Dewalt DXPW3025 Support Question
Dewalt DXPW3025 Support Question
Find answers below for this question about Dewalt DXPW3025.Need a Dewalt DXPW3025 manual? We have 1 online manual for this item!
Question posted by herbertmwebb on September 14th, 2013
I Overfilled The Pump To The Top.is The Fix Simply To Drain Oil To Properlevel?
The person who posted this question about this Dewalt product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Dewalt DXPW3025 Manual Pages
Instruction Manual - Page 2
...DXPW3025 Pressure Washer
A. Professional Spray gun D. Starter grip
J. High-pressure pump
Engine
Refer to the engine instruction manual for pressure washers is not available, an SAE 30W non-detergent oil may be used.
Frame G.
Nozzle holder C. Gas cap O. Pump
For best results, pump oil designed specifically for location and operation of other engine controls. If this oil...
Instruction Manual - Page 3
... is a registered trademarks of California to fresh air immediately. If you in minutes. See a doctor. English
Specifications
MODEL
WEIGHT
HEIGHT
WIDTH
Length
PSI**
GPM**
Engine
DXPW3025
85 lbs (38.5 kg)
22" (55.9 cm)
21" (53.3 cm)
34" (86.4 cm)
3000 (20684 kPa)
2.5 (9.5 L/min)
HONDA GX160*** 163 cc
** PSI and GPM ratings...
Instruction Manual - Page 8
... children away from
• Oil could fill the cylinder and damage the ...spray gun/wand is a powerful cleaning tool that could look like a toy to a ...173;age to prevent it
• Fuel or oil can result.
Always place pressure...position.
Serious
off valve, drain the fuel from the pressure washer at your
destination...oil leaks will cause gun/wand to ...
Instruction Manual - Page 11
... very rapidly. NOTICE: DO NOT attempt to Spray Wand Nozzles. Reduce the speed of water and a wider spray pattern.
f
3. p
e
4.
NOTE: The high-pressure pump was filled with oil at the factory to be cleaned.
2. This nozzle delivers a less powerful stream of the gasoline engine (RPM). Slow the engine down with saddle bolts...
Instruction Manual - Page 12
...: Use only soaps and chemicals designed for very intense cleaning
Surfaces*
metal or concrete; NOTE: For every 10 gallons (38 liters) of water
pumped 1 gallon (3.8 liters) of pump as flowers and shrubs. Changing Nozzles on it into the container holding chemical/
cleaning solution.
Before spraying, check the item to be used.
12...
Instruction Manual - Page 13
...overfill.
DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! Never fill fuel tank when engine is left in an effort to engine instruction manual for fuel expansion. This
could damage hose and/or pump ...of the pump can result in amputation or other serious injury.
Connect the water hose to come in enclosed, poorly ventilated areas. Check engine oil level. ...
Instruction Manual - Page 14
... to avoid
kickback and prevent hand or arm injury. Place the engine ON/OFF switch (H) to pump inlet.
Turn the water source on gun to the CLOSED position
as needed.
14. NOTICE: Risk...11. Adjust spray for the task being performed by
hand. NOTICE: Risk of pump. If engine does not start .
Note: If the oil level in the ON position.
12. Stand
on a stable surface and grip ...
Instruction Manual - Page 15
... engine contains flammable fuel. WARNING: Risk of property damage. Remove pump oil drain plug. Loosen pump oil fill plug (BB).
2. An oil designed
specifically for proper storage procedures. Pull trigger on spray gun ... any water pressure.
15 Nozzle Cleaning
If the nozzle becomes clogged with an oil drain hole to pump will result.
4. English
3. Do not smoke or work near open flames ...
Instruction Manual - Page 16
...NOTE: Do not operate pressure washer without
U
filter properly installed. Pump
The manufacturer recommends using a pump protector/ winterizer when storing the unit for storage.
sTORAGE
Engine
Consult... spray wand from the
spray wand. Y 4. Remove any obstructions with the nozzle cleaning tool (Y) provided and back flush with clean water.
5. Direct water supply into high pressure ...
Instruction Manual - Page 17
... between handle and frame when assembling to drain all water from your local dealer or authorized service center. When using replacement lances or guns with your tool, please contact the FNA Group at www...Il 60007, or call (877) FNA-GAS1.
WARNING: The use of any accessory for your tool are available for use with this pressure washer, do not use identical replacement parts.
17 danger: ...
Instruction Manual - Page 18
... in material and workmanship and not parts failure due to the end user and are hereby disclaimed and excluded by engine manufacturer warranty. High Pressure Pump (defects in material and workmanship) One (1) year from date of purchase. Frame (defects in material and workmanship) Two (2) years from date of purchase.
Warranty does...
Instruction Manual - Page 19
... carburetor choke valve. PSI: Pounds per minute.
19 Quick-connect spray wand: Allows the user to lower the temperature inside the pump. Thermal relief valve: When the temperature inside the pump rises too high the valve will then close. Chemical injection system: Mixes cleaners or cleaning solvents with the water. CU: Cleaning...
Instruction Manual - Page 20
...(refer to the NO CHOKE position.
See Spray Wand Nozzles under Operation.
20 Low oil. Pressure builds up after period of normal use .
4
Choke lever in the NO CHOKE position.
Move ...at gun/spray wand connection 25, 26 Water leaking at pump...25, 26, 27, 28 Oil leaking at pump...29, 30, 31, 32, 33, 34, 35 Pump Pulsates...12
Code 1 2 3
Troubleshooting Codes
possible cause...
Instruction Manual - Page 21
... piston. 25 Worn or broken o-ring. 26 Loose hose connection. 27 Piston packings worn. 28 Pump head or tubes damaged from the hose. Repair leak. Turn off .
See Nozzle Cleaning under Operation...if necessary. Dilute chemical. Lengthen water supply hose instead of water present, turn on to pump inlet and turn water source off the engine, then the water source. Have parts cleaned or...
Instruction Manual - Page 22
... correct amount. Clean air filter element. Check and replace. Loose drain plug.
Refer to remove any blockage. English
(Troubleshooting Codes cont.)
Code 29 30
Oil seals worn. possible cause
31 Worn drain plug o-ring 32 Worn fill plug o-ring.
33 Pump overfilled.
34 Incorrect oil used. 35 Vent plug is clogged.
36 Air filter filled with...
Instruction Manual - Page 68
...Elk Grove Village, IL 60007
(DEC11)
Part No. 7104816 r1 DXPW3025 Copyright © 2011
The following are trademarks the DeWALT Industrial Tool Co., used under license. the kit box configuration;
DeWALT®,...174; and the yellow and black color scheme are trademarks for one or more DeWALT power tools: the yellow and black color scheme; the "D" shaped air intake grill;
and the array...
Similar Questions
Pump Oil Fill Cap
I need a oil fill cap for a DEWALT Pressure washer pump.Model number: DXPW3625 Where can i please ge...
I need a oil fill cap for a DEWALT Pressure washer pump.Model number: DXPW3625 Where can i please ge...
(Posted by bben546052 1 year ago)
How Does The Pump Separate From The Engine Crank Shaft?
(Posted by peterhayles 10 years ago)
Dxpw 3025 Pump Problem
Water is shooting out of my pump relief valve. what could be the problem?
Water is shooting out of my pump relief valve. what could be the problem?
(Posted by enlighteninglad 10 years ago)