Cub Cadet LGTX 1054 Support Question
Cub Cadet LGTX 1054 Support Question
Find answers below for this question about Cub Cadet LGTX 1054.Need a Cub Cadet LGTX 1054 manual? We have 3 online manuals for this item!
Question posted by stimm01 on June 3rd, 2018
No Drive Forward Or Reverse
2013 lgtx 1054 barely climbs a slight incline with or without pto mower engaged??even at full throttle.!i'm open to suggestions. thanks
Current Answers
Answer #1: Posted by Odin on June 3rd, 2018 5:49 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
The spark plugs' gap is insufficient. Remove the spark plug(s) and reset the gap.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Cub Cadet LGTX 1054 Manual Pages
Series 1000 Brochure - Page 1
... and PTO start sequence LEDs
Neutral start, operator presence, reverse safety switch, brake pedal lock, RevTEK™ reverse mowing technology
OPERATION PTO Clutch Deck Lift Brakes Seat
Electronic fingertip engagement for ... 2013 Cub Cadet
Lawn and garden tractors
SERIES 1000
LTX 1040 LTX 1042 KW LTX 1045 LTX 1046 LTX 1046 KW LTX 1050 LTX 1050 KW LGT 1050 LGT 1054 LGTX 1050 LGTX 1054 GTX 1054
...
Series 1000 Brochure - Page 2
..., lawn sweeper, steel cart, poly cart, lawn dethatcher, lawn spike and plug aerator, lawn roller...PTO Clutch Deck Lift Brakes
Seat
ADDITIONAL SPECIFICATIONS Front Tires Rear Tires Forward Speed Reverse Speed Fuel Tank Capacity Engine Oil Capacity Transmission Oil Capacity Wheelbase Overall Length Estimated Weight w/Deck
MOWer DECK Cutting Width/Blades Deck Cutting Height deck Construction Deck Drive...
LGT 1050 Operator's Manual - Page 1
... INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Hydrostatic Lawn Tractor -
LGT 1050 Operator's Manual - Page 4
... Read, understand 5.
loaded dump cart, lawn roller, etc.) on wet grass. 12... of alcohol or drugs.
16. Rapid engagement or braking could cause the front of...remove key before driving under the influence of riding mower-related
injuries. Your...hanging tree branches, wires, door openings etc.,
7. All slopes require ...:
pedal completely and shift into reverse. Contact your foot on ramp(s)...
LGT 1050 Operator's Manual - Page 5
...can occur if the operator is spilled, wipe it on mower). Extinguish all cigarettes, cigars, pipes and other debris build... gasoline cap and tighten securely.
l. General Service
1. Never run into Reverse. Section 2 - Never carry children, even with a plastic liner. When... 14 years of the fuel tank or container opening at least two minutes before shifting into the path...
LGT 1050 Operator's Manual - Page 9
... operate the riding mower without first opening the hydrostatic relief valve. Doing so will NOT engage when the hydrostatic bypass rod is pulled out. Figure 3-1
2. To open the hydrostatic relief ... of the tractor. Assembly & Set-Up
3
Contents of Crate
• One Lawn Tractor
•
• One Lawn Tractor Operator's Manual •
One Oil Drain Tube One Engine Operator's Manual
...
LGT 1050 Operator's Manual - Page 11
... tractor. Use extreme care when handling gasoline. Do NOT top off the tank. Slide the seat forward or rearward to STOP filling tank once fuel is engaged in the engine. Do not overfill the tank. Gasoline is shipped with oil in the seat-stop...Kawasaki Owner's Manual. Adjusting the Seat
To adjust the position of ignition. See Figure 3-6. Figure 3-5 WARNING! Engage the parking brake.
LGT 1050 Operator's Manual - Page 12
... Features
4
Fuel Tank Cap
Systems Indicator Monitor
Ignition Switch Module
Throttle/Choke Control Fuel Level Indicator
Brake Pedal Cargo Net
Seat Adjustment Lever
Parking Brake/ Cruise Control Lever
Electric PTO Knob
Drive Pedal Reverse Pedal Deck Lift Lever
Storage Bin
Cup Holder
Figure 4-1
Lawn Tractor controls and features are applicable to your tractor. NOTE: Your...
LGT 1050 Operator's Manual - Page 13
... board.
Reverse Pedal
The reverse pedal is located on the right side of the tractor along the running board. The further downward the pedal is also controlled with the drive pedal.
Cargo Net
The cargo net is located on its original position when it illuminate's during this maintenance interval.
PTO (Blade Engage)
If the PTO light...
LGT 1050 Operator's Manual - Page 15
... control from cranking or starting .
15 Doing so will automatically shut off if the PTO (Blade Engage) knob is moved into the engaged (ON) position with the drive pedal in position for reverse travel. Place the throttle/choke control lever near the SLOW position.
3. If the interlock system should ever malfunction, do not operate the tractor...
LGT 1050 Operator's Manual - Page 16
..., do not force the steering wheel to maneuver in reverse is always in the FAST (rabbit)
NOTE: Mowing in reverse with the cutting blades (PTO) engaged. 5. Turn the key from forward to shortened battery life, and poor cut quality.
2.
Drive Pedal Reverse Pedal
Indicator Light
Stop Position
Reverse Push Button
Reverse Caution Mode
Position
Figure 5-1
3.
CAUTION: Do NOT attempt...
LGT 1050 Operator's Manual - Page 17
... same forward speed. To set parking brake, stop engine and remove key to prevent unintended starting. Section 5 -
Press the brake pedal completely down position and the tractor will automatically shut off.
After completing step 3, the drive pedal should remain in the down with a slope in reverse. If it doesn't, the parking brake is engaged...
LGT 1050 Operator's Manual - Page 18
...Short grass is recommended that the throttle/choke control is designed to mow...reverse the direction to throw the discharge to ensure proper charge on the battery.
• For best results it is installed.
• Do not cut the grass too short. This will be certain that the first two laps be cut quality.
2. Plan your tractor. To engage the PTO:
1. Engaging the PTO
Engaging the PTO...
LGT 1050 Operator's Manual - Page 20
... changed.
Battery
CALIFORNIA PROPOSITION 65 WARNING!
Drive the tractor to keep the battery cables...the gap reset once a season.
reversing them could result in the Engine Owner...part of California to your lawn, near enough for correct plug... alternating system. Disengage the PTO (Blade Engage), set the parking brake and...the drain port. 7. Pop open the protective cap on any other...
LGT 1050 Operator's Manual - Page 21
... 6 - Lubrication
WARNING! While sitting in the operator's position on the drive system, parking brake and lift linkage at least once a season with light... points on the tractor, start the engine and place the throttle lever in the operator's position with the Smart Jet system,...the cutting deck to the operator's position and engage the PTO.
Turn the ignition key to the STOP position...
LGT 1050 Operator's Manual - Page 24
... idler bracket and pivot it to be easily removed from the electric PTO clutch, carefully insert a 3⁄8" drive ratchet wrench (set to relieve tension on the belt. Insert Ratchet... the square hole found in the disengaged (OFF)
position and engage the parking brake. 2.
Place the PTO/Blade Engage knob in the left side of the deck.
24 LocatethePTOclutchunderthefrontofyourtractor.SeeFigure...
LGT 1050 Operator's Manual - Page 26
... servicing, repairing, or inspecting, always disengage PTO, set parking brake, stop engine and remove..., disconnect the NEGATIVE (Black) wire from an open flame or pilot light as the blown fuse.
... assure a good connection.
Charge the battery in reverse order of the blade marked ''Bottom'' (or ...is in it) facing the ground when the mower is located under the hood, mounted behind the...
LGT 1050 Operator's Manual - Page 27
... tools used in serious damage to your Cub Cadet dealer to engage and disengage safely.
To change the tractor's transmission drive belt. the deck belt on the sidewall of the deck. Reinstall... Uneven tire pressure could cause the cutting deck to change or replace
6. See your tractor's PTO system.Remount the belt guards removed earlier.
8. Changing the Deck Belt
WARNING! All belts on...
LGT 1050 Operator's Manual - Page 29
... PTO/Blade Engage knob engaged. 2. Spark plug wire(s) disconnected. 4. Throttle ...Mower will not mulch grass
1. Cutting blade loose or unbalanced. 2. Damaged or bent cutting blade. 1. Wet grass. 3. Excessively high grass.
Dull blade. 3.
Engage parking brake. 3. Connect wire(s) to FAST position.
5. Place throttle lever to spark plug(s). 4. Fill tank with throttle...
LGT 1050 Operator's Manual - Page 30
... Air Filter and Pre-cleaner
KH-12-050-01-S Oil Filter KH-25-050-22-S1 Fuel Filter
954-04077 954-0642
Deck Drive Belt (50" Deck) Deck Drive Belt (54" Deck)
942-04053C 942-04053C-X 942-0677B 942-0677B-X
2-in-1 Deck Blade (50" Deck) Extreme Deck Blade (50" Deck) 2-in-1 Deck...
Similar Questions
Where Does The Spring Go On The Clutch In The Front Crossbar?
(Posted by tesahope55 9 months ago)
Cub-cadet-cc30e-lawn-mower
cub-cadet-cc30e-lawn-mower won`t just beeps after inserting the key. The battery fully charged
cub-cadet-cc30e-lawn-mower won`t just beeps after inserting the key. The battery fully charged
(Posted by paulross 1 year ago)
Cub Cadet Lgtx 1054 Power Steering Jerks To The Left.
All of sudden the power steering wants to jerk to the left and sometimes goes all the way to the lef...
All of sudden the power steering wants to jerk to the left and sometimes goes all the way to the lef...
(Posted by shotgun16ga 2 years ago)
Lawn Mower Not Starting.
Our lawn mower will not start. We replaced battery and now it acts like it wants to crank but won't....
Our lawn mower will not start. We replaced battery and now it acts like it wants to crank but won't....
(Posted by TDivens1972 6 years ago)
My Power Steering On My Cub Cadet Lgtx 1054 Quit. Need To Get Information On How
need information on how to fix power steeringand/or purchase a service manual
need information on how to fix power steeringand/or purchase a service manual
(Posted by Terryloy 6 years ago)