Cub Cadet BC 509 Support Question
Cub Cadet BC 509 Support Question
Find answers below for this question about Cub Cadet BC 509.Need a Cub Cadet BC 509 manual? We have 3 online manuals for this item!
Question posted by Anonymous-137314 on May 29th, 2014
Should The Bolt At The Bottom Of The String Holder Move
need to put in new string cannot access spool, bolt does not loosen
Current Answers
Related Cub Cadet BC 509 Manual Pages
Cultivator Warranty Information - Page 1
...1238 in the following cases: A. Wear items - Bump Knobs, Outer Spools, Cutting Line, Inner Reels, Starter Pulley, Starter Ropes, Drive Belts... Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or...by Cub Cadet LLC (Cub Cadet) with respect to new merchandise purchased and used for rental or commercial purposes,...
Handheld Blowers Brochure - Page 1
All while enjoying your perfectly manicured lawn.
STARTING MADE EASY
There's no need to struggle with a cord every time you 'll have less prep time and more fuel efficiency. BC210 BC509
Designed for trimming and cutting of yard ...
Handheld Blowers Brochure - Page 2
... on the machine. handheld
equipment
SPECIFICATIONS Engine Power Start Optional Crankshaft Shaft Attachment Capable Cutting Swath Line Diameter Handle
Feed Head
Hour Rating Warranty†
string trimmers
CS202
SS418
ST228
25cc, 2-cycle
29cc, 4-cycle
27cc PRO, 2-cycle
No
No
Yes
Half-crank
Half-crank
Full-crank
Curved, Steel
Straight, Steel
Straight...
BC 509 Operator's Manual - Page 1
...Instructions to Assemble Straight Shaft String Trimmers
For complete instructions, ...
Operator's Manual
Read and understand all instruction, warning and danger labels on into spool. Push the bottom add-on the unit.
Pull tight. Tighten the screws with... Remove the oil fill plug from the boom.
Page 13
NEED HELP?
Español - Choke Lever
Continue to squeeze throttle control and move choke...
BC 509 Operator's Manual - Page 2
...can cause injury while it returns automatically to yourself and others . Always loosen the fuel tank cap slowly to another. • If you have difficulty...extended, and the proper line installed. Use a full face shield when needed to the operator and/or bystanders. All U.S. DANGER: Failure to ...bolts or damage before repairing damage. Failure to do not cut , trim or ...
BC 509 Operator's Manual - Page 3
... Place it was pre-installed, loosen the screws on the output shaft with one 3.04 fluid oz. (90 ml) bottle of gasoline and oxygenates such as needed . Screw (4) D-Handle
3. ... turn counterclockwise (Fig. 10).
9.
Fig. 1
6. Pull tab to lengthen, pull strap to loosen (Fig. 15).
2. Store the cutting attachment for the cutting attachment to measure the correct amount during...
BC 509 Operator's Manual - Page 4
...accessories.)
STARTING INSTRUCTIONS 1.
At full throttle the blade has
maximum cutting power and is no need to page 10 of the unit. To avoid serious personal injury, turn off while in ...of the Electric Starter or Power Start Bit™ operator's manual. 6. This can occur without the need to full throttle before starting position (Fig. 22). Replace the blade.
• Cut at the ...
BC 509 Operator's Manual - Page 5
... 29
the line through one of the two holes in the outer spool (Fig. 34).
6.
INSTALLING A PREWOUND REEL
1. Inspect the bolt inside , in the direction indicated on the air filter cover (Fig...maintenance procedures may spin during idle speed adjustments.
Insert the end of new
trimming line, loop it run at a time (as needed), to wind the line in the slot on the inner reel. ...
BC 509 Operator's Manual - Page 6
...inner reel
Cutting head dirty
Clean inner reel and outer spool
Line welded
Disassemble, remove the welded section and rewind
Line...air gap at any time without binding. tighten loose screws, nuts or bolts.
Short Term Storage (1-2 weeks) 1. Do not use strong detergents. ... Old fuel (over 30 days) Cutting attachment bound with new line
Inner reel bound up the unit to Position 3.
We...
Similar Questions
How To Loosen Bolt On String Cap To Replace With Different Cap
(Posted by justindrzymalla 8 years ago)
Changing String
I'm trying to change the string in my cub cadet ss470. How do I remove the string that's still left ...
I'm trying to change the string in my cub cadet ss470. How do I remove the string that's still left ...
(Posted by sethheaton 8 years ago)
String Throttle Dies Down
My string doesn't cut as fast when I hit grass with the string. Throttle isn't as strong
My string doesn't cut as fast when I hit grass with the string. Throttle isn't as strong
(Posted by Sandlot89 8 years ago)
Adding New String To Cub Cadet Cs202
How do you put new string into Cub Cadet CS202
How do you put new string into Cub Cadet CS202
(Posted by bchums 10 years ago)