Dell OptiPlex 7010 Support Question
Find answers below for this question about Dell OptiPlex 7010.Need a Dell OptiPlex 7010 manual? We have 6 online manuals for this item!
Question posted by wilsolow on July 14th, 2014
How To Enable Wol On Dell Optiplex 7010
Current Answers
Answer #1: Posted by DellJesse1 on July 15th, 2014 7:06 AM
Start the computer and TAP the F2 key to enter system setup. Tab or arrow over to the power management tab.You will then see where to enable WOL.
This option allows the computer to power up from the off state when triggered by a special LAN signal. Wake-up from the Standby state is unaffected by this setting and must be enabled in the operating system. This feature only works when the computer is connected to AC.
- Disabled - Do not allow the system to power on by special LAN signals when it receives a wakeup signal from the LAN or wireless LAN.
- LAN Only - Allow the system to be powered on by special LAN signals.
This option is Disabled by default
Thank You,
Dell-Jesse1
Dell Social Media and Communities
email:[email protected]
Dell Community Forum.
www.en.community.dell.com
Dell Twitter Support
@dellcares
Dell Facebook Support
www.facebook.com/dell
#iwork4dell
Related Dell OptiPlex 7010 Manual Pages
Similar Questions
Can you help me to retrieve the dell drivers for the SM Bus Controller of a Dell Optiplex 7010 pleas...
any instructions on how to hook up 2 monitors on the optiplex 7010 ??? thx
vmware s/w is must to install multi monitors through one cpu but i did not get its cd how i install ...