Craftsman 28928 Support Question
Craftsman 28928 Support Question
Find answers below for this question about Craftsman 28928 - YT 4000 24hp 46" Yard Tractor.Need a Craftsman 28928 manual? We have 1 online manual for this item!
Question posted by HONhomerj on October 12th, 2013
How To Install A Clutch Cable On A Craftsman Riding Mower
The person who posted this question about this Craftsman product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Craftsman 28928 Manual Pages
Operation Manual - Page 1
... this Owner's Manual.
Sat
SEARS, ROEBUCKAND
CO., HOFFMAN ESTATES,
Visit our Craftsman website:www.sears.com/craftsman
426152 Rev. 2
IL 60179 U.S.A.
*As rated by the engine manufacturer Operator's Manual
ICRIIFTSMI N°I
LAW TRACTO
24.0 HR* 46" Mower Electric Start Automatic Transmission
Model No. 28928
• EspaSol, p. 34
This product has a low emission engine which operates...
Operation Manual - Page 2
...Assembly/Pre-Operation
7
Operation
9
Maintenance Schedule 17
Maintenance
17
Service and Adjustments 21
Storage
28
Troubleshooting
29
Sears Service Back Cover
Craftsman Riding Equipment Warranty: Lawn Tractors, Garden Tractors, Zero Turn Riders
CRAFTSMAN TWO YEAR FULL WARRANTY
FOR TWO YEARS from the date of purchase, if any non-expendable
part of this product is void...
Operation Manual - Page 3
... when operating near rotating
parts or under
the influence of your tractor.
Avoid discharging material
41&
against a wall or obstruction. Keep clear of the discharge opening at the lowest possible speed when on the machine and in
may lose control of riding mower-related injuries.
Stop machine ifanyone enters the area.
• Never...
Operation Manual - Page 5
... the area.
• Before and while backing, look down
and behind and down for another ride and be run over or
backed over by the machine. • Keep children out of the... and the discharge guard frequently and replace with manufacturer's recommended parts, when necessary. • Mower blades are sharp. Allow machine to stop and
inspect the machine. Repair, if necessary, before
storing...
Operation Manual - Page 6
... 5 Amps Headlights
Battery:
Amp/Hr:
28
Min. Please read and retain this tractor. taining, caring for and using your purchase of the California Public Resources Code). quired...INSTALLATION SERVICE
For Sears professional installation of your new purchase for you to schedule service. We have similar laws. nance" and "Storage" sections of dependable operation. Your new Craftsman...
Operation Manual - Page 9
... , if not avoided could result in death or serious injury. CAUTION when used to the tractor and/or engine.
R N N L I',,I @
REVERSE
6
NEUTRAL
HIGH
e
LOW
G
CHOKE
...ON
ENGINE START
PARKING BRAKE
MOWER HEIGHT
MOWER LIFT
LIGHTS ON
FUEL
t
BATTERY
REVERSE
FORWARD
CRUISE CONTROL
CLUTCH/BRAKE PEDAL
@@®@@
ATTACHMENT CLUTCH DISENGAGED
ATTACHMENT CLUTCH ENGAGED
DANGER, KEEP HANDS...
Operation Manual - Page 10
... various controls and adjustments. Indicates when service is required for braking the
tractor and starting the engine. (C) PARKING BRAKE - Used for the
engine and mower.
10 Locks clutch/ brake pedal into the brake position.
(D) THROTTLE/CHOKE
CONTROL-
Used to engage the mower blades, or other powered attachment while in reverse.
(H) LIGHT SWITCH - KNOW YOUR...
Operation Manual - Page 11
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your tractor is depressed.
(_) Attachment Clutch
(t'_) Disengaged Position
Engage Position
GROUND DRIVE. Pedal should remain in to disengaged
position
(r_'_). STOPPING
MOWER BLADES -
ENGINE -
• Move throttle control (D) between half and full speed (fast) position, before leaving the operator's position. NOTE: Under certain ...
Operation Manual - Page 12
... "TO ADJUST MOWER CUTTING HEIGHT" in appropriate hole. Install gauge wheel in this section of manual).
2. Tighten securely.
3.
proximately 2-1/2 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth. • For best cutting performance, grass over 3 inches during the cool season and to ap- Your tractor is equipped...
Operation Manual - Page 13
...turn ignition key
counterclockwise
to ROS "ON" posi- TO STOP MOWER BLADES disengage attachment clutch control.
_,CAUTION"
Do not operate the mower
without either the entire grass catcher, on hills.
•... Disengaged
NOTE: To protect hood from damage when transporting your tractor, be sure hood is located at the back of tractor.
1. Use the slope guide provided at the rear drawbar ...
Operation Manual - Page 14
... and set parking brake.
To service engine and mower, see the Maintenance section in the Maintenance section of ...lead oxide deposits and reduce valve life).
Move attachment clutch to choke position. ADD GASOLINE • Fill fuel .... NOTE: Service reminder runs when the ignition key is in your tractor. Move throttle control to disengaged position.
4. Use fresh, clean, ...
Operation Manual - Page 18
...Install and tighten blade bolt securely
(45-55 Ft. Special blade bolt is heat
BLade
• When the engine is engaged, any attempt by the operator to drive in the disen- How-
BLADE CARE For best results mower blades must be purchased from your tractor...
ignition switch in the ROS "ON" position and the attachment clutch engaged, any maintenance.
Do not attempt to drive in
•...
Operation Manual - Page 19
...a suitable container.
1.
Replace belts if they will drain more frequently to slip from tractor. 2. ing the engine and after each time you check the oil level. All oil ...cable ends with grease or petroleum jelly. 5. TRANSAXLE
PUMP FLUID
The transaxle was sealed at least once a year if the tractor is running !ow on oil. Change the oil after 100 hours of drain valve and install...
Operation Manual - Page 21
... link (E) from idler arm (R).
6.
nected, the attachment lift lever will be mounted on level surface and engage parking brake. 1. Remove clutch cable spring (Q) from mower remove retainer spring and washer.
7. TO INSTALL MOWER
Be sure tractor is to its lowest
position. 3.
Depress brake pedal fully and set parking brake. 2. Make sure the blades and all moving...
Operation Manual - Page 22
... in all mower pulley grooves. 11. Insert rod end of tractor.
7. 3. Repeat on outside of tractor. Hook end of this manual.
03042tex
22 iMPORTANT: Check belt for proper routing in tractor front suspension bracket (F). Install belt onto engine pulley (M) and belt keepers (G).
. Raise attachment lift lever to highest
position. 12. ATTACH FRONT LINK (E) - Push clutch cable housing...
Operation Manual - Page 24
... footrest. Pull belt toward rear of this manual).
BELT REMOVAL-
1. Install belt through stationary idler (A) and clutching idler (B). 6.
Remove beltfrom stationary idler (A) and
clutching idler (B). 3. Make sure belt is in this section of tractor. Install mower (See "TO INSTALL MOWER" in this section of tractor, off both mandrel pulleys and idler pulleys
2. Pull belt slack...
Operation Manual - Page 26
... BULB 1. Remove bulb holder from accidental grounding. 1. However, minor adjustment may cause
your tractor to prevent sparking from the hole in front of the grill. 3. Install new battery with remaining hex bolt and keps nut. First connect RED battery cable (B) to reconnect the headlight wire connector. Tighten securely
6. The fuse holder is necessary...
Operation Manual - Page 29
...grass/too fast.
2 Throttle in "CHOKE" position. 3 Build-up of grass, leaves and
trash under mower. 4 Dirty air filter. 5 Low oil level/dirty oil. 6 Faulty spark plug.
7 Dirty fuel filter...tank witlfresh, clean gasoline.
9 Empty fuel tank and carburetor, refill tank with attachment clutch
engaged
Faulty operator-safety control system. TROUBLESHOOTING CHART: See appropriate section in manual unless...
Operation Manual - Page 30
...Tighten blade bolt. 2 Level mower deck.
3 Clean underside of mower housing.
4 Contact a Sears or other qualified service center.
1 Place throttle control in clutch mechanism.
1 Replace blade. ...2 Mower deck not level.
3 Buildup of grass, leaves, and trash under mower.
8 Mower drive belt worn.
7 Clean underside of mower housing.
8 Replace mower drive belt.
9 Blades improperly installed.
...
Operation Manual - Page 31
... team of drive
Engine "backfires" when turning engine "OFF" Engine dies when tractor is shifted into reverse
CAUSE
CORRECTION
1 Bad battery cell(s). 2 Poor cable connections.
1 Replace battery. 2 Check/clean all connections.
3 Faulty regulator (if...Replace motion drive belt. attachment is not "ON" while mower or other product manuals online. anage ho
e
brought to help with home projects.
Similar Questions
How Does The Attachment Clutch Work On A Sears Riding Mower
(Posted by Swbobby 9 years ago)
How To Install A Clutch Assembly On A Craftsman 3000 Riding Mower
(Posted by imNei 9 years ago)
Yt 3000 21 Hp Yard Tractor By Craftsman How To Clean The Carburetor
(Posted by jobyproo 9 years ago)
How To Change Riding Mower Blade Brake Clutch Cable
(Posted by micaaroa 9 years ago)
How Do You Replace Mower Deck Clutch Cable
(Posted by ndemarco 11 years ago)