Home » Cisco » Bridges & Routers » Cisco 7604

Cisco 7604 Support Question

Find answers below for this question about Cisco 7604.
Need a Cisco 7604 manual? We have 4 online manuals for this item!

Cisco Overview Questions Manuals Reviews Videos Research

Question posted by fadimoali on August 23rd, 2011

Power Consumption

what is the power consumptions for cisco 7600 and ASR 9K your fast respone is really appreciated

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Tefik on August 23rd, 2011 6:15 AM

This answer was accepted by the poster of the original question.

Tefik

Member since:
May 10th, 2011

Points: 447,890

1,080
points

120 or 240 VAC (switchable), 48 to 60 VDC (respectively).

Related Cisco 7604 Manual Pages

Processor Guide - Page 10

... for the Cisco 7600 Series Routers • Cisco 7600 Series Router Installation Guide • Cisco 7609 Router Installation Guide (OSR-7609) • Cisco 7600 Series Router Module Installation Guide • Cisco 7600 Series Router Cisco IOS Command Reference • Cisco 7600 Series Router Cisco IOS System Message Guide • Cisco 7600 Series Router Cisco IOS Software Configuration...

Processor Guide - Page 13

....2SRC introduces support for core switching logic • Modular Gigabit Ethernet ports that you can configure with 10 Gigabit Ethernet uplink ports). Chapter 1 Cisco 7600 Product Overview Cisco 7600 Series Routers Features Table 1-1 lists some key features of software being used on the MSFC. It is available in which the PFC3A is supported. MSFC2 and...

Processor Guide - Page 21

... 3 protocols, such as the Spanning Tree Protocol (STP) and others. Chapter 2 Route Switch Processors and Supervisor Engines Overview - For information about supported protocols, see the Cisco 7600 Series Router Cisco IOS Software Configuration Guide and the release notes for the software version running on the...

Processor Guide - Page 73

OL-10100-11 Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide A-1 A A P P E N D I X Technical Specifications This appendix provides the technical specifications for the Cisco 7600 route switch processors (RSPs) and supervisor engines. Module Specifications Table A-1 lists the environmental and physical specifications for the Cisco 7600 route switch processors and ...

Installation Guide - Page 19

...AC- or DC-input, load-sharing power supplies • Support for modules and power supplies • Environmental monitoring of the Cisco 7600 series router. Chapter 1 Product Overview Cisco 7600 Series Routers Features Table 1-1 lists some key ... two hot-swappable supervisor engines • Fast switchover for redundant supervisor engine and modules • Support for two redundant AC-

Installation Guide - Page 76

Table 2-9 Cisco 7600 Series Router Bandwidth and Port Density Architecture Cisco 7603 Router Backplane Bandwidth for Supervisor Engine 32 32 Gbps Backplane Bandwidth ... Cisco 7604 Router 32 Gbps 720 Gbps 720 Gbps 50 48 12 3 6 Cisco 7606 Router 32 Gbps 720 Gbps 720 Gbps 82 80 20 5 10 Cisco 7609 Router 32 Gbps 720 Gbps 720 Gbps 130 128 32 8 16 Cisco 7609-S Router 32 Gbps Cisco 7613 Router ...

Installation Guide - Page 105

... reload the software on the router: Router# reload This example illustrates how to use the reload command to reload the software on the router in 10 minutes: Router# reload in 10 Router# Reload scheduled for 11:57:08 PDT Fri Apr 21 1996 (in 10 minutes) Proceed with reload? [confirm] Router# OL-5077-7 Cisco 7600 Series Routers Module Guide 4-5

Software Configuration Guide - Page 34

... hold down the Control key while you might do something that could result in equipment damage or loss of data. In this page: http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX 32 OL-4266-08

Software Configuration Guide - Page 40

... QoS features on this page: http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX 1-6 OL-4266-08 Each hardware-assisted tunnel must have a unique source. Each tunnel interface uses one additional router MAC address entry per router MAC address. - Tip For additional information...

Software Configuration Guide - Page 42

... through Telnet, page 2-2 Accessing the CLI through Telnet Note Before you can make a Telnet connection to the router, you see the "Configuring IPv4 Routing and Addresses" section on page 22-4). See the Cisco 7600 Series Router Module Installation Guide for the period specified with the exec-timeout command. Completes enable mode enable. Telnet sessions...

Software Configuration Guide - Page 48

ROM-Monitor Command-Line Interface Chapter 2 Command-Line Interfaces Tip For additional information (including configuration examples and troubleshooting information), see the documents listed on this page: http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX 2-8 OL-4266-08

Software Configuration Guide - Page 57

... is 0x2 Router# OL-4266-08 Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX 3-9 Check the current state of memory. Processor board ID SAD04430J9K R7000 CPU at 300Mhz, Implementation 39, Rev 2.1, 256KB L2, 1024KB L3 Cache Last reset from power-on your system. You will need to reenter the setup command to...

Software Configuration Guide - Page 277

... enable the extended system ID on page 20-24. With the extended system ID enabled, a router bridge ID (used by the spanning tree algorithm to avoid undesirable root bridge election and spanning tree topology issues. OL-4266-08 Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX 20-3 Extended System ID A 12-bit extended...

Software Configuration Guide - Page 300

...configure the Cisco 7600 series router as the secondary root bridge for the specified VLANs if the primary root bridge fails (assuming the other network devices in the network use the default bridge priority of 4: Router# configure terminal Router(config)# spanning-tree vlan 10 root secondary diameter 4 Router(config)# end Router# 20-26 Cisco 7600 Series Router Cisco IOS Software Configuration...

Software Configuration Guide - Page 304

... the configuration. The vlan_ID value can be 1 through 4094, except reserved VLANs (see Table 14-1 on page 14-2). Reverts to the default bridge priority value. 20-30 Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX OL-4266-08 The bridge_priority value can be from 1 to 65535. Exits configuration mode. Verifies the...

Software Configuration Guide - Page 313

... 200000 128.240 P2p Bound(STP) Router# OL-4266-08 Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX 20-39 This example shows how to 24576 mst bridge max aging time unchanged at 20 mst bridge hello time unchanged at 2 mst bridge forward delay unchanged at 15 Router(config)# ^Z Router# Router# show spanning-tree mst Purpose Configures...

Software Configuration Guide - Page 327

... interface fastEthernet 4/4 detail Port 196 (FastEthernet4/4) of VLAN0010 is enabled BPDU:sent 0, received 0 Router# OL-4266-08 Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX 21-11 Designated root has priority 32768, address 00d0.00b8.140a Designated bridge has priority 32768, address 00d0.00b8.140a Designated port id is 160.196, designated...

Software Configuration Guide - Page 527

...), page 36-18 - Layer 2 Multicast IGMP Snooping, page 36-19 - OL-4266-08 Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX 36-11 FIB Glean (Unicast Only), page 36-17...Understanding How DoS Protection Works • Hardware-Based Rate Limiters on the Cisco 7600 series routers. Ingress-Egress ACL Bridged Packets (Unicast Only), page 36-15 - Use security ACLs if ...

Software Configuration Guide - Page 543

... CON Off ACL BRIDGED IN Off ACL BRIDGED OUT Off IP FEATURES Off ACL VACL LOG On CEF RECEIVE Off CEF GLEAN Off MCAST PARTIAL SC On IP RPF FAILURE On TTL FAILURE Off ICMP UNREAC. RL# 1: Free - RL# 6: Used IP RPF FAILURE ICMP UNREAC. OL-4266-08 Cisco 7600 Series Router Cisco IOS Software Configuration...

Software Configuration Guide - Page 917

...# OL-4266-08 Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX 54-7 LOU destination, ADJ - ACL adjacency Module ACLent ACLmsk QoSent QoSmsk Lbl-in - egress label, LOUsrc - ANDOR, QoSent - ACL TCAM masks, AND - ingress label, Lbl-eg - LOU source, LOUdst - Chapter 54 Power Management and Environmental Monitoring Understanding How Power Management Works...