2003 Chevrolet Venture Support Question
2003 Chevrolet Venture Support Question
Find answers below for this question about 2003 Chevrolet Venture.Need a 2003 Chevrolet Venture manual? We have 1 online manual for this item!
Question posted by Braloa on February 28th, 2014
Chevy Venture Wipers Won't Return To Off Position
The person who posted this question about this Chevrolet automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 2
The 2003 Chevrolet Venture Owner
Seats and Restraint Systems ...1-1 Front Seats ...1-3 Rear Seats ...1-7 Safety ... Service ...5-3 Fuel ...5-5 Checking Things Under the Hood ...5-10 All-Wheel Drive ...5-50 Bulb Replacement ...5-52 Windshield Wiper Blade Replacement ...5-58 Tires ...5-60 ...5-86 Appearance Care Vehicle Identification ...5-94 Electrical System ...5-95 Capacities and Specifications ...
Owner's Manual - Page 3
Box 07130 Detroit, MI 48207
GENERAL MOTORS, GM, the GM Emblem, CHEVROLET, the CHEVROLET Emblem and the name VENTURE are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it will be there if you need it .
In ...
Owner's Manual - Page 15
... on the seatback to check that it is locked down on the rear of the seat. Push and pull on page 1-82.
4. To return the seat(s) to the normal position, do the following:
1. The second row (40/60) sections can be adjusted forward or rearward individually.
2.
Push the seat back and firmly...
Owner's Manual - Page 18
... the Split Bench Seat
Make sure the seatback is in the upright position, unhook the side attachment for the safety belt. to release the rear latches ...the seatback
L
101 waru.
-..--A
1-11 This mini-buckle is folded all the way forward.
3. To return the seatback to an upright position, pull on the nylon strap or lift the recliner lever without putting any pressure on the right side of ...
Owner's Manual - Page 25
...the seat fully rearward.
3. Removing the Bucket Seats
Make sure the seatback is in the upright position.
Slide the seat all the way back by lifting either one of the seat to fold the...back on the seatback.
The head restraints should be sure it locks upright. To return the seatback to an upright position, pull on the nylon strap or lift the recliner lever without putting any pressure ...
Owner's Manual - Page 143
... ignition switch. Shift to PARK (P) only when your ignition, steering wheel and transaxle. E (START): This position starts the engine. The switch will return to RUN for driving. Notice: If your key seems stuck in ? This is the position for normal driving.
2-32 To restart when you're already moving .If you do, you...
Owner's Manual - Page 155
... will fold almost flush with the vehicle. This feature is particularly useful in a comfortable driving position. If you are sitting in automatic car washes. Both outside rearview mirrors.
2-44
To return the mirror to select the passenger's side rearview mirror. Turn the control counterclockwise to select the driver's side rearview mirror, or...
Owner's Manual - Page 190
... the steering column includes the following: Turn and Lane-Change Signals Headlamp High/Low-Beam Changer Flash-to-Pass Windshield Wipers iiv'indshieid -Washer Then move the steering wheel to a comfortable position and release the lever to lock the wheel in place.
0
Cruise Control
3-7 Horn
You can raise it to the highest...
Owner's Manual - Page 191
To signal a turn is finished, the lever will return automatically. When the turn , move the lever all the way up or down. An arrow on page ...more than 3/4mile (1.2 km), a chime will flash in fog is left ) positions. These positions allow you to make sure they are on, this light on the instrument panel cluster will return by itself when you signal a turn it back on. Turn and Lane-Change...
Owner's Manual - Page 213
... airflow through the rear floor outlets, place the left rear seat is the cold air return outlet. For more information on how to use the temperature controls located on to direct cooled...the overhead rear-control panel, behind the left bucket seat in the second row in the forward position. To increase or decrease the temperature for the entire vehicle, use the main climate control system...
Owner's Manual - Page 216
...box. For more information on ventilation, see "Climate Controls" listed previously in the forward position. Be sure to the rear-seating area. The outlet behind the left bucket seat in ... the index. The access panel for the passenger compartment air filter is the cold air return outlet. Po replace the filter, do the following:
Passenger Compartment Air Filter
Passenger compartment air...
Owner's Manual - Page 246
Press AM FM to the middle position, select BAS or TRE. If a station is weak or noisy, you return to your favorite stations.
Then press and hold the up to 18 stations ... Then press and hold the AUDIO button for the display to return to time of day. To adjust both tone controls and both speaker controls to the middle position, first end out of the six numbered pushbuttons until you hear...
Owner's Manual - Page 247
....
Radio Messages
CAL (Calibration): Your audio system has been calibrated for service. You must be returned to time of day. To adjust balance or fade to the dealership for your vehicle and must return to the middle position, select BAL or FAD.
CEN will appear on the display.
3-64
To adjust both tone...
Owner's Manual - Page 249
The display will hear one beep. If a station is weak or noisy, you return to the middle position. Press BAND to decrease the treble. is displayed. PSCAN (Preset Scan) b : ...for more than two seconds and the radio will return and the bass and treble equalization that best suits the type of station you set up to the middle position, push and hold one beep. Setting the Tone ...
Owner's Manual - Page 256
... and hold the AUDIO knob. To adjust all tone and speaker controls to the middle position, push and hold one beep and adjust the display level to the middle position. The radio will produce one of station you return to your favorite stations.
If a station i weak or noisy, you selected will also be...
Owner's Manual - Page 260
... v dl II - Press EJT to playing speed. SEEK and a positive number will increase the number of selections to be in this pushbutton again to return to playing speed. You may not be searched back, up to 30... TAPE and an arrow showing which side of the current selection, depending upon the position on the display. The radio will continue moving forward through the tape. If you...
Owner's Manual - Page 265
.... The radio will appear on .
2. To adjust all tone and speaker controls to the middle position, push and hold the AUDIO knob. The radiowill produce one of station selected. 5. PRESET SCAN .... The radio will appear on the display.
Whenever you press that numbered pushbutton, the station you return to your pushbuttons, play for a few seconds, then go on to the next preset station. ...
Owner's Manual - Page 266
..., display messages from these stations and will adjust the display level to the middle position. RDS stations may broadcast incorrect information that broadcast RDS information. AUTO EQ (Automatic ...In rare cases, a radio station may also provide the time of the frequency. To return to the middle position, select balance or tade and pusn ana noia rile AUDIO knob.
of day, a...
Owner's Manual - Page 380
... from the vehicle with the good battery.
4. Return the remote positive (+) terminal cover to its original position. Disconnect the black negative (-) cable from the other vehicle.
5.
Disconnect the red positive (+) cable from the vehicle that had the dead battery. 2. L
~~~~ ~
Jumper Cable Removal
A. Dead Battery or Remote Positive (+) Terminal
5-49 To disconnect the jumper...
Owner's Manual - Page 389
While holding the wiper arm away from the glass, push the release clip from the windshield or ...wiper arm away from under the blade.
5-58 To remove the windshield wiper blade(s):
1. Turn the wipers on to OFF while the wipers are removed in At Least Twice a Year on page 5- 104. Windshield Wiper Blade Replacement
Windshield wiper blades should be inspected at the outer position...
Similar Questions
Electrical Issues Of My 2003 Chevy Venture Lt
My 2003 chevy venture lt has started having issues with the parking lights will not shut off and wil...
My 2003 chevy venture lt has started having issues with the parking lights will not shut off and wil...
(Posted by Lillithlette2 1 year ago)
How Do I Keep Snow/ice Off My Chevy Venture Wipers?
(Posted by riccrg 9 years ago)
How To Calibrate Windshield Wipers On A 2003 Chevy Venture
(Posted by mykalaxela 10 years ago)
Where Is The Wiper Speed Module Located On 2003 Chevy Venture
(Posted by leolyuu 10 years ago)
Chevy Venture 1999 Will Not Start After I Parked. What Could Cause This?
Chevy venture 1999 will not satrt again after being parked. When the ignition is turned on, the secu...
Chevy venture 1999 will not satrt again after being parked. When the ignition is turned on, the secu...
(Posted by olugbenja 11 years ago)