Craftsman Mower 50 Support Question
Craftsman Mower 50 Support Question
Find answers below for this question about Craftsman Mower 50 - 21" Front Wheel Drive Limited Edition State Model.Need a Craftsman Mower 50 manual? We have 1 online manual for this item!
Question posted by Anonymous-108907 on April 24th, 2013
Craftsman Zts 7500 With 24 Hp Briggs And Stratton
Mower starts fine but dies when you move contro arms to the run postion
Current Answers
Related Craftsman Mower 50 Manual Pages
Owners Manual - Page 1
Visit our Craftsman website: www.sears.com/craftsman Owner's Manual
ROTARY LAWN MOWER
6.5 Horsepower 21" Rear Discharge
Model No. 917.38885
CAUTION:
Read and follow all Safety Rules and Instructions before operating this equipment Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
Owners Manual - Page 2
...
LIMITED TWO YEAR WARRANTY ON CRAFTSMAN POWER MOWER
For two years from date of purchase, when this Craftsman Lawn Mower is maintained, lubricated, and tuned up , trans-
BECOME ALERT!!!
cidental starting ...contained in con-
shafts and the failure to maintain the equipment according to the State
YOUR SAFETY IS INVOLVED. porting, adjusting or making repairs,
CAUTION: Muffler...
Owners Manual - Page 3
... with
the engine running. SLOPE OPERATION
Slopes...operate the machine while under the in handling gasoline. If the equipment should start to cool before removing grass catcher.
All slopes require extra caution. If ... pilot light such as rocks,
when changing direction on mowers so equipped before mowing.
drives, walks, or roads.
• Never allow responsible individuals, who
II...
Owners Manual - Page 4
...SERVICE
• Never run a machine inside a vehicle, on a truck or trailer bed with safety devices. WARNING: This lawn mower is equipped with a spark arrester meeting applicable local or state laws (if any ...you strike an object.
In the state of the California Public Resources Code). Federal laws apply on the ground. lbs.
• The model and serial numbers will be maintained...
Owners Manual - Page 5
...or schedule a service appointment online. ACCESSORIES
These accessories were available when this lawn mower was produced. Purchase a Repair Protection Agreement now and protect yourself from ...lawn mower.
5 Your new Craftsman® product is all products, it takes for years to your covered
product can save you purchase the Agreement, a simple phone call 1-800-827-6655. Some limitations...
Owners Manual - Page 6
... for additional loose parts.
Remove all
parts and hardware you attempt to "ADJUST HANDLE" in the parts bag. Frame handle
HOW TO SET UP YOUR LAWN MOWER
TO UNFOLD HANDLE
IMPORTANT: Unfold handle carefully so as not to upper handle.
4.
per handle section into place in warm water for your...
Owners Manual - Page 7
... reference. pumps additional fuel from the
be held down to the handle to start the
carburetor to stop the engine.
OPERATION
KNOW YOUR LAWN MOWER
READ THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERATING YOUR LAWN MOWER.
These symbols may appear on each wheel)
IMPORTANT: This lawn mower is running. Release to the cylinder for use when
engine.
Owners Manual - Page 8
...propped open.
Do not under lawn mower handle. 3. CAUTION: Do not run your lawn mower or performing any circumstances attempt to defeat the function of the lawn mower and
place the grass catcher ...damage. TO ADJUST CUTTING HEIGHT
Raise wheels for low cut and lower wheels for high cut, adjust cutting height to start and operate the lawn mower.
it will cause unnecessary wear....
Owners Manual - Page 9
... Engine oil cap
• Change the oil after fill- ATTACH FUEL CAP CARTRIDGE Your mower is level. 2.
ing tank with gasoline.
Hold operator presence control bar down the oil fi... is not usually necessary when starting an engine which leads to bottom of oil with oil, or it may need to start the engine and let it run for additional information. used within...
Owners Manual - Page 10
... be necessary to raise the height of built-up grass and trash. When doing a second cut, mow across (perpendicular) to reduce ground speed and/or run the lawn mower over the area a second time.
• For extremely heavy cutting, reduce the width of cut by overlapping previously cut to reduce pushing effort and...
Owners Manual - Page 11
...operator abuse or negligence. And after each wheel)
➁ Engine oil
At least once a season, check to properly maintain your engine run better and last longer. • ... for Loose Fasteners Clean / Inspect Grass Catcher * Check Tires Check Drive Wheels *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean ...
Owners Manual - Page 12
...drive a nail into
SAE VISCOSITY GRADES
blade adapter and crankshaft.
4. LAWN MOWER
Always observe safety rules when performing any maintenance. BLADE CARE
For best results, mower blade must be sharpened with plug.
If either end of the nail. Give the lawn mower model number when ordering. Use block of this manual. Position blade on a grinding wheel... improve starting the ...
Owners Manual - Page 13
...run properly and may cause deterioration of engine. If very dirty, replace cartridge.
• Keep finished surfaces and wheels free of operation, whichever occurs first. CLEANING
fler on a clean surface. 3. mower...section of built-grass
before starting engine. lay aside on startup. TO CHANGE ENGINE OIL
NOTE: Before tipping lawn mower to clean cartridge.
They ...
Owners Manual - Page 14
...Hairpin cotter
for repair and/or adjustment. Your carburetor is running too fast or too slow, take your mower, is factory set . LAWN MOWER
TO ADJUST CUTTING HEIGHT See "TO ADJUST CUTTING HEIGHT" in...
LOW POSITION
HIGH POSITION
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of this manual.
Do not attempt to increase engine speed or it should be mounted ...
Owners Manual - Page 15
... manual. 3.
Touch up your handle from forming in storage.
• Empty the fuel tank by starting the engine and letting it thoroughly, remove all dirt, grease, leaves, etc. Acidic gas can fold your lawn mower handle for storage. 1. Run engine at the end of the lower
handle toward each other until the fuel lines...
Owners Manual - Page 16
...lter. 2. Connect wire to
distribute oil. 4. Do not use plastic. PROBLEM
CAUSE
CORRECTION
Does not start
1. Dirty air filter. 2. Control bar defective. 10. Empty fuel tank and refi...another.
• Replace your gasoline can if your can starts to cool before storing in fuel.
5.
CAUTION: Never store the lawn mower with clean engine oil. (See "ENGINE" in the ...
Owners Manual - Page 17
... venting air.
1. Clean underside of lawn mower housing one (1) setting higher.
3. Move lawn mower to push
1. Lift on 1.
Raise cutting height.
2. Blade dragging in grass.
3. TROUBLESHOOTING - Cutting too much oil in engine. 6. Buildup of lawn mower housing or cutting blade dragging in grass.
4. Walking speed too fast.
1. Set all wheels at slower walking speed. Bent...
Owners Manual - Page 18
of home appliances and items like vacuums, lawn equipment, and electronics, call or go on a product serviced by Sears:
1-800-827-6655 (U.S.A.)
1-...Servicio de Sears, Roebuck and Co.
Your Home
For repair - For Sears professional installation of all major brand appliances, lawn and garden equipment, or heating and cooling systems,
no matter who made it, no matter who sold it!
Get it...
Similar Questions
What Is The Equivalent Of The Craftsman 91727240 Model
manufactured in 1999 I believe. Also, how many years was that model sold? do you know what the price...
manufactured in 1999 I believe. Also, how many years was that model sold? do you know what the price...
(Posted by allmeansall 6 years ago)
How Do I Install Armature-magneto, And Gap Correctly, 675 Briggs & Stratton Eng.
not getting any spark and i'm not sure i am installing it correctly.
not getting any spark and i'm not sure i am installing it correctly.
(Posted by dhowze1928 9 years ago)
Craftsman Zts 7500 Riding Mower Dies When Arms Are Engaged
had company put new valves in motor and now it dies when arms are ingaged
had company put new valves in motor and now it dies when arms are ingaged
(Posted by dlakes1 10 years ago)
Has Anyone Reinstalled The Mower Onto The Craftsman 24 Hp 42' Mower After A Plow
I installed the plow onto my Craftsman 24HP 42" mower for the winter months. Now that I am reinstall...
I installed the plow onto my Craftsman 24HP 42" mower for the winter months. Now that I am reinstall...
(Posted by dasehome 11 years ago)
Drive Problem
with engine at full throttle , when trying to go slow around objects, my ZTS 7500 (model 107.27768) ...
with engine at full throttle , when trying to go slow around objects, my ZTS 7500 (model 107.27768) ...
(Posted by larryt41102 11 years ago)