1998 Chrysler Sebring Support Question
Find answers below for this question about 1998 Chrysler Sebring.Question posted by pearman13132002 on August 31st, 2011
1998 Sebring Wont Start
Current Answers
Answer #1: Posted by tmckelvey82 on November 8th, 2011 6:43 AM
1. Insert one of the pre-programmed transponder keys into the ignition lock cylinder and turn the switch to the ON position.
2. The key should remain in the ON position for 5 seconds but not more then 15 seconds before you turn it back to the OFF position.
3. Within 10 seconds, insert the second pre-programed transponder key into the ignition lock cylinder and turn the switch to the ON position. The VTSS(Vehicle Theft Security System) or Sentry Key Immobilizer System lamp (depending on model ) should start to flash. This along with a audible tone will indicate to you that the system has entered the "Customer Learn" programming mode.
4. Within 45 seconds, turn the switch to the OFF position. Insert the new transponder key and turn the switch to the ON position. After approximately 10 seconds an audible tone will sound and the Indicator lamp will stay illuminated for 3 seconds. This will be your acknowledgement that you have successfully programmed in the new transponder key.
5. To add additional keys, repeat steps 1 through 4.
Otherwise, you really are going to have to see a dealer.
Please be sure to accept this answer and mark as helpful.
Not the answer you were looking for? Then please feel free to resubmit!
Thank you!
Similar Questions
When I turn the key all the aux lights & warning bells come on, but it wont start. Head lights w...