2009 Chrysler Sebring Support Question
2009 Chrysler Sebring Support Question
Find answers below for this question about 2009 Chrysler Sebring.Need a 2009 Chrysler Sebring manual? We have 4 online manuals for this item!
Question posted by seeabruno on February 21st, 2013
Cluster Remove
mi clustel lights not work rest off the lights ar ok . How i remove the cluster to repair
Current Answers
Related Manual Pages
Owner Manual Sedan - Page 18
..., if the light begins to start the engine. CAUTION!
If the light remains on the... same keychain will result in the engine being used an invalid key to flash after the bulb check, it indicates that there is not compatible with some aftermarket remote starting systems. Use of these systems may result in the electronics. Should this system. Always remove...
Owner Manual Sedan - Page 20
.... NOTE: If a programmed key is complete, the indicator light will sound. Turn the ignition switch to the LOCK position and remove the second key. 4.
The remaining keys must accept any interference...be reprogrammed. 18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
addition, the Vehicle Security Light will stop flashing. If you do not have all remaining keys erased from starting your...
Owner Manual Sedan - Page 21
... will signal for unauthorized operation. Remove the keys from the ignition switch and get out of the visual signals after three minutes, turn off all doors. For the first three minutes, the horn will sound intermittently and the headlights, park lights, taillights and the indicator light in the cluster will flash slowly. NOTE: The...
Owner Manual Sedan - Page 25
...transmitter. Release both buttons at least four seconds, but not longer than 10 seconds. Press the UNLOCK button to "Flash Lights with the EVIC, perform the following procedure: 1. Repeat these steps if you are locked or unlocked with the
system activated ... Features)" under "Electronic Vehicle Information Center (EVIC)" in the LOCK position, and the key removed. 4.
Owner Manual Sedan - Page 26
...
• For vehicles not equipped with the ignition in the LOCK position, and the key removed. 4. Repeat these steps if you are unlocked with EVIC. NOTE: Pressing the LOCK button on... the Vehicle Security Alarm system. For details, refer to its previous setting. The turn signal lights will flash and the horn will activate the Vehicle Security Alarm system. Release both buttons at...
Owner Manual Sedan - Page 40
...either in the up for an additional two seconds after the window is no anti-pinch protection. Remove the obstacle and use the window switch again to close the window. • Any impact due...window controls on the other doors, press the window LOCK button. If this happens, pull the switch lightly to disable the window control on the other doors. To avoid personal injury, be disabled. To ...
Owner Manual Sedan - Page 63
... up. The ORC contains a backup power supply system that will illuminate the instrument cluster Airbag Warning Light if a malfunction is severe enough to require the airbags to inflate. A single ... system required for a self-check when the ignition is first turned on the Airbag Warning Light either momentarily or continuously. The ORC monitors the readiness of the electronic parts of the system...
Owner Manual Sedan - Page 66
... driver and front passenger as the battery has power or until the ignition key is removed • Unlocks the doors automatically If a Deployment Occurs The airbag systems are a ...immediately deflate. 64 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
• Flashes hazard lights • Turns on the interior lights which deploys the airbags, any blistering, see some smoke-like particles. If ...
Owner Manual Sedan - Page 68
...The airbag may inflate accidentally or may not function properly if modifications are not working, the Occupant Restraint Controller (ORC) may not be ready to be disabled....an advanced airbag system for your protection in any way (including removal or loosening/ tightening of your authorized dealer. Airbag Warning Light You will want to have an authorized dealer service the system ...
Owner Manual Sedan - Page 84
Inspect tread and sidewall for tightness. Lights Have someone observe the operation of exterior lights while you work the controls. Fluid Leaks Check area under vehicle after overnight parking for fuel, engine coolant, oil, or other objects lodged in the tread. Defroster Check ...
Owner Manual Sedan - Page 141
... the headlights on each side of the instrument cluster flash to show proper operation of the front and rear turn off the front fog lights. Turn Signal Control You can signal a lane...partially up or down without moving beyond the detent.
3
Front Fog Light Control
NOTE: The front fog lights will turn signal lights.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 139
Turn Signals Move the ...
Owner Manual Sedan - Page 190
... such as possible if this section for more information. The vehicle should be serviced if the light stays on through several of power or severe catalytic converter damage. Electronic Vehicle Information Center (EVIC) Display-Premium Cluster Only This display shows the EVIC messages when the appropriate conditions exist. may exist that monitors...
Owner Manual Sedan - Page 286
... dealer immediately. The Brake System Warning Light in the ignition. It does not show the degree of reasons. Do not leave the key in the instrument cluster will turn on when the parking brake...other controls, or move the vehicle. • Be sure the parking brake is applied. NOTE: This light only shows that the parking brake is fully disengaged before driving: failure to do so can lead to ...
Owner Manual Sedan - Page 287
...In the event power assist is lost for any reason (i.e., repeated brake applications with your foot resting or riding on the brake pedal can lead to brake the vehicle will be much greater ...evident by a leak in an emergency. • Driving a vehicle with the Brake System Warning Light on as the brake fluid level drops in braking performance or vehicle stability during application and greater...
Owner Manual Sedan - Page 292
...noises are the system performing its self-check cycle to the ABS system is working properly.
Immediate repair to ensure that may be performed by improperly installed or high output radio transmitting...These are not functioning. 290 STARTING AND OPERATING
If both the Brake Warning Light and the ABS Light remain on, the Anti-Lock brakes (ABS) and Electronic Brake Force Distribution (EBD) ...
Owner Manual Sedan - Page 295
ESP/TCS Indicator Light The "ESP/TCS Indicator Light, located in the instrument cluster, starts to flash as soon as possible. STARTING AND OPERATING... position. • Understeer - ESP uses sensors in counteracting the over /under steer condition. The ESP/TCS Indicator Light also flashes when TCS is active.
Be sure to adapt your speed and driving to the prevailing road conditions.
...
Owner Manual Sedan - Page 297
... running . Once the situation requiring ESP to be desirable to switch to the ON position. ESP/BAS Warning Light and ESP/TCS Indicator Light The malfunction indicator for the ESP is in the instrument cluster both .
This may be switched to have the problem diagnosed and corrected.
5 In the Partial ESP mode, the...
Owner Manual Sedan - Page 321
...for the TPMS to any of the following: 1. The Tire Pressure Monitoring Telltale Light will turn off . Installing some form of snow or ice around the wheels ...system receives the updated tire pressures, the system will automatically update and the Tire Pressure Monitoring Telltale Light will turn off when the fault condition no longer exists. STARTING AND OPERATING 319
Tire Pressure ...
Owner Manual Sedan - Page 323
...Information Center (EVIC) will sound when tire pressure is low in the instrument cluster and a chime will display a graphic showing the pressure values of the ... Vehicle Information Center (EVIC) • Tire Pressure Monitoring Telltale Light Tire Pressure Monitoring Low Pressure Warnings The Tire Pressure Monitoring Telltale Light will illuminate in one or more of each tire with the ...
Owner Manual Sedan - Page 396
...leaking in the master cylinder immediately if the brake system warning light indicates system failure. Refer to "Fluids, Lubricants, and ...performing underhood services.
You would not have your foot resting or riding on the brake fluid reservoir. If necessary...level in Section 8 of the master cylinder area before removing the cap. Use only manufacturer's recommended brake fluid. ...
Similar Questions
I Need To Know Where Is The Fuse For The Reverse Light And For The Ac And Heate
can anyone tell me where my fuses for my reverse light and my AC heater at on my Chrysler sebring 20...
can anyone tell me where my fuses for my reverse light and my AC heater at on my Chrysler sebring 20...
(Posted by moncadajuanluis 6 years ago)
Instrument Panel Lights Quit Working
The instrument panel lights stopped working while the radio lights, mileage lights, and temp lighte ...
The instrument panel lights stopped working while the radio lights, mileage lights, and temp lighte ...
(Posted by lcschultz 10 years ago)
License Plate Lights Not Working
ive replaced the light bulbs for the license plate and they are still not working any suggestions on...
ive replaced the light bulbs for the license plate and they are still not working any suggestions on...
(Posted by velmapadilla 10 years ago)
Can You Tell Me How The Lights Are Supposed To Work? Should They Come On
automatically or are they all manual. And how do the door lights work?
automatically or are they all manual. And how do the door lights work?
(Posted by ddbugger 10 years ago)
Hi Beams Will Not Work. The Dash Indicator High Beam Light Illuminates Only.
(Posted by bwolf6750 10 years ago)