Chicco 00061472580070 Support Question
Chicco 00061472580070 Support Question
Find answers below for this question about Chicco 00061472580070 - Ketfit 30 Infant Car Seat.Need a Chicco 00061472580070 manual? We have 1 online manual for this item!
Question posted by Blondinnewcar on September 10th, 2014
Can You Tell Me When This Made Was Produced?
Im wanting to buy one off of amazon bt i know this modle is dicontinuded and i want to make sure it is still ok to use and not out of date. Thanks for any info you can provide
Current Answers
Related Chicco 00061472580070 Manual Pages
User Guide - Page 2
... Carrier 26 Safety Tips for Securing Child 28 Secure Child Checklist 29 Vehicle Information Unsafe Vehicle Belts 30 Installation Positions 31 Installation with Base LATCH or Vehicle Belt 32 Installation Using Vehicle Belt 32 Installation Using LATCH 34 Uninstalling Base 33, 36 Installation without Base 37 Installation in Aircraft 38 Cleaning and Maintenance...
User Guide - Page 3
...on Carrier is in Size Range
3 4
weight - 4-30 lbs (2 and 13.5 kg)
height - 30 inches or less (76cm)
4 Secure Child Properly in... correctly!
1 Install Child Restraint Rear-Facing 1 forward facing vehicle seats only
child faces towards rear of the
Child Restraint.
The ... installation or use, please call . SAFE USE CHECKLIST
YOUR CHILD'S SAFETY DEPENDS ON YOU! You MUST follow ...
User Guide - Page 4
...30 pounds (2 and 13.5 kg) and whose height is in harness.
NEVER allow any slack. ONLY USE the Newborn Insert for information on child restraint installation. DO NOT use this child restraint if top of restraint. ALWAYS check to make sure...all instructions and warnings in a vehicle, be sure to also check the vehicle owner's manual for infants who weigh between 4 and 11 pounds (2 and...
User Guide - Page 5
...use restraint in rear facing or side facing vehicle seats.
NEVER use , ALWAYS check to make sure that has a front airbag. After latching Carrier into Base, lift up on Carrier to make sure... front seating positions.
ONLY use this restraint. NEVER travel with side airbags. An unsecured child restraint could be killed or seriously injured if you use Chicco KeyFit infant child ...
User Guide - Page 6
... position" before lifting carrier by other parts for the "Do Not Use After" date. An unlocked handle could fall .
Check manufacturer's label on underside of Restraint
DO NOT use Child Restraint if it has been involved in this User Guide. Suffocation Hazard: Infant carrier can roll over on beds, sofas or other elevated surfaces...
User Guide - Page 8
...
SHOULDER BELT LOCKOFF
The Shoulder Belt Lockoff is used when installing the Base using vehicle belts or LATCH. See vehicle owner's manual or label on page 32 for details regarding LATCH use in most vehicles manufactured after September 1, 2002. Refer to "Installation Using Vehicle Belt" on seat belt for more information.)
Refer to your vehicle...
User Guide - Page 9
... e Harness Adjuster Strap
g h
f Lower Slots
f
a
g Middle Slots
h Upper Slots
i Head Support Fastener Tabs
b c
i
d e
16
CARRIER OVERVIEW
a Carry Handle b Canopy c Handle Button d Neck Pads e Harness Straps f Seat Pad g Adjuster Cover h Head Support
i Harness Slots j Chest Clip k Adjuster Strap
l Adjuster Button m Buckle n Newborn Insert o Canopy Mount p Easy-access belt path, to...
User Guide - Page 10
...
b
shoulder straps.
Keep adjuster area clean and free of child's chest, level with armpits. BE SURE handle is latched. Chest Clip
To separate chest clip, push center
button and pull apart. For cleaning...place handle in one of dirt. Stand
NEVER hang toys or other objects from handle when using Child Restraint in "CARRY" position Carry before lifting carrier by handle. Check that it ...
User Guide - Page 11
...its extended position.
20
NEWBORN INSERT
Use Newborn Insert to fit your child....using carrier without canopy. Release bow from Canopy Mount to pop up under the canopy. The canopy must be extended before attempting to release end of insert should always be changed to provide
additional support and ensure
a secure harness fit for smaller
1
infants. ONLY USE Insert with infants...
User Guide - Page 12
... the slots used with harness adjustment.
22
23
CARRIER/BASE ATTACHMENT
1 To secure carrier to provide
a
additional support for a click.
Pull up on underside b of base. NEVER use head support ...hands when removing.
If using a blanket/cover, make sure it is securely latched. Head support could interfere with or without newborn insert.
Be sure to verify that it does...
User Guide - Page 13
... infant may have difficulty breathing or have other strap. Do not twist strap.
4 Re-attach strap to
2
expose splitter. DO NOT USE Child Restraint if any part of harness is less than 30 inches (76 cm). CHILD REQUIREMENTS
Child Requirements
Children should look like illustration.
5 Repeat for other medical problems when placed in a seated...
User Guide - Page 14
...straps are latched. Child must be resting against back and
bottom of child's shoulders.
Make sure that they
are not AT or BELOW child's shoulders, you can pinch a fold in seated position. a Harness must be snug. c Straps must be laying flat, free of...
1 Loosen harness by pulling
slowly on adjuster strap until
harness is snug around child.
7
8 Make sure child is too loose.
User Guide - Page 15
... secured and tightened harness around child. NEVER use the Newborn Insert and Head Support provided with armpits.
2
3 Check Tightness of ...Chest Clip Chest clip should be in serious
injury or death!
2 To keep child properly secured in harness whenever child is not snug
around your child.
3 To ensure a better fit for smaller infants, use...
User Guide - Page 16
... vehicles using the vehicle
seat belts or LATCH. VEHICLE INFORMATION
This Child Restraint can be used to install this Restraint. The BEST POSITION is one that children are UNSAFE for use with ... sudden stop or crash.
30
INSTALLATION POSITIONS Accident statistics indicate that :
• Is Recommended by Vehicle Owner's Manual. • Results in rear seating positions. DEATH or SERIOUS...
User Guide - Page 17
...verify it DOES NOT INTERFERE with Recline Foot
against seat back.
2 Adjust Base Angle by pushing
Recline Buttons while lifting Base. INSTALLATION USING VEHICLE BELT
LATCH or Vehicle Belt? Vehicle must...during a sudden stop or crash.
33
Passengers may be safely installed using Vehicle Lap Belt only (no Shoulder Belt), make sure that Lap Belt is 2
between arrows.
6
d Belts & Buckles MUST ...
User Guide - Page 18
... by
5
pulling up on LATCH Pull
Strap while pressing Base firmly
into vehicle seat.
6 Store LATCH Pull Strap neatly 6 in Pull Strap Storage Pocket.
7 Check Installation a LATCH belts MUST be
TIGHT
b Base MUST be STABLE
7
c Bubble MUST be used with lower LATCH anchors at the standard spacing (11 inches) ONLY!
Angle is...
User Guide - Page 19
... Belt under the front edge of the Carrier. Put the vehicle belt in Pull Strap Storage Pocket. When not using a non-locking vehicle belt.
Storing LATCH
Insert LATCH Connectors into
vehicle seat. INSTALLATION USING LATCH
Uninstalling Base
1
Remove Carrier from Base
1 Loosen LATCH by lifting the LATCH Release Lever and pulling Base away...
User Guide - Page 20
... to adjust angle
of seat pad, while removing from
1
Harness Slots as described in cold water on Carrier MUST
be LEVEL with floor. Be sure to contact your airline ...
be TIGHT.
INSTALLATION IN AIRCRAFT
This Child Restraint is certified for use Carrier without the Seat Pad.
39 Installing the Seat Pad Reverse the removal instructions to dry. Carefully follow instructions in ...
User Guide - Page 21
... parts are available for your Child Restraint.
Cleaning Harness and LATCH Straps Sponge clean using warm water and mild soap. DO NOT USE BLEACH, solvents, or household cleaners, as they may weaken the straps.
Cleaning Plastics Sponge clean using warm water and mild soap.
To order replacement parts, call:
Chicco Customer Service 1-877...
Similar Questions
How Do I Order A Replacement Cover For My Chicco Car Seat
(Posted by kefoxra 9 years ago)
How Much Are Chicco Car Seat Replacement Covers?
(Posted by gekaco 10 years ago)
How Much Are Chicco Keyfit 30 Replacement Covers
(Posted by sughoff 10 years ago)
How Can I Tell If My Keyfit Carseat Is A 22 Model Or A 30?
I have a Keyfit 22 and 2 bases. I just purchased a Keyfit 30 off craigslist, but the warning tags wh...
I have a Keyfit 22 and 2 bases. I just purchased a Keyfit 30 off craigslist, but the warning tags wh...
(Posted by Anonymous-65398 11 years ago)
Where To Purchase Replacement Cover For Keyfit 30 Car Seat?
I am wanted to change the color/ pattern on my chicco keyfit 30 car seat. Where can I purchase a rep...
I am wanted to change the color/ pattern on my chicco keyfit 30 car seat. Where can I purchase a rep...
(Posted by abridges 13 years ago)