Home » Chrysler » Troubleshooting » 2012 Chrysler 200

2012 Chrysler 200 Support Question

Find answers below for this question about 2012 Chrysler 200.
Need a 2012 Chrysler 200 manual? We have 4 online manuals for this item!

Chrysler Overview Questions Manuals Reviews Videos Research

Question posted by naomiholloman02 on February 1st, 2022

My Battery Key Is Not Working Now When I Start My Car It Starts Up Then Cuts Of.

my beeper is not reading good and I took the battery out the key due to my alarm going off malfunctioning I couldn't turn it off even with the key in the ignition. Once the alarm went off I tried to start my car which it starts up for a couple of seconds then turns back off. I already replaced the battery and transmission also the alternator within the last year and months or so. I am bad with knowing issues about cars. Need advice please.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by SonuKumar on February 2nd, 2022 7:04 AM

This answer was accepted by the poster of the original question.

SonuKumar

Member since:
May 9th, 2021

Points: 16,604,800

1,100
points

https://www.youtube.com/watch?v=7jkn6NKdjs4

Why does my key fob not work after replacing battery?

The most common problem with these car key fobs is that the batteries go dead over time, in which case replacing the battery should fix the problem. ... Take the key fob apart and check for broken contacts or misaligned buttons. Reprogram your remote yourself or have a professional do it.

https://www.lifewire.com/broken-car-remote-4111537

https://www.samlemanmorton.com/manufacturer-information/program-cdjr-key-fob/

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

Related Manual Pages

Owner Manual - Page 14

... Key Ignition Key Removal Automatic Transaxle Place the shift lever in a safe place. Turn the ignition switch to the ACC position, push the key and cylinder inward, rotate the key to order duplicate keys from your authorized dealer. Ask your vehicle locks. You can be used to the LOCK position, and remove the key. 12 THINGS TO KNOW BEFORE STARTING...

Owner Manual - Page 19

...key is programmed. Cut the additional Sentry Key௡ Transponder blank(s) off. The Remote 2. This procedure consists of programming a blank key to the LOCK position and remove the first key. authorized dealer. Turn the ignition switch to the ON/RUN position within Customer Key Programming 60 seconds. THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17 3. Insert the second valid key...

Owner Manual - Page 205

...: • The "ESC Off Indicator Light" and the "ESC Activation/Malfunction Indicator Light" come on momentarily each time the ignition switch is turned to the on . Electronic Stability Control (ESC) Activation/ it indicates that it is not on position, but do not start the vehicle. If the light does not come on, have the...

Owner Manual - Page 214

... - Unless reset, this message will flash in the EVIC display for approximately five seconds after a single chime has sounded to ЉTire Pressure Monitoring SystemЉ in ЉStarting and OperatingЉ. To turn the ignition switch to display each time you turn off the message temporarily, press and release the MENU button. If Equipped...

Owner Manual - Page 291

...Equipped ...307 5 If Equipped ...297 Ⅵ Automatic Transmission ...297 ▫ Automatic Transmission Ignition Interlock Systems ...299 ▫ Key Ignition Park Interlock ...299 ▫ Brake/Transmission Interlock System ...299 ▫ Four-Speed Automatic Transmission - STARTING AND OPERATING CONTENTS Ⅵ Starting Procedures ...294 ▫ Automatic Transmission ...294 ▫ Normal...

Owner Manual - Page 296

... to any driving gear. Children should be in the PARK or NEUTRAL position before you can start within 10 seconds, turn the ignition switch to touch the parking brake, brake pedal or the shift lever. Normal Starting NOTE: Normal starting your vehicle, adjust your seat, adjust the inside and outside mirrors, fasten your vehicle. • Never...

Owner Manual - Page 297

... information. 5 If this way. and release it will continue to the START position WARNING! started , ignite and damage the converter able from a booster battery or the battery in a flash fire onds. Refer to the LOCK causing serious personal injury. position, wait 10 to 15 seconds, then repeat the "Normal • Do not attempt to push or...

Owner Manual - Page 298

... 10 to 15 seconds, then enough power to continue running when the key is flooded. occurs, release the accelerator pedal, turn the ignition switch to the START position and To prevent...floor. If this 15 seconds before trying again. With Tip Start If the engine fails to start after two 15second periods of starting after you have followed the "Normal Starting" or "Extreme Cold Weather...

Owner Manual - Page 301

..., the ignition switch must be turned to the ON/RUN or START position (engine running . Automatic Transmission Ignition Interlock Systems These systems prevent the key fob from the ignition when the ignition is in the LOCK/OFF position and once removed the shift lever is inoperable. NOTE: If a malfunction occurs, the system will trap the key in PARK. Key Ignition Park...

Owner Manual - Page 313

...ensure that it indicates the PARK position. 5 STARTING AND OPERATING 311 WARNING! (Continued) • When leaving the vehicle, always remove the key fob from PARK or NEUTRAL into PARK, ... seated. • Look at the shift lever position display and verify that you must turn the ignition switch from the LOCK/OFF position to an unlocked vehicle. The following indicators should be ...

Owner Manual - Page 401

Set the parking brake, shift the automatic transmission into PARK and turn the ignition to avoid the radiator cooling fan whenever the hood is flammable and explosive. Turn off the heater, radio, and all unnecessary electrical accessories. To allow jump-starting there are remote battery posts located on . WARNING! • Take care to LOCK. 2. Remote Positive...

Owner Manual - Page 414

...battery or a battery replacement. This might indicate a damaged cap. If you crank or start the engine, you will have to the ON position, but do the following: 1. If the problem is not this check verifies the "Malfunction 2. Resolving the problem will be determined not ready for testing. Normally, the OBD II system will turn the ignition...ignition key-actuated test, which you turn...

Owner Manual - Page 430

... (before the onset of freezing weather, where Refer to cool. 428 MAINTAINING YOUR VEHICLE Cooling System WARNING! • When working near the radiator cooling fan, disconnect the fan motor lead or turn the ignition switch to remove all deposits and chemicals. If you see or hear steam coming from under the hood, do...

User Guide - Page 11

...• The seat belts for cuts, frays, or loose parts. Inspect the belt system... A snug belt reduces the risk of the Remote Start System, windows, door locks or other controls could ... event of injury. THEFT ALARM To Arm • Press the Key Fob LOCK button or the...To Disarm • Press the Key Fob UNLOCK button or turn the ignition to remove slack from injury during...

User Guide - Page 78

... all unnecessary electrical accessories. 3. Remove the protective cover over the remote positive (+) battery post. Jump-starting there are remote battery posts located on the cover. 4. Set the parking brake, shift the automatic transmission into PARK and turn the ignition to jump-start the battery, park the vehicle within the jumper cables reach, set of the engine compartment...

Owner Manual Convertible - Page 17

... is also ignition key is cut to ON/RUN, the Vehicle Security Light will turn on for three seconds for that are proKey-In-Ignition Reminder grammed to the vehicle can be armed or activated. The with the electronics. Always remove key from the ignition and lock all doors when leaving the vehicle unattended. An unlocked car is locked...

Owner Manual Convertible - Page 19

... first valid key into the ignition switch. Insert the second valid key into the ignition switch. key is complete, the indicator 2. A blank first key. dure: Turn the ignition switch to the ON/RUN position within System serviced, bring all vehicle keys with you have two valid Sentry Keys௡ by using the Customer Key Pro- This procedure consists of pro- Cut the additional...

Owner Manual Convertible - Page 223

... Cargo Shield (with a single chime) • Speed Too High (with a single chime) • Convertible Top Malfunction (with a single chime) • Oil Change Required (with a single chime) • Low Tire (with a single chime). Oil Change Required - Fuel low • Remote start aborted - UNDERSTANDING YOUR INSTRUMENT PANEL 221 • Key In Ignition • Remote start aborted -

Owner Manual Convertible - Page 422

... ignition key-actuated test, which you can use prior to going to pass could prevent vehicle registration. 2. Failure to the test station. If you crank or start the engine, you must do not an inspection of your vehicle may be a legal requirement to pass 1. system is ready for the I /M), this test over. Turn the ignition switch...

Owner Manual Convertible - Page 438

... can start at... for brittle rubber, cracking, tears, cuts, and tightness of the connection at anytime the ignition switch is dirty or contains a considerable...8226; When working near the radiator cooling fan, disconnect the fan motor lead or turn the ignition switch to open... the hood until the radiator has had time to remove all deposits and chemicals. Never try...