2007 Chevrolet Avalanche Support Question
2007 Chevrolet Avalanche Support Question
Find answers below for this question about 2007 Chevrolet Avalanche.Need a 2007 Chevrolet Avalanche manual? We have 1 online manual for this item!
Question posted by whatsysnc on December 15th, 2013
Chevy Avalanche Vibration When Accelerating
The person who posted this question about this Chevrolet automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 1
2007 Chevrolet Avalanche Owner Manual
Seats and Restraint Systems ...7 Front Seats ...9 Rear Seats ...18 Safety Belts ...20 Child Restraints ...43 Airbag System ...70 Restraint System Check ...87 Features ...
Owner's Manual - Page 3
... A First Printing
©
2006 General Motors Corporation. Box 07130 Detroit, MI 48207 GENERAL MOTORS, GM, the GM Emblem, CHEVROLET, the CHEVROLET Emblem, and the names AVALANCHE and Z71 are registered trademarks of what is in U.S.A. How to Use This Manual
Many people read the owner manual from : Helm, Incorporated P.O.
This manual...
Owner's Manual - Page 124
..., you . When the engine starts, let go down as it is stopped. 1. Notice: Do not try to shift to LOCK. With your foot off the accelerator pedal, turn the ignition key to PARK (P) only when your vehicle is an easy target for up and lubricates all moving , use NEUTRAL (N) only. The...
Owner's Manual - Page 125
...;18°C), do the same thing, but this : 1. If you do not, your foot off the accelerator pedal, turn the ignition key to START and hold the key in your engine in START. If the engine...up to the floor and holding it there as you hold it there up on the accelerator pedal. When starting your vehicle. it exceeds the maximum cranking time allowed, approximately 15 seconds to ...
Owner's Manual - Page 127
... on the outside temperature, the kind of extension cord could be damaged. If the cord will be sure to unplug and store the cord as accelerating from moving engine parts. When greater power demands are required, such as it was before to achieve better fuel economy. When less power is located...
Owner's Manual - Page 130
...will be used for passing, and you are: • Going less than THIRD (3) without using your accelerator pedal about halfway down. • Going about 35 mph (56 km/h), push your brakes. You can ...;rst gear until the vehicle is going slowly enough.
130 If you need more , push the accelerator all the way down steep mountain roads, but then you are trying to FIRST (1) and SECOND ...
Owner's Manual - Page 131
... clutch operation is normal. The button is approximately 64°F (18°C) your torque converter clutch will resume. When stopping on a hill using only the accelerator pedal may damage the transmission. Notice: Spinning the tires or holding the vehicle in one place on a hill, use this feature to enable or disable...
Owner's Manual - Page 132
... steering system. Notice: Driving on clean, dry pavement in Four-Wheel-Drive High or Four-Wheel-Drive Low for extended periods of time may experience a vibration in Four-Wheel-Drive High or Four-Wheel-Drive Low for an extended period of time.
Some delay for extra traction. Read the part that...
Owner's Manual - Page 211
... system. SET − (Set/Coast): Press this button to set the speed or make the vehicle decelerate.
[ (Cancel): Press this button to make the vehicle accelerate or resume to safely use it again, you may turn off .
When you are located on page 363. With cruise control, you can maintain a speed...
Owner's Manual - Page 212
...− button located on the steering wheel and release it . But you do this, you want to use cruise control. 1. Take your foot off the accelerator. 212
Increasing Speed While Using Cruise Control
To increase the cruise speed while using cruise, you might hit a button and go into cruise when you...
Owner's Manual - Page 213
..., and the steepness of cruise control. Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to maintain the vehicle's speed. Erasing Speed Memory
When you may have to the... the cancel button on the steering wheel. • Press the On/Off button on the accelerator pedal to increase your cruise control set cruise speed.
When going up steep hills, you turn...
Owner's Manual - Page 223
... for 3 seconds and then stay lit to keep your dealer. • Other conditions that URPA is damaged, the URPA system may affect system performance include vibrations from a jackhammer or the compression of mud, dirt, snow, ice, and slush. If the DIC still displays the PARKING ASSIST OFF message after cleaning the...
Owner's Manual - Page 252
... soon as possible. If the Light is Flashing
The following may prevent more serious damage to your vehicle: • Reducing vehicle speed • Avoiding hard accelerations • Avoiding steep uphill grades • If you are towing a trailer, reduce the amount of water? The diagnostic system can determine if the fuel cap...
Owner's Manual - Page 253
... notice this inspection if the check engine light is warmed up , stalling when you put the vehicle into gear, misfiring, hesitation on acceleration, or stumbling on acceleration. (These conditions may take several days of the proper fuel to pass this inspection if the OBD (on page 443. Here are some...
Owner's Manual - Page 272
If this message is on, but acceleration and speed may be reduced. FUEL LEVEL LOW
If the fuel level is low, this message will display and a chime will also display when the ... page 468 for more information.
HOOD OPEN
If the hood is in performance, proceed to your dealer for service as soon as possible. Check to accelerate.
Owner's Manual - Page 360
... page 363. and the amount of the vehicle; All three systems have to decide to go where you are the brakes, the steering, and the accelerator. That is wet, dry, or icy; Then you have to do alcohol, drugs, and frustration. Sometimes, as two or three seconds or more of those...
Owner's Manual - Page 361
... down. Avoid needless heavy braking. The lights and chime will check itself. But you will help prevent a braking skid. Some people drive in spurts - heavy acceleration followed by a 10-second chime. See your vehicle's performance.
Owner's Manual - Page 363
..., the system performs several diagnostic checks to ensure there are no traction and the other does, this feature, it may hear or feel the brakes vibrate, or you may be equipped with the StabiliTrak® system which combines antilock brake, traction and stability control systems and helps the driver maintain directional...
Owner's Manual - Page 366
... problem does not clear itself after restarting the vehicle, you may hear a noise or vibration. It will activate and the StabiliTrak® light will automatically disengage. This can spin ... be covered by applying brakes to each individual wheel (brake-traction control) as heavy acceleration while turning or abrupt upshifts/ downshifts of the transmission. When road conditions allow the...
Owner's Manual - Page 367
...your front wheels are steering through a sharp curve.
While you are based on the accelerator pedal, steer the vehicle the way you are straight ahead. If there is no traction...Under less favorable conditions you can get in the same direction. Both control systems - steering and acceleration - have ever tried to go , and slow down. What should adjust your speed. The traction...
Similar Questions
How To Change Chime Volume On 2007 Chevy Avalanche
(Posted by meliMel37 9 years ago)
How To Tighten A Belt On A 2007 Chevy Avalanche
(Posted by fanHugo 9 years ago)
2005 Chevy Avalanche 1500 Lt Z71
Number and location of the lubracation zerks for a 2005 Chevy Avalanche 1500 LT Z71
Number and location of the lubracation zerks for a 2005 Chevy Avalanche 1500 LT Z71
(Posted by tlstewart42 10 years ago)