2001 Chevrolet Blazer Support Question
2001 Chevrolet Blazer Support Question
Find answers below for this question about 2001 Chevrolet Blazer.Need a 2001 Chevrolet Blazer manual? We have 1 online manual for this item!
Question posted by jlifnats70 on July 2nd, 2015
Hazard Lights And Stop Lights Do Not Work.
I have a 2001 Blazer LT 4WD. Stop Lights and Hazard Lights do not work. I have changed light bulbs, checked for blown fuses, and checked the ground wires. There was a recall on the switch back in 2002 that was repaired on this vehicle in 2003. Where is that switch located and how do I get a new one??
Current Answers
Answer #1: Posted by BusterDoogen on July 2nd, 2015 8:37 AM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,427
Member since:
October 30th, 2011 Points: 28,565,427
Check fuse # 10 the instrument panel fuse block located at the driver's end of the instrument panel.Since you checked the bulbs the switch near the brake pedal has failed. Go here for the repair visual.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Manual Pages
Owner's Manual - Page 2
Every 2001 Blazer under warranty is backed with the following services:
1-800-CHEV-USA ®
( For vehicles purchased in Canada, call 1-800-268-6800 )
that provides in an emergency:
Courtesy Transportation
Free lockout assistance Free dead-battery assistance Free out-of-fuel assistance Free flat-tire change Emergency towing
Owner's Manual - Page 56
... add-on child restraints have a label saying that come down over each of the motor vehicle. A T-shaped shield has shoulder straps that are not available, obtain a replacement copy from the manufacturer.
1-44 Q: A:
How do child restraints work? A child restraint system is a permanent part of the infant's shoulders and buckle together at the...
Owner's Manual - Page 72
... open them at any time by pressing the up arrow end of the switch. Lightly tap the switch to open the window slightly.
Press the driver's window switch down briefly to prevent passengers from operating the power windows. Lockout Switch Four-door vehicles have a lockout feature to activate the express-down feature. Swing-Out Windows (2-Door...
Owner's Manual - Page 79
...work or if you have to stand closer to your vehicle for the transmitter to 30 feet (9 m) away using the remote keyless entry transmitter supplied with your vehicle. You may notice a decrease in range. D Check...service. See the instructions that may cause undesired operation of the device. Changes or modifications to this system by other than an authorized service facility could...
Owner's Manual - Page 88
...'s window and open the door. This should be blown. If the alarm does not sound when it should, but the vehicle's headlamps flash, check to go off the alarm. However, your dealer for the SECURITY light to see "Fuses and Circuit Breakers" in the Index. PasslockR
Your vehicle is equipped with the manual door lock and...
Owner's Manual - Page 100
... front axle is for service. Press and release the 4HI switch. The indicator lights will come on, you turn on the ignition and one -half as bright as on briefly when you should take your front axle to 4LO, the vehicle must be stopped or moving less than 3 mph (4.8 km/h) with the transmission in...
Owner's Manual - Page 150
...programmed already. A rolling code system changes the code of the unit at ...-held transmitter is being transmitted. Release both buttons once the light starts to the HomeLink Transmitter.
2-82 If you cannot program... programming, the hand-held transmitter may automatically stop transmitting after 1996, the garage door opener may not work with Rolling Codes" later in this section ...
Owner's Manual - Page 160
..., though, you must drive, turn off all unnecessary accessories. Readings in either warning zone. Have the vehicle serviced as soon as possible. See "Shift Light" in the electrical system.
You can still work and stop you have a brake problem.
Brake System Warning Light
When the ignition is on the instrument panel cluster if you . The...
Owner's Manual - Page 161
... vehicle towed for service.
Anti-Lock Brake System Warning Light
With the anti-lock brake system, this section. CAUTION:
Your brake system may not be working properly if the brake system warning light ...brake system warning light is still on after you've pulled off the road and stop .
If the light comes on while you are driving, pull off the road and stopped carefully, have anti...
Owner's Manual - Page 163
... same Tire Performance Criteria (TPC) can affect your vehicle's emission controls and may cause the SERVICE ENGINE SOON OR CHECK ENGINE light to pass a required Emission Inspection/Maintenance test. If the light stops flashing and remains on , after a while, your emission controls may not work as a check to costly repairs not covered by your warranty. NOTICE:
Modifications made...
Owner's Manual - Page 166
....
Security Light
This light will come on briefly when you turn on briefly when you should come on the ignition, as a check to show...vehicle. If the vehicle fails to start, see your dealer. This system is working. Service Four-Wheel-Drive Warning Light (If Equipped)
This light should see "Passlock" in the Index for additional information regarding the SECURITY light.
The light...
Owner's Manual - Page 167
... or liftglass is on, the fuel gage tells you about how much fuel you are starting the engine. Fuel Gage
Check Gages Light
The CHECK GAGES light will come on when the tow/haul mode has been selected. If the light comes on and stays on while you are in the Index. Tow/Haul Mode...
Owner's Manual - Page 186
...stop at the beginning of the selection. Then, insert the cassette tape. The middle position balances the sound between the speakers. The tape direction arrow will blink during the SEEK operation. PROG (2): Press this button to switch...thin they may not work best with the ignition off , the tape will be on the display whenever a tape is off , press EJECT or RECALL. To load a ...
Owner's Manual - Page 201
...longer than that are so thin they may not work best with the ignition off . To load a cassette tape with tapes that are up to 30 to stop at the beginning of the center console. Once... cassette reel or until you do for the radio. Remote Cassette Tape Player (If Equipped)
A lighted tape symbol shows when a cassette tape is selected for play first. Anytime a cassette tape is inserted, ...
Owner's Manual - Page 240
... and fade. D Stop your brakes to stall when going uphill. D Shift back to keep vehicle speed under control. D Never go downhill with the transmission in a manual shift. Apply the brakes lightly when descending a hill...serious accident.
But if it happens going downhill, here's what to do all the work and could overheat and fade.
D Shift to PARK (P) (or to NEUTRAL (N) with...
Owner's Manual - Page 247
...stop and may affect your windshield wiper inserts when they can build up under your windshield washer tank filled with the road.
4-31 The water may cause pulling to separate from the inserts. They won't work... through a large puddle of the vehicle. You could lose control of water or a car wash, apply your brake pedal lightly until your vehicle is hydroplaning, it is dangerous. ...
Owner's Manual - Page 270
... when you avoid situations that the lamps and any trailer brakes are working . Following Distance
Stay at the same time. Passing
You'll need to the right. This lets you check your electrical connection at least twice as far behind the vehicle ahead as you . Making Turns
NOTICE:
Making very sharp turns while...
Owner's Manual - Page 274
... chart when connecting the wiring harness to the starter solenoid (eight-wire harness only).
D Light Green: Back-up lamps. D Yellow: Left stoplamp and turn signal. The optional heavy-duty trailer wiring is a six-wire harness assembly. The heavy-duty trailer wiring is fused in the Index. D Dark Green: Right stoplamp and turn signal. D White: Ground wire.
Store the harness...
Owner's Manual - Page 301
...a sudden stop or collision, loose equipment could damage the wheel. The spare tire hoist cannot be stored under the vehicle with the... passenger compartment of the wheel wrench, on the ground at the rear of the vehicle. Hoist Arm
CAUTION:
Storing a jack, a ...Follow this , have the wheel repaired as soon as possible.
1. Put the chisel end of the vehicle could cause injury. Spring E....
Owner's Manual - Page 383
... only helps to keep your vehicle in good working condition. See your Warranty and Owner Assistance booklet or your vehicle in this manual are important. Any damage caused by failure to keep your dealer for details. Maintenance intervals, checks, inspections and recommended fluids and lubricants as prescribed in good working condition, but also helps the...
Similar Questions
I Have A 2001 Blazer Lt 4wd. Rear Stop Lights And Hazard Lights Do Not Work.
Do the hazard lights in front affect the hazard lights and brake lights in the rear? If a hazard lig...
Do the hazard lights in front affect the hazard lights and brake lights in the rear? If a hazard lig...
(Posted by jlifnats70 8 years ago)
How Do I Get To The Thrust Bearing For A Belt Pulleyon My 2001 Chevy Blazer Lt
my 2001 chevy blazer making very loud noise, I was told it is the thrust bearing for lower belt pull...
my 2001 chevy blazer making very loud noise, I was told it is the thrust bearing for lower belt pull...
(Posted by lillianrharris 10 years ago)
Where Is A Vin Number On Chassie.blazer Lt 1997
(Posted by Anonymous-102634 11 years ago)
Where Is A Vin Number On Chassie In Blazer Lt 1997
(Posted by Anonymous-102634 11 years ago)