for at the same time. TO UNLATCH THE TRUNK Press the TRUNK button on the transmitter two times to deactivate the Security Alarm.
USING THE PANIC ALARM To turn ...off by the system.
2 When the PANIC alarm is 5 mph (8 km/h) or greater. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 25
NOTE: Pressing the LOCK button on the transmitter while you are in the vehicle will cause...
Owner's Manual - Page 28
... apply. 26 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
PROGRAMMING ADDITIONAL TRANSMITTERS Refer to pry the two halves of the transmitter apart. With the transmitter buttons facing down, use a flat blade to SENTRY KEY "Sentry Key Programming." If you touch a battery... case, snap the two halves together. NOTE: Perchlorate Material - special handling may cause battery deterioration.
Owner's Manual - Page 29
... from a normal distance, check for these two conditions. 1.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 27
GENERAL INFORMATION This device complies with part 15 of FCC rules and ....
2 This device must accept any interference that may be received including interference that may not cause harmful interference. 2. If your Remote Lock Control fails to operate the equipment. Operation is five...
Owner's Manual - Page 33
... for a number of vehicle equipment may cause severe personal injuries and death. • Never leave children alone in the ignition. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 31
WARNING!
• For...when you park and leave the vehicle. • When leaving the vehicle always remove the key from the ignition lock, and lock your vehicle.
Unsupervised use of reasons. Leaving children in...
Owner's Manual - Page 36
... in a collision. 34 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
"CHILD-PROTECTION" DOOR LOCK SYSTEM (REAR DOORS) The Rear Door Child-Protection Locks are engaged.
Remember that the rear doors can only be ... are located inside the rear edge of the ignition key or similar flat-bladed object into the lock and rotate approximately one-quarter turn to the lock or unlock position (as indicated by...
Owner's Manual - Page 37
... is active. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 35
NOTE: For emergency exit with the system engaged, move the lock plunger up -down the window, and open the door with the outside door handle. The window controls will operate when the ignition switch is turned to the ON or ACC position, and...
Owner's Manual - Page 44
42 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Buckle up even though you . Someone on the road may be a poor driver and cause a collision that seat belts save lives, and they ...dangerous. Seat belts reduce the possibility of ejection and the risk of injury caused by striking the inside of the belt to be belted at all times. This feature allows the shoulder part of the vehicle. But in a ...
Owner's Manual - Page 180
...the tire size equipped on when turning the key from LOCK/OFF to ON/RUN...ON/RUN position before engine start . may result. (Refer to "Tire Inflation Pressures"... may illuminate the light after engine start . If the Malfunction Indicator Light...will drive normally and will illuminate when the key is equipped with a TPMS, as a ...Aftermarket wheels can cause sensor damage. Malfunction Indicator Light This light...
Owner's Manual - Page 181
...on . The vehicle should be serviced as soon as four seconds. Turn the ignition key to operate normally provided that it may stay on , have the system checked by an authorized dealer. 27. ... but do not start the vehicle. High Beam Indicator This light shows that there is a problem with the anti-lock brake system (if equipped).
4 If the brake light turns on, it is turned to restore the...
Owner's Manual - Page 247
... or dust, and to cool the interior rapidly upon initial start up inside air stuffy and window fogging may occur. To ...will illuminate when the Air Conditioning System is set to engage the Air Conditioning. Extended use the recirculation mode as ... of the recirculation mode in recirculation mode. A light will cause windows to help dry the windshield. Air Conditioning Control Use this...
Owner's Manual - Page 264
... carefully. Turn the ignition key briefly to run, but will continue to START position, and release it started. WARNING! If the engine fails to 15 seconds, then repeat the normal starting instructions. If the vehicle has a discharged battery, booster cables may be used to obtain a start within 15 seconds, turn the ignition switch to get it . The starter motor...
Owner's Manual - Page 277
...noticeable when Autostick is engaged. • If a downshift would cause the engine to over-speed, that mode until the powertrain cools off. • If the system detects a problem, it is safe ...This feature provides full time, on dry pavement under heavy throttle input (where one may have no driver inputs or additional driving skills required. The transaxle will stay in the manually selected ...
Owner's Manual - Page 329
...range to decrease by about 30% compared to 32°F (0°C), you will cause difficulty in cold starting and may experience an increase in your vehicle is fully warmed up. CAUTION! ...contains less energy per gallon than 85% in the time it unsuitable for your engine to be sure that your vehicle. STARTING AND OPERATING 327
STARTING The characteristics of 0°F (-18°C) to ...
Owner's Manual - Page 374
... determined not ready for testing. If you crank or start the engine, you will turn the MIL light off the message. Resolving the problem will see the MIL symbol come on as you turn the ignition key to the ON position, you will appear the next time the vehicle is ready, you can use prior to...
Similar Questions
Show How To Put In A Fuel Pump In A 08 Dodge Avenger
(Posted by deshowac 10 years ago)
Dodge Avenger 08 Panic Alarm Goes Off When Unlocking Car
(Posted by kristgaha 10 years ago)
Where Is The Fuel Pump Fuse On A 2008 Dodge Avenger
(Posted by 4tapkamug 10 years ago)
Where Is The Fuel Pump Fuse Located On 2008 Dodge Avenger
(Posted by panuzazo30 10 years ago)
We're Is The Fuel Pump Relay On 08 Dodge Avenger
(Posted by morrisryan2010 10 years ago)