2002 Chevrolet Suburban Support Question
2002 Chevrolet Suburban Support Question
Find answers below for this question about 2002 Chevrolet Suburban.Need a 2002 Chevrolet Suburban manual? We have 1 online manual for this item!
Question posted by evilsmurfet on July 18th, 2013
Expansion Valve
Where is the second expansion valve located ?
Current Answers
Answer #1: Posted by sabrie on July 18th, 2013 10:31 PM
sabrie
Member since:
May 23rd, 2013 Points: 3,306,778
Member since:
May 23rd, 2013 Points: 3,306,778
Hi there. Check out this video it might help you.
rtsp://v5.cache7.c.youtube.com/CjYLENy73wIaLQkQm3pytlHq6hMYESARFEIJbXYtZ29vZ2xlSARSBXdhdGNoYK-K3M2GzbP0UQw=/0/0/0/video.3gp
rtsp://v5.cache7.c.youtube.com/CjYLENy73wIaLQkQm3pytlHq6hMYESARFEIJbXYtZ29vZ2xlSARSBXdhdGNoYK-K3M2GzbP0UQw=/0/0/0/video.3gp
www.techboss.co.za
Answer #2: Posted by linkshahzad on July 18th, 2013 10:49 PM
linkshahzad
Member since:
June 12th, 2013 Points: 60,030
Member since:
June 12th, 2013 Points: 60,030
- Recover the refrigerant.
- Raise and support vehicle.
- Remove the A/C line block fitting bolt.
-
Separate the line block fitting, remove and discard the O-ring seal, and cap or tape the A/C line to prevent contamination of the refrigerant system.
-
Lower the vehicle.
- Remove the left side rear quarter trim
-
Remove the nut from the line block fitting at the thermal expansion valve.
- Carefully remove the A/C lines from the thermal expansion valve and pull the lines up through the floor of the vehicle.
- Remove and discard the O-ring seals and cap or tape the lines to prevent contamination.
-
Remove the bolts from the thermal expansion valve that were exposed by removal of the line block fitting.
Related Manual Pages
Owner's Manual - Page 9
... a pedal when you don't want it with your vehicle has a manual bucket or a split bench seat, you try to move the seat with this lever located at the front of the vehicle if you can lose control of the seat. Try to adjust a manual driver's seat while the vehicle is moving .
Owner's Manual - Page 10
If your vehicle has a lumbar adjustment, the knob is located on the outboard side of the seat, move the lever up or down in a continuous...turning the knob.
1-3 Manual Cushion Tilt (If Equipped)
Manual Lumbar Control (If Equipped)
If your vehicle has this lever located at the inside edge of the vehicle. To raise or lower the front of the seat cushion.
To increase or decrease support...
Owner's Manual - Page 11
... control forward or rearward. D Moving the whole horizontal control up or down
If your vehicle has a power seat, you can adjust it with these controls located on the outboard sides of the seats.
Move the reclining front seatback rearward or forward by moving the control toward the rear or the front...
Owner's Manual - Page 12
...and, within five seconds, press one of the seat. To recall your vehicle has this feature, the four-way control is located on the outboard side of the two numbered buttons on the memory control.
1-5 To program the seat position for more lateral... control. Adjust the driver's seat to program and recall the driver's seat and recliner position are located on the driver's door trim panel.
Owner's Manual - Page 13
... indicator light will need to an upright position. To adjust the front seatback, lift the manual lever located on the driver's door panel. If your vehicle has power seats with a power recliner, see ...without pushing on how to operate.
Release the lever to control the driver's heated seat is located on the outboard side of the seat. The button used to lock the seatback where you...
Owner's Manual - Page 16
... passengers to use when the seat is folded and will automatically fold rearward to allow a flat load floor for cargo or entry to adjust the location of the seat and that it is returned to the person sitting there. On Tahoe/Yukon models the rear seatbacks may have to the third...
Owner's Manual - Page 18
... position, and not reclined. In order to fold the back of the back. 2.
Release the lever to the person sitting there.
Pull forward the lever located at the base of a bucket seat into a horizontal load floor, the back must be in a sudden stop or crash. If you pull the lever without...
Owner's Manual - Page 19
... the button on the side of the seat cushion and pull the seat cushion up on the head restraint. 3. Pull up on the strap loop located at the rear of the head restraint guide cap and lift up . If the seatback cannot fold flat because it interferes with rear bucket seats...
Owner's Manual - Page 20
That could move forward in a sudden stop or crash. up on the release lever labeled 1 and then pull up on the release lever, labeled 1, located on the latches. 2. D To return the seat to the passenger position, pull
Push forward on the seatback until the seatback locks into position.
1-13 Always ...
Owner's Manual - Page 21
... Enter the rear cargo area of the seat up on the seat.
Push and pull on the lever located under the carrying handle at the rear of the seat on the seatback to create a flat load floor....CAUTION:
If the seatback isn't locked, it is fully engaged in place using the support rod located on the underside of the seat labeled 2. 4. Tilting the 50/50 Split Bench Seat
Once the third seatback has...
Owner's Manual - Page 195
... the defogger off after several minutes. Your vehicle's ventilation system supplies outside air to direct outside air through the vehicle, and out the air exhaust valves. NOTICE:
Don't use the vent setting to the inside of your vehicle is running, unless you need additional warming time, press the button again. The...
Owner's Manual - Page 305
Jack Handle Extensions D. Valve Stem, Pointed Up F. Hoist Cable I. Hoist Shaft E. Hoist End of Extension Tool
5-22 Hoist Lock J. A. Wheel Wrench C. Hoist Assembly B. Spare Tire G. Tire Retainer H. Hoist Shaft Access Hole K.
Owner's Manual - Page 315
... seated in the rear bumper and into the hoist shaft. 4. Make sure the retainer is fully seated across the underside of the vehicle with the valve stem pointed upward. 2. Raise the tire fully against the underside of the vehicle. Push, pull, and then try to tighten the cable. Raise the tire...
Owner's Manual - Page 316
... of the jack onto the pin in the mounting bracket. Jack Handle Extensions D. Then, assemble wheel chocks and bottle jack together with the wing nut. 3. Valve Stem, Pointed Up F. Wheel Wrench C.
Owner's Manual - Page 338
... you're through.
6-17 See "Engine Compartment Overview" in the Index for the VORTEC 4800, 5300, 6000 and 8100 V8 engines is located on the engine valve cover, on location. 8100 Engines All Other Engines Be sure to fill it enough to put the level somewhere in the proper operating range. The engine...
Owner's Manual - Page 358
... clean as well as washer fluid. Don't use washer fluid. If it is located in the Index for the location of the vehicle. D
D
Your brake master cylinder reservoir is leaking out of the... water. NOTICE:
D When using concentrated washer fluid, D
follow the manufacturer's instructions for expansion if freezing occurs, which could damage the tank if it is that sooner or later your...
Owner's Manual - Page 371
NOTICE:
Don't let anyone tell you that underinflation or overinflation is on the valve stems. They help prevent leaks by looking at least three hours or driven no more ... sure to check tire pressure. It's not. How to Check Use a good quality pocket-type gage to put the valve caps back on the rear edge of the spare tire. You can't tell if your tires have enough air (underinflation...
Owner's Manual - Page 402
... Maintenance Replacement Parts
Replacement part numbers listed in your GM dealer. VIN Code Oil Filter* Engine Air Cleaner/Filter* Passenger Compartment Air Filter Kit** PCV Valve* Spark Plugs[[ V PF59 A1519C[ 52485513 CV948C PTJ14R15***/ PZTR5A15[[& dagger; If you have any questions, please contact your vehicle when it was built, or if you...
Owner's Manual - Page 415
Check constant velocity joints and axle seals for leaking. j Check rear/front axle fluid level and add fluid as needed. Check that the purge valve works properly, if equipped. j Rotate tires. If you drive regularly under dusty conditions, the filter may require replacement more often. An Emission Control Service. Check ...
Owner's Manual - Page 418
... listed previously and, therefore, haven't changed your automatic transmission fluid, change both the fluid and filter. j Except 8.1L V8 Engine: Inspect Positive Crankcase Ventilation (PCV) valve. Uses such as found in taxi, police or delivery service. or if the vehicle is over 8600 lbs. j Change transfer case fluid. An Emission Control...
Similar Questions
Fuse Box Location
Trying to locate fuse box inside 91 Chevy suburban
Trying to locate fuse box inside 91 Chevy suburban
(Posted by hotmama911711 1 year ago)
Fuse Box Locations On A 2001 Suburban
how meany fuse boxes are there and where are they located on a 2001 Suburban
how meany fuse boxes are there and where are they located on a 2001 Suburban
(Posted by jamesandria72 8 years ago)
Egr Valve Location On 8.1 Liter Engine
I need to replace the EGR valve on my 2500 burb. Where is it located?
I need to replace the EGR valve on my 2500 burb. Where is it located?
(Posted by clmoe5 11 years ago)