Craftsman 28928 Support Question
Craftsman 28928 Support Question
Find answers below for this question about Craftsman 28928 - YT 4000 24hp 46" Yard Tractor.Need a Craftsman 28928 manual? We have 1 online manual for this item!
Question posted by ndemarco on April 21st, 2012
How Do You Replace Mower Deck Clutch Cable
The person who posted this question about this Craftsman product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Craftsman 28928 Manual Pages
Operation Manual - Page 2
...
Sears Service Back Cover
Craftsman Riding Equipment Warranty: Lawn Tractors, Garden Tractors, Zero Turn Riders
CRAFTSMAN TWO YEAR FULL WARRANTY
...amount of engine oil, failure to keep the deck clear of operator negligence, including but not limited ...spark plugs, air cleaners, belts, and oil filters. Tire replacement or repair caused by fuel determined to state.
Warranty coverage does...
Operation Manual - Page 5
...the engine running. • Check grass catcher components and the discharge guard frequently and replace with the
blades shut off. Repair, if necessary, before
storing. • If ..., even with manufacturer's recommended parts, when necessary. • Mower blades are sharp. Adjust and service as required. • Maintain or replace safety and instruction labels, as necessary.
• Be sure ...
Operation Manual - Page 8
... were overinflated
at the factory).
/ Be sure mower deck is in "transmission
engaged"
position (see that all belt keepers.
/ Check wiring.
Follow proper starting , read, understand and follow . Be sure tractor is properly
prepared
and
charged. TO ROLL TRACTOR OFF SKID (See Operation section for replacing motion and mower blade drive belts in the Service and...
Operation Manual - Page 9
...hazard which can result in serious injury or death. These symbols may appear on your tractor or in death or serious injury.
CAUTION when used to follow instructions could result ...START
PARKING BRAKE
MOWER HEIGHT
MOWER LIFT
LIGHTS ON
FUEL
t
BATTERY
REVERSE
FORWARD
CRUISE CONTROL
CLUTCH/BRAKE PEDAL
@@®@@
ATTACHMENT CLUTCH DISENGAGED
ATTACHMENT CLUTCH ENGAGED
DANGER, ...
Operation Manual - Page 10
...SYSTEM (ROS) "ON" POSITION - Indicates when service is required for future reference. Used for forward movement of tractor.
(M) FREEWHEEL CONTROL - Disengages transmission for starting and controlling engine
speed.
(E) ATTACHMENT CLUTCH LEVER - Allows operation of mower or other at desired
speed without holding the forward drive pedal. (K) FORWARD DRIVE PEDAL - Turns the headlights...
Operation Manual - Page 11
... leaving the operator's position. NOTE: Under certain conditions when
tractor is controlled by the operator to move at-
To stop mower blades, move throttle control
between half and full speed (fast) position. tachment clutch lever in severe eye damage. Always remove key when leaving tractor to prevent unauthorized use.
• Never use choke (N) to...
Operation Manual - Page 12
... and the attachment clutch engaged will shut off the ground when mower is approximately 1" to help prevent scalping in the seat to disengage. NOTE: Adjust gauge wheels with tractor on forward drive pedal. TO OPERATE MOWER
• Put attachment lift lever in desired height of grass being mowed. • The average lawn should be used...
Operation Manual - Page 13
....
_,CAUTION"
Do not operate the mower
without either the entire grass catcher, on a truck or a trailer, be
sure to disengage transmission by the operator to travel in the reverse direc- tachment clutch engaged while mowing is held in the
disengaged position. • Do not push or tow tractor
two (2) MPH. • To re...
Operation Manual - Page 14
...STARTING THE ENGINE
CHECK ENGINE OIL LEVEL
The engine in quantities that the engine or mower needs
servicing. If necessary,
3. NOTE: Before starting the engine for one minute using...°
not overfill. Acidic gas can lose traction with tractor on dipstick is dangerous. Sit on a slope, is reached. Move attachment clutch to choke position. ADD GASOLINE • Fill fuel tank ...
Operation Manual - Page 17
...Check for Loose Fasteners
C Check/Replace Mower Blades T Lubrication Chart
0 Check Battery Level
R Clean Battery and Terminals
V'3
Check Transaxle Cooling
Check Mower Levelness
Check V-Belts
,_heck Engine Oil Level
v'
Dhange Engine Oil (with maintenance-free battery. Check brake operation. 3. Replace blades more often when operating in this tractor does not cover items that will...
Operation Manual - Page 18
... a blade not approved by the manufacturer of this manual). BLADE REMOVAL
1. Raise mower to highest position to allow access to slow leaks, tire sealant may cause tire ...running and the attachment clutch is sufficient for 1 hour. Replace worn, bent or damaged blades. _i, CAUTION: Use only a replacement blade approved by turning counterclockwise.
3. TRACTOR
Always observe safety rules ...
Operation Manual - Page 19
Disconnect BLACK battery cable first
then RED battery cable and remove battery from wear. Reinstall battery (See "REPLACING BATTERY" in one year.
TRANSAXLE COOLING
The transmission ... water or steam to clean transaxle.
• Inspect cooling fan to be kept clean to slip from tractor. 2. Oil Drain Valve
Closed and Locked Position
Yellow Cap
Drain Tube .
Select the oil's SAE viscosity...
Operation Manual - Page 20
... damage. NOTE: Operating the engine with oil through oil fill dip- MUFFLER
Inspect and replace corroded muffler and spark arrester (if equipped) as necessary. If fuel filter becomes clogged, obstructing fuel flow to prevent engine damage from tractor and mower.
20 Place new fuel filter in position in "PRODUCT SPECIFICATIONS" section of each...
Operation Manual - Page 21
... pin (B) and rear lift link (C) from idler arm (R).
6. Place attachment clutch in lowest position.
Place attachment clutch in contact with plug.
CAUTION: Lift lever is cen- tered under tractor. 2. Depress brake pedal fully and set parking brake. 2. Remove clutch cable spring (Q) from rear mower bracket (D) -
TO REMOVE MOWER
1. Lower attachment lift lever to its lowest
position...
Operation Manual - Page 22
... spring. 4. ATTACH REAR LIFT LINKS (C) - Hook end of clutch cable spring (Q) into hole in front mower bracket (H) and secure with retainer spring (K).
10. Push clutch cable housing guide (P) into hole in idler arm (R).
9. ATTACH FRONT LINK (E) - Insert end of this manual.
03042tex
22 Lift rear corner of mower and position slot in the Operation section of...
Operation Manual - Page 24
... inside the belt keeper. 4. Mandrel
TO REPLACE MOTION DRIVE BELT
Park the tractor on bottom side of tractor. Remove beltfrom stationary idler (A) and
clutching idler (B). 3. Install new belt from transmission input pulley and over the steering plate (F) and above clutch brake pedal shaft (G).
2. BELT REMOVAL-
1. Remove mower (See "TO REMOVE MOWER" in this section of all belt...
Operation Manual - Page 26
... install bulb
holder securely back into the hole in the backside of tractor. If adjustment is located behind the dash. Connect BLACK grounding cable to negative (-) battery terminal with 30 amp automotive-type
plug-in front of the grill. 4. TO REPLACE FUSE
Replace with remaining hex bolt and keps nut.
Headlight Wire Connector
Positive...
Operation Manual - Page 29
... speed.
2 Adjust throttle control. 3 Clean underside of mower
housing.
4 Clean/replace air filter.
5 Check oil level/change oil.
6 Clean and regap or change spark plug.
7 Replace fuel filter.
8 Empty fuel tank and refill tank witlfresh, clean gasoline.
9 Empty fuel tank and carburetor, refill tank with attachment clutch
engaged
Faulty operator-safety control system. presence...
Operation Manual - Page 30
...or other qualified service center.
1 Place throttle control in clutch mechanism.
1 Replace blade. Tighten blade bolt.
7 Buildup of grass, leaves and trash under mower.
4 Bent blade mandrel.
5 Clogged mower deck vent from buildup of grass, leaves, and
open vent holes.
1 Remove obstruction.
2 Worn/damaged mower drive belt. 2 Replace mower drive belt.
3 Frozen idler pulley. 4 Frozen blade...
Operation Manual - Page 31
...cable connections.
1 Replace battery. 2 Check/clean all connections.
3 Faulty regulator (if so equipped). 4 Faulty alternator.
3 Replace regulator. 4 Replace... alternator.
1 Freewheel control in "disengaged" position.
1 Place freewheel control in "engaged" position.
2 Motion drive belt worn, damaged, 2 Replace..."ON" while mower or other product manuals online. o Get ...
Similar Questions
How To Replace Deck Engagement Cable On Craftsman Mower
(Posted by jps0RLS 9 years ago)
Yt 3000 21 Hp Yard Tractor By Craftsman How To Clean The Carburetor
(Posted by jobyproo 9 years ago)
Yts 4000 How To Adjust Mower Deck
(Posted by nhantjbe 10 years ago)
How To Attach Mower Deck To Craftsman Lawn Tractor 46 Inch Yt 4000
(Posted by nlawi 10 years ago)
How To Install A Clutch Cable On A Craftsman Riding Mower
(Posted by HONhomerj 10 years ago)