Calculator Will Not Work After Rethreading

• Turn off the calculator.
• Pull up on the tab on the far side of the printer cover to remove the cover.
• Pinch together the ribbon lock (the arrow shows you the direction to pinch). Lift the ribbon spools off the shafts and discard them.
• Separate the new ribbon spools. Guide the ribbon tape around the four guiding pegs and set the spools on the shafts. The spools should be peg side down.
• Rotate the spools so the peg at the bottom of the spool goes into the hole of the spool holder. Release the ribbon locks.
• Rotate the spools to make the ribbon taut, keeping the ribbon positioned around the guide pegs.
• Replace the printer cover and turn the calculator on.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!