2000 Chrysler 300M Support Question
2000 Chrysler 300M Support Question
Find answers below for this question about 2000 Chrysler 300M.Question posted by pattijomn on September 15th, 2012
Turn Signal Switch Question
On the 2000 Chrsyler 300M do you have to unhook the airbag and remove the steering wheel to change the turn signal switch?
Current Answers
Answer #1: Posted by roadrunnertim on September 15th, 2012 2:05 PM
roadrunnertim
Member since:
May 9th, 2012 Points: 1,071,190
Member since:
May 9th, 2012 Points: 1,071,190
Yes, you must remove the airbag and steering wheel to access the turn signal switch. Be very careful removing the airbag. You must disconnect the negative battery cable and pull the airbag fuse. Watch out for static electricity as well. It doesn't take much to trigger an airbag and they can do serious harm if they go off in your face.
There's a video on YouTube that may help you out. It shows someone removing the turn signal switch from a 2005 Chrysler, but it should give you a good idea how to remove your turn signal switch.
Here's the link: www.youtube.com/watch?v=AvNuBqF-UcM
Similar Questions
How To Replace 2000 Chrysler 300m Neutral Safety Switch
(Posted by tholcd 10 years ago)
Where Is The Turn Signal Relay Located On A 2000 Chrysler 300m
(Posted by lyncun 10 years ago)
Where Is The Turn Signal Relay In A 2000 Chrysler 300m?
(Posted by Sudunat 10 years ago)
How To Remove Passenger Cv Axle From 2000 Chrysler 300m
(Posted by anLUIS 10 years ago)
How To Replace The Front Passenger Side Turn Signal Bulb On A 2000 Chrysler 300m
(Posted by zack3022 12 years ago)