2005 Chevrolet SSR Pickup Support Question
2005 Chevrolet SSR Pickup Support Question
Find answers below for this question about 2005 Chevrolet SSR Pickup.Need a 2005 Chevrolet SSR Pickup manual? We have 1 online manual for this item!
Question posted by brmelu on August 11th, 2014
How To Install A Windscreen On A 2005 Chevy Ssr
The person who posted this question about this Chevrolet automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 1
2005 Chevrolet SSR Owner Manual
Seats and Restraint Systems ...1-1 Front Seats ...1-2 Safety Belts ...1-6 Child Restraints ...1-19 Airbag System ...1-38 Restraint System Check ...1-51 Features and Controls ...2-1 Keys ...2-3 Doors ...
Owner's Manual - Page 2
... manual in the back of the manual.
Box 07130 Detroit, MI 48207 GENERAL MOTORS, GM, the GM Emblem, CHEVROLET, the CHEVROLET Emblem and the name SSR are on the road.
Owner's Manual - Page 36
... the LATCH system. Lower Anchorages and Top Tethers for Children (LATCH System)
Your vehicle is located in the passenger seat. This system, designed to make installation of child restraints easier, does not use another vehicle anchor to secure the restraints.
Lower Anchorage B.
Owner's Manual - Page 37
... that restraint, and also the instructions in the seat, where the seatback meets the seat cushion.
1-31 {CAUTION:
If a LATCH-type child restraint is properly installed using the anchorage points, or use the LATCH system in your vehicle, you in locating the anchors for that a LATCH-type child restraint is not...
Owner's Manual - Page 89
... the following two conditions: (1) this device may not cause harmful interference, and (2) this equipment. When programming a garage door, it is recommended that a new battery be installed in your hand-held transmitter for quicker and more accurate transmission of the radio frequency. It is advised to have the "stop and reverse" feature...
Owner's Manual - Page 95
... 2. Insert the convertible top release tool and turn it to remove the cargo cover. 1. These plugs have been installed to keep dust and water from entering into the cargo bed. See your dealer if the convertible top release tool... in the glovebox. Removing the Cargo Cover
Do not remove the factory installed drain plugs located on the inside front of the bed, if equipped. 2. Open the tailgate.
Owner's Manual - Page 98
...oor tracks may have covers that can be removed so that can be used to install accessories in the cargo area of the floor track.
2-40 To install the floor track covers, follow these steps: 1. See Tailgate on available ... Tracks
Your vehicle has floor tracks and side rails that available accessories can be installed if the optional cargo compartment trim is ordered.
Owner's Manual - Page 99
... forward. 5. Insert the cover into the floor track and slide it rests against the endcap. 7. To remove the floor track covers, reverse the installation procedure. Reinstall the floor track fastener and endcap by attaching them to the Velcro® strips located in the carpeted cargo area. 2-41 Slide...
Owner's Manual - Page 100
...ends of the side rails use this for instructions. Once the cargo net system has been installed, the side-saddle storage bins can be removed to attach the cargo net to help ...following: 1. Removable Endcaps Shown 2.
If your vehicle has the side-saddle storage bins installed, remove the bins before installing the cargo net. If your vehicle has an access slot on page 2-47 for attachment...
Owner's Manual - Page 104
Install and tighten a D-ring into each hole on the driver's side of the cargo net to the telescoping cross bar as shown.
2-46 Using other end ...
Owner's Manual - Page 105
... the cross bar as shown to the tracks on either side of the cargo net. The cargo net system can be removed by reversing the installation procedure.
Owner's Manual - Page 106
...rst be removed for instructions.
2-48 Locate and remove the endcap on page 2-40 for installation. 2. If your vehicle has an access slot on the forward end of the side ...a locking tab into the forward end of the side rail. To install the side-saddle storage bins, do not need to be removed before continuing the installation of the side-saddle storage bins. If your vehicle has an acces ...
Owner's Manual - Page 109
... To remove the storage bin(s), reverse the previous steps.
See Loading Your Vehicle on the storage bin. Install the locking lid on page 4-29 for more information.
8. Each storage bin is delivered with the side-... and locking plate and loosely tighten it to the proper load limits. Be sure to install the other D-rings will not work because the studs will be too long and the ...
Owner's Manual - Page 110
... Bumper The vehicle may have a bevelled notch (B) above the seat's inboard protective cap (C). The correct seatback bumpers have a windscreen (A) installed to the rear of each seat to remove the bumpers completely. 6. Remove the windscreen from the bumpers. 5. Bevelled Notch in its protective bag. 3. The convertible roof can be fully retracted and the seats...
Owner's Manual - Page 137
... release it or keep other than the cigarette lighter in blown vehicle or adapter fuses. Do not hang any electrical equipment to follow the proper installation instructions included with your warranty. Ashtrays and Cigarette Lighter
Your vehicle has an ashtray and cigarette lighter.
Owner's Manual - Page 143
... on the driver's door to show the old mileage reading when the new odometer was installed. If the new one can tell you how far your trip odometer, Trip A, and... Trip B functions. The trip information button toggles to the mileage total of your vehicle needs a new odometer installed. Trip Odometer
The trip odometer can be set to display your vehicle has been driven since you last set...
Owner's Manual - Page 152
... the engine. If so, your dealer for service as soon as it is safe to fully install the cap. If the Light is Flashing
The following may prevent more serious damage to your vehicle...You may be wet. A few driving trips with the cap properly installed should turn the light off . Turn the key off or improperly installed. Did you just drive through a deep puddle of cargo being hauled ...
Owner's Manual - Page 231
...;c Tire and Loading Information label is very important to know how much weight it can shorten the life of all occupants, cargo and all nonfactory-installed options. Two labels on page 5-52 and Inflation - Tire Pressure on tires and in kilograms and pounds. Loading Your Vehicle
It is attached...
Owner's Manual - Page 236
... covered by your disabled vehicle towed. Remember not to have your warranty. The repairs would not be covered by your vehicle before you buy and install the new equipment.
Owner's Manual - Page 242
Installing the Ball Rod
To install the ball rod do the following:
2. Remove the cover of the housing located behind the license plate area by pushing in the tabs and pulling downward.
4-40 Unlock using the key. 1. Be sure the unit is unlocked before pretensioning.
