1998 Chevrolet Lumina Support Question
1998 Chevrolet Lumina Support Question
Find answers below for this question about 1998 Chevrolet Lumina.Need a 1998 Chevrolet Lumina manual? We have 1 online manual for this item!
Current Answers
Answer #1: Posted by TommyKervz on November 21st, 2015 6:40 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,843
Member since:
January 10th, 2013 Points: 17,776,843
See removal instructions here: http://www.justanswer.com/chevy/0xu7l-95-chevy-lumina-need-know-find.html#re.v/327/
Related Manual Pages
Owner's Manual - Page 41
Slide the guide under belt. 1. elastic The cord must be under and past the belt. Then, place guide the the over the belt, and insert the two edgesthe belt into of the seatback and interior body to remove the the guide from between the edge of the slotsof the guide.
1-31 Pull the elastic cord out from its storage clip.
2.
Owner's Manual - Page 42
.... Make sure that you can take them out from the guides. The elastic cord must be under belt and the the guide on top.
4. To remove and store the comfort guides, squeeze the belt edges togetherso that the shoulder belt crosses the shoulder. I
I
3. Be sure that the belt is not twisted...
Owner's Manual - Page 45
...of slots(B) or the lowerpair of the harness. Built-in Child Restraint (Option)
The child should also be at one year old.It is least important to Motor Vehicle Safety Standards.
A rear-facing restraint gives the infant's head, neck and body the support...m)and who weigh between22 and 60 pounds (10 and 27 kg) and whose height is about a year old. With this sectionfor more information.
Owner's Manual - Page 49
Add some slack to remove from the slot. Feed a small amountof harness slack back into the slot.
7. You'll on keep most of the harness. it
1-39 5. Twist the harness slightly to the shoulder part by pulling up the lap part. Select one side of this slack until you finishStep 9.
6.
Owner's Manual - Page 56
harness should be away from the Built-in Child Restraint
10. Adjust the positionof the harness on child's shoulder. off
1-46 Removing the Child from the child's face and neck, but not falling the child's shoulders. The the 1. On each side of the harness, the shoulder part ...
Owner's Manual - Page 57
Remove the child from the child restraint cushion.
2. Press the child restraint cushion firmly into up the seatback. 3. Unlatch the harness by pushing the button on ...
Owner's Manual - Page 59
... toward the center of the vehicle. This type of of up to restrain or position a child on a continuous flat surface. An infant car bed is removable.
1-49 the parts base stays secured the vehicle and the seat in two -- Rear-facing infant restraints are designed infants of restraint faces the rear...
Owner's Manual - Page 67
To remove the child restraint, just unbuckle the vehicle's safety belt and let go . The safety belt it will go back all the way. It's alwaysbetter to ...
Owner's Manual - Page 69
... the top strap if the child restraint has one. Here's why: in a rear-facing child restraint can be using the lap-shoulder belt. it To remove the child restraint, unbuckle the vehicle's just safety belt.It will go as the instructions say. Securing a Child Restraint in the Index.)
2.
Owner's Manual - Page 71
... to work an adult for or larger child passenger. The safety belt will move freely again and be sure is secure. Larger Children
6. it To remove the child restraint,just unbuckle the vehicle's let safety belt and it helpful to use your knee to a sit window so the child can wear...
Owner's Manual - Page 79
... to get in a safe place. Keep the plugs in . If you lose your dealer who can help prevent theft.
1
The ignition key is delivered, dealer removes the the plugs from the door keys and gives them to the first owner. But you So have a plug. I NOTICE:
When a new vehicle is the...
Owner's Manual - Page 84
... pry apart the front and back.
2.
If the transmitter does not work, try synchronizing the transmitter with the new one, it has previously been sent.
Remove the battery and replace with your receiver, (located in your dealer for about five seconds. To replace the battery:
1. make sure the halves are together...
Owner's Manual - Page 86
... features, we know that nothing we put it can make on it transmitter with you can help. However, there are ways you . it impossible to remove your vehicle and open the driver's door, 0 Lock all windows and lock your valuables outsight.
the
Parking at Night
Park in a busy, well area.
Remember...
Owner's Manual - Page 87
... may be clean and dry before trying another key during this time, you don't have to make a match. Turn ignition off. If you insert or remove the key from randomly trying different keys with different resistor pellets in an attempt to wait three minutes before it and fuel systems. For about...
Owner's Manual - Page 89
... switch, you can turn door when the ignition isin OFF, LOCK or ACC and the the key is in LOCK. OFF (C): This positionlets you can remove your engine. Ignition Positions
LOCK (B): Before you put the key the ignition into switch, the switch is off , you E can use RUN display someof your...
Owner's Manual - Page 276
... centerof the dome lamp cover at the outer positionsof the wiperpattern. Snap the cover firmlyinto place. Turn on the wipers tothe low wipe setting. 2. Remove the old bulb fiorn the small prongs extending from the dome lamp base plate; hook the new bulb onto the prongs. 3, To replace the bulb cover, center...
Owner's Manual - Page 277
.... 0 Overloading your tires have questions about your tire warranty and where to remove it from the wiper arm.
5 .
3. Push the new wiper blade securely... as a resultof too much friction. You could cause serious injury. Keep tires at the recommended pressure. 0 Worn, old tires can cause accidents.your If tread is badly worn, if your tires can cause overheating as overloaded tires. for
...
Owner's Manual - Page 297
...Box, Mix Motor, DRL Module, HVAC Control Head, Defogger Relay, (S.E.O.) Digital Speedometer Hazard Flasher R.H. Sunroof Control Unit, (S.E.O.) Accessory Feed
Fuse
12
Rating Description
Anti-Theft/PCM -- Spot Lamp (S.E.O.) Steering Wheel Control -- Steering #1 Wheel Radio Control Lighting Not Used Not Used Power Accessory#1 -- Relay
A B S -- Steering #2 Wheel Radio Controls Air Bag -- Air...
Owner's Manual - Page 299
rn
Fuse
Description
WCMPT REL Remote Trunk Release, Back-up Lamps, Remote ControlDoor Lock Receiver PCM BAT Powertrain Control Module (PCM), Fuel Pump Relay, Cont #1 and Fan #2 Relay A/C CMPR Relay Automatic Transaxle
A/c CONT
TRANS
6-61 Underhood Electrical Center Passenger's Side Some fuses are the underhood electrical ...
Owner's Manual - Page 300
...
12
13
Relay
14
15
16
Description
FUEL PUMP AIC CMPR
17
18
FAN CONT #2 -- Primary Cooling Fan (Driver's Side) IGN SYST
6-62
Fuse
F/INJN
PCM IGN
Description
Fuel Injectors Mass Air Flow (MAF) Sensor Heated Oxygen Sensor and #2 #1 Evaporative Emissions(EVAP) Canister Purge Solenoid Valve Electronic Ignition (EI) Control Module...
Similar Questions
Removing The Dash On A 93 Chevy Lumina Euro
i was wondering how to remove the dash to get to the instrument cluster ..
i was wondering how to remove the dash to get to the instrument cluster ..
(Posted by mc199774 9 years ago)
Do I Need A Specialty Tool I To Remove The Power Brake Booster Of 98 Chevy Lumin
98 Chevy Lumina with a 3.1liter
98 Chevy Lumina with a 3.1liter
(Posted by hotrod5069 10 years ago)
How To Remove The Vats From My 98 Chevy Lumina
(Posted by gustaFla 10 years ago)
What Would Cause A New Relay Not To Work But A Old Relay Can Be Ridged To Work?
what would cause a brand new relay not to work but the old one can be ridged to work on a 95 chevy l...
what would cause a brand new relay not to work but the old one can be ridged to work on a 95 chevy l...
(Posted by 1781music 11 years ago)