2011 Chevrolet Cruze Support Question
2011 Chevrolet Cruze Support Question
Find answers below for this question about 2011 Chevrolet Cruze.Need a 2011 Chevrolet Cruze manual? We have 1 online manual for this item!
Question posted by elmraspe on December 11th, 2013
How To Remove Headlight Bulb Chevy Cruze
The person who posted this question about this Chevrolet automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 1
2011 Chevrolet Cruze Owner Manual M
In Brief ...1-1 Instrument Panel ...1-2 Initial Drive Information ...1-4 Vehicle Features ...1-15 Performance and Maintenance ...1-19 Keys, Doors and Windows ...2-1 Keys and Locks ...2-2 Doors ...2-8 Vehicle ...
Owner's Manual - Page 2
2011 Chevrolet Cruze Owner Manual M
Driving and Operating ...9-1 Driving Information ...9-2 Starting and Operating ...9-16 Engine Exhaust ... Conversions and Add-Ons ...9-50 Vehicle Care ...10-1 General Information ...10-2 Vehicle Checks ...10-4 Headlamp Aiming ...10-28 Bulb Replacement ...10-28 Electrical System ...10-34 Wheels and Tires ...10-40 Jump Starting ...10-78 Towing ...10-81 Appearance...
Owner's Manual - Page 3
... concessionnaire ou à l'adresse suivante: Helm, Incorporated P.O. Litho in this manual including, but not limited to, GM, the GM logo, CHEVROLET, the CHEVROLET Emblem, and CRUZE are options that may or may not be obtained from your vehicle. Introduction
This manual describes features that you did not purchase or due to...
Owner's Manual - Page 34
... is open the trunk. The horn sounds and the turn signal indicators may flash and/or the horn may also arm the theft-deterrent system. Remove the used battery by prying with this vehicle will unlock. See "Unlock Feedback" under Vehicle Personalization on the back of the transmitter by pushing on...
Owner's Manual - Page 40
... while exiting with the correct key. The vehicle is automatically immobilized when the key is damaged. The vehicle may not start if the key is removed from the ignition. Arming the System
To arm the system, use the power door lock switch or the RKE transmitter to be activated. The system...
Owner's Manual - Page 45
.... Release of the window when closing and the window continues to auto-reverse, it , and the window goes down all the way, release it is removed.
Obstacle Detection Feature
If equipped with the ignition in ON/RUN by pushing or pulling the switch. Programming the Power Windows
If the battery on...
Owner's Manual - Page 48
... an issue with sunroof operation, noise, or plugging within the water drainage system. Do not remove grease from the sunroof. Initializing the Sunroof If the sunroof cannot be fully closed . 2. ...10 seconds after the sunroof has fully closed , or the express open the sunroof and remove any resistance during automatic closing, it will automatically close sunroof switch to be released when the...
Owner's Manual - Page 51
... the handle at the front of the vehicle if you do not want to be sure it is not moving . Slide the seat to be removed. The sudden movement could startle and confuse you, or make you push a pedal when you try to adjust a manual driver seat while the vehicle is...
Owner's Manual - Page 70
Place the guide over the belt, and insert the two edges of the belt into the slots of the seat. Remove the guide from the neck and head.
2. 3-22
Seats and Restraints
There is one guide, if equipped, for some adults. If not, they are available ...
Owner's Manual - Page 71
... be close to take belt restraining forces.
3. The belt should go over the shoulder and across the chest. To remove and store the comfort guide, squeeze the belt edges together so that the safety belt can be seriously injured. Be ... and not falling off of it lies flat. The person wearing the belt could be removed from the guide. These parts of the belt is not twisted and it .
Owner's Manual - Page 83
... and passenger knee airbag, the off . 2. Everyone in a rear-facing infant seat.
If the On Indicator is Lit for more information, including important safety information.
.
.
.
. Remove the child restraint from the vehicle.
.
Owner's Manual - Page 84
... directions provided by the child restraint manufacturer and refer to make sure that person is sitting in the vehicle, and check with legs comfortably extended. 5. Remove any additional material from the seat such as blankets, cushions, seat covers, seat heaters, or seat massagers. 3.
Turn the vehicle off . Restart the vehicle and...
Owner's Manual - Page 99
... vehicle anchor to the child restraint instructions and the following steps: 2.1. See "Head Restraint Removal and Reinstallation" at the proper anchor location. This may be attached, attach and tighten the...the safety belts. If the child restraint manufacturer recommends that the top tether be removed. If necessary, move buckled safety belts to attach the child restraint at the end...
Owner's Manual - Page 100
... a rear outboard seating position with an adjustable head restraint, or in the center seating position without a headrest, or the rear outboard head restraint has been removed, route the single tether over the seatback. Route, attach, and tighten the top tether according to the child restraint instructions and the following instructions:
.
.
Owner's Manual - Page 274
...vehicle is installed could damage the windshield. Remove the wiper blade. Aim adjustment to the low-beam headlamps may be sure to a dealer for wiper blade replacement. Bulb Replacement
For the proper type of the...taken to get an acoustic windshield so you (for vertical aim). For any bulb‐changing procedure not listed in a crash, the headlamp aim may be re-aimed, it from...
Owner's Manual - Page 275
... pulling straight back. 5. Vehicle Care
High‐Beam Headlamp/ Low‐Beam Headlamp and DRL
1. Remove the parking/turn signal lamp bulb socket from the headlamp assembly by turning counterclockwise. Be sure the connector release (B) locks into place. 2. Remove the connector retaining tab (A). 7. Open the hood. Disconnect the wiring harness connector from the...
Owner's Manual - Page 276
...assembly by turning counterclockwise and pulling straight out. Remove the bulb socket (B) by turning clockwise. Open the trunk.
2. Trunk Deck Inboard Taillamps 1. Remove the trunk deck trim cover (A). 3. 10-30
Vehicle Care
Taillamps, Turn Signal, Sidemarker, Stoplamps, and Back-Up Lamps
3. Remove the bulb (A) from the bulb socket. 4. Install the new bulb in the bulb socket. 5.
Owner's Manual - Page 277
Turn Signal Lamp D. Remove the bulb from the socket (A). 5. Install the bulb socket by turning clockwise. 7. Install the trunk deck trim cover. Stop Lamp/Taillamp C. Sidemarker Lamp To replace any one of these bulbs: 2. Install the new bulb in the bulb socket. 6. Open the two screw covers. Back-up , and Sidemarker Lamp 1.
Vehicle Care
10-31
Stoplamp...
Owner's Manual - Page 278
... Lamp C. Sidemarker Lamp B. Stop Lamp/Taillamp D. Remove the bulb socket from the grommets. Install a new bulb into the taillamp assembly by turning it straight back until the two posts disengage from the taillamp assembly by turning it clockwise. Install the bulb socket into the bulb socket. 7. A. Back-up Lamp 5. Remove the two screws, which secure the...
Owner's Manual - Page 279
... lamp assembly by turning clockwise into the socket. 1. Remove the two screws from the license plate lamp assembly. 5.
Push the new bulb into the license plate lamp assembly. 6. Install the bulb socket by using the two screws to secure. Turn the bulb socket counterclockwise and pull the bulb straight out of the socket. 4. Vehicle Care...
Similar Questions
