Denon DN-HC4500 Support Question
Denon DN-HC4500 Support Question
Find answers below for this question about Denon DN-HC4500 - DJ Mixer USB Controller.Need a Denon DN-HC4500 manual? We have 1 online manual for this item!
Question posted by ossiebeng on April 12th, 2014
How To Reset Deondra275r
my receiver went dead.how do i reset it?
Current Answers
Related Denon DN-HC4500 Manual Pages
Operating Instructions - Page 2
... when the apparatus has been damaged in any interference received, including interference that produce heat. 9. The exclamation ...registers, stoves,
or other . NO USER-SERVICEABLE PARTS INSIDE.
DN-HC4500 Serial No. Operation is damaged or deformed, it is subject to...Interference-Causing Equipment Regulations. CAUTION:
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER ...
Operating Instructions - Page 5
... owners are welcome to enjoy all DENON Mixers
2 X-Control When the DN-HC4500 is its own internal power supply to rewire a thing in addition to the main unit:
q Audio cord 2 w USB cable 1
e Operating instructions 1 r CD-ROM 1
1 FEATURES
2 Internal 24-Bit Processing & USB Audio Unlike most powerful and flexible DJ hardware controller on valuable user feedback. These new Plug...
Operating Instructions - Page 6
... to use the included USB cable.
2
ENGLISH
Found New Hardware USB audio device
Once installation is completed, the message "Your new hardware is installed and ready to a Macintosh computer
• The DN-HC4500 is displayed, as shown below appears at the bottom right of cable may operate erratically after connected to your mixer. is plug-and...
Operating Instructions - Page 7
.... CAUTION: Note that offers X-Control.
• With the DN-HC4500 it from a PC. The ...DN-HC4500's AC inlet terminal. r POWER button
• Push this button to a computer. • Sends the USB MIDI and HID commands
from the DN-HC4500. • Sends the USB audio signals from the USB...mixer has the Fader Start function. o FLIP/B TRIM
[When PCDJ connected] Refer to the PCDJ's manual.
[When DN...
Operating Instructions - Page 8
...Loop and Stutter.
!4 CONT./SINGLE, RELAY
[When PCDJ connected] Refer to the PCDJ's manual.
[When DN-D4500 connected] • CONT./SINGLE:
A short tap of these buttons is pressed and held in, ... for more than 1 sec to select the pitch range.
@3 Pitch Slider
[When PCDJ connected], [When DN-D4500 connected] • Use this slider to adjust playing speed. • The playing speed decreases when ...
Operating Instructions - Page 9
... key adjust mode. is displayed and source
3 switching is controlling the DJ software on a PC/MAC. indicator
• "KEY ADJ...USB audio signals from a computer. T.ELAPSED: The playing time from the beginning of that is currently playing or set .
t External device connection confirmation indicator
• This lights when MIDI signals have been sent or received between the DN-HC4500...
Operating Instructions - Page 10
...PLAY/PAUSE button is also called Back-Cue.
The current pitch setting is pushed during play
When the DN-D4000/D4500/BU4500's
1
"Power On Play" presetting is cancelled. Select the File
• Turn ...manual of the PLAY/PAUSE button switches between playback and pause. Power on play , the DN-D4500 pauses playback at that point.
Pitch Bend
With PITCH BEND function you started from the...
Operating Instructions - Page 11
... to B looping, B
4
point for A2 ignored.
• When the B point for A2 is detected
after playback started from or return to A2 point with
seamless. DN-D4000/D4500/BU4500 continues
playback after EXIT playback, the B point moves to exit from the A point. t To enable stutter
6 playback, push FLIP
button for Stutter...
Operating Instructions - Page 12
...of the model to be changed , "Audio Fs Sel" is displayed on the character...DN-HC4500 uses unique MIDI specifications.
(2) CD Model Sel: DN-D4500* / DN-D4000 Select the name of the jog wheel.
(7) FaderIn Mode: 1-PLAY/CUE / 2-PLAY / CUE
(8) X-CONT XFD: OFF / ON* Sets whether to enable or disable X-control... value.
(1) USB Mode Sel: HC4500 MIDI* Selects the USB communications mode. Preset...
Operating Instructions - Page 13
... to be selected.
Press the "Close" button.
7 5
Diagram: Confirm Installation window
Diagram: Installation Complete window
2 Uninstalling Uninstall at the "Add or Remove Programs" control panel.
9
ENGLISH ENGLISH
9 ASIO CONTROL PANEL (Windows version only)
Installing the ASIO driver
Double-click the installer. Choose "Everyone" if "everyone" uses the computer on the desktop, check...
Operating Instructions - Page 14
... compatible DENON DJ devices is displayed automatically. (Example: DN-HC4500-1) • Select the device to the settings.
10
ENGLISH
NOTE: • The range of values is compatible are activated, the
settings of the ASIO device specifications device switches between enabled and disabled. e Audio Buffer Size
Use this button to close the ASIO control panel without...
Operating Instructions - Page 15
...the installer.
Press the "Close" button.
7 5
Diagram: Confirm Installation window
Diagram: Installation Complete window
2 Uninstalling (Windows version only) Uninstall at the "Add or Remove Programs" control panel. Check www.denondj.com for verifying the folder in "C\Program Files\DENON_DJ\DDJUpdater\DNHC4500\". Diagram: Installing window
This window is displayed when installation is...
Operating Instructions - Page 16
...device name is displayed.
12
ENGLISH Press the Load button to the "DENON DJ Upgrade program" screen.
The following appears on the device's panel display:
...can now be pressed). ENGLISH
Updating procedure
1 Connect the computer by USB cable. The following appears on the power in the update mode.... Launch the DN-HC4500 update program. If the update file has not been loaded, "...
Operating Instructions - Page 18
mode
Message type
Note ON/OFF
38 Jogwheel fwd/rev
39 X-Control fader
40
Parameters KNOB Increment/Decrement
41 Pitch Slider
n = MIDI CH
14
...; relative data 0x00 (min) → 0x7F (max) Increment : 0x00 Decrement : 0x7F
0xmmh (MSB)
Message type Note ON/OFF
≠
Control change
≠ ≠ Pitch bend change
-100% : 0x7F7F (MSB/LSB) 0% : 0x4000 (MSB/LSB)
+100% : 0x0000 (MSB/...
Operating Instructions - Page 19
...)
0x3B 0x3C 0x3D
34 Scratch Position 5
DN-HC4500 return pitch slider position
DN-HC4500 return X-
35 Scratch Position 6 36 Scratch Position 7
Control fader position
15
only Use 0x4D/0x4E only...Control Change ENGLISH
Data reception
VFD symbol data reception The various VFD symbols can be set to on , off or blinking, as per the table below .
2 Receive command for VFD Symbol
2 Receive...
Operating Instructions - Page 20
... 0x33 0x34 0x35 0x36 0x37 0x38 0x39 0x3A 0x3B 0x3C 0x3D 0x3E 0x3F 0x40 0x41
Message type Control Change
n = MIDI CH
✽ "Track Position Blink" sets blinking of the entire track position... The time-related display and segment display can be set by MIDI command, as per the table below.
2 Receive command for VFD Parameter
Items
VFD Parameter
1 Tr number MSB
2 Tr number LSB 3 Time mini 4 Time ...
Operating Instructions - Page 21
... 0x12 0x13 0x14 0x15 0x16 0x17 0x18 0x19 0x2E 0x2F 0x30 0x31 0x32 0x33 0x34 0x35 0x36 0x37 0x38 0x39
Value
0x00 ~ 0x0F
Message Type
Control Change
VFD segment data reception The various segments are set by 2-byte data, as per the following font code. (0x00/0x00 to 0x00/0x07 cannot...
Operating Instructions - Page 22
... Sel
Item USB Control mode select Drive control model select Audio sampling frequency select
Unit number Set MIDI CH Set JOG Pulse Sel Fader In Mode Xcont XFD Audio buffer Model code
Unit number MIDI CH JOG count number per cycle Fader In mode select X-control mode select Audio buffer size Model number
Data
0x00: HC4500 MIDI, 0x02...
Operating Instructions - Page 23
... table
Preset name
USB mode Sel CD Model Sel Audio Fs Sel
Item
USB Control mode select Drive control model select Audio sampling frequency select
JOG Pulse Sel Fader In Mode Xcont XFD
JOG count number per cycle Fader In mode select X-control mode select
Data
0x00: HC4500 MIDI, 0x02 to 0x0F: Reserve 0x00: DN-D4500, 0x01: DN-D4000 0x01...
Operating Instructions - Page 24
... dBV (TYP)
Less than -110 dB (TYP @1 kHz)
2 USB I/F USB B connector:
USB2.0 (Max480 Mbps) PC/MAC (Host) ¤ DN-HC4500 (Slave) application
USB Audio (Speaker) PCM 16bit/24bit 44.1 kHz/48 kHz/96 kHz 4ch
USB MIDI I/O IN: 1 port, OUT: 1 port
USB HID I/O (General) 32Byte packet
2 Control I/F Fader start:
X-CONTROL: CD Drive control:
FADER 1 3.5 mm stereo mini jack (Tip/Ring:signal...
Similar Questions
Wiring Diagram For The Plug That Goes Into The Mixer .
I am wondering if it's possible to wire a plug up that would do the job of the original cord I have ...
I am wondering if it's possible to wire a plug up that would do the job of the original cord I have ...
(Posted by peteanthony9 5 years ago)
How To Stream Tv Audio (klv32ex300 Sony) Thro Hdmi Cable Connected To Denon 1611
(Posted by narentexho 9 years ago)
I Need A Power Supply For A Denon Dx 100 Mixer
(Posted by swanso56 12 years ago)
Why My Controller Wont Come On
I was on a gig and the dn-hc1000s just stop working and i need to get so insight on what to do. I re...
I was on a gig and the dn-hc1000s just stop working and i need to get so insight on what to do. I re...
(Posted by djruckshun 13 years ago)
How Can I Make My Dn-hc-1000s Stop Freezing Virtual Dj 6.0.8?
I LOVE my new DN-HC1000s. But when I scratch or loop too long... virtual DJ stops responding but mus...
I LOVE my new DN-HC1000s. But when I scratch or loop too long... virtual DJ stops responding but mus...
(Posted by stretchcs14 13 years ago)