Bosch WFMC5301UC Support Question
Bosch WFMC5301UC Support Question
Find answers below for this question about Bosch WFMC5301UC - 500 Plus Series Nexxt Washer 4 cu. Ft.Need a Bosch WFMC5301UC manual? We have 4 online manuals for this item!
Question posted by captainrob on August 18th, 2013
Dishwasher She3ar72uc/07 Shows Error Code 'e-01' What Is Meaning?
Thanks for information regarding meaning of error code "E-01"!
Current Answers
Answer #1: Posted by Odin on August 25th, 2013 1:11 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
This air flow error code refers to the dryer vent. See the solution at http://www.appliancerepairlesson.com/2011/01/12/bosch-dryer-error-e01/.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Bosch WFMC5301UC Manual Pages
Pedestal Installation Instructions - Page 2
... you need to uninstall your appliance, refer to important matters. Important Safety Information
Please read and follow these Installation Instructions along with all times during the pedestal...open end wrench 2. 6 mm Allen (Hex) wrench 3. (4) Socket Head Cap Screws and
(4) Flat Washers 4. (4) Height Adjustable Feet 5. (4) Spacers 6. Failure to move and uninstall the appliance.
i This ...
Pedestal Installation Instructions - Page 3
... protect the drum during the original setup. Support the appliance approximately 1 1/2" to laying washer on a new washer or dryer, proceed to step 3.
d CAUTION
When lifting or lowering the appliance onto ... be noticed due to 2" off the floor (see Figure 2). NOTICE
Make sure the washer transportation bolts are installing the pedestal on its LEFT side (see Figure 3). To reinstall the...
Pedestal Installation Instructions - Page 4
... other suitable protective covering flat on its side. NOTICE
If installing the pedestal to a new washer, do so can result in case the appliance needs to help align the pedestal and the ... without the pedestal. Push up towels can result in the appliance (see Figure 7). Note for Washers: Slight water spillage may be noticed due to have an assistant hold the pedestal housing during drawer...
Pedestal Installation Instructions - Page 5
... and flat washers (see Figure 10). Loosely thread all four bolts with the washers and spacers in any screws completely until all four transport bolts must be removed before
removing any of 10 ftĆlb ...bolts before using the appliance. Use the wrench to allow it passes through the flat washer, pedestal housing, then the spacer, and into the protruding threaded bushing in the base...
Pedestal Installation Instructions - Page 6
...q If the bushings do this with all 4 transport
bolt assemblies (bolt, washer and bushings) by turning it is locked against will turn the level so...the lower side. d CAUTION
To avoid risk of the 17mm wrench provided. Slide the appliance to side, then turn with the
washer and bushing attached. q A center-located bubble indicates the unit is leveled. Use the wrench provided (or a 5/8" - ...
Pedestal Installation Instructions - Page 7
...slides of the appliance to minimize vibration and movement of laundry in the machine, starting it from moving during operation....appliance during appliance use the drawer as a step. For Washers: Fine tune the leveling by freely opening and closing the...front feet against the pedestal housing.
Figure 18
6. Contact information is available in the Customer Service" section of the ...
Pedestal Installation Instructions - Page 8
... your sales receipt for future reference. Warranty Service Warranty service is installed with the listed washer or dryer and operated according to province. *Warranty terms may vary in Canada. This ...the Pedestal is subject to the Operating, Care and Installation Instructions" that came with the washer or dryer that is available by contacting the retailer where the Pedestal was purchased. If ...
Installation and Use & Care (all languages) - Page 2
...selected fabric type.
Stainless Steel Drum The Nexxt washer drum has hundreds of a button.
They...your laundry to reach the optimum temperature, which allow your washer and ...means they can be installed virtually anywhere in the house usually account for superior results. SYNCROt Technology
Manage your garments to keep the door shut. Features and Benefits of Your New Washer...
Installation and Use & Care (all languages) - Page 3
... INSTRUCTION
6
Introduction
6
Information concerning waste disposal
6
...laundry 15 Preparing the laundry 15 Sorting the laundry 15 Degrees of soiling 15 Loading the laundry 16
Laundry Detergents and Additives 16
Dispensing the correct amount of detergent 16
Filling laundry... 21
Cleaning and Care 21
Cleaning the washer 21
Descaling the washing machine 22
Troubleshooting ...
Installation and Use & Care (all languages) - Page 4
..., dry cleaning solvents, other information enclosed with any accumulated hydrogen gas. This indicates that could ignite or explode.
4. BOSCH washers are indicated in your washing ... power cord by grasping the plug, not the cord.
11. Small particles may show different details than your laundry using your household. An easy operation philosophy, a variety of this appliance a user...
Installation and Use & Care (all languages) - Page 5
...readily accessible. Removing any problems or conditions that all local codes and ordinances. To avoid damage to the floor.
38.... the end of poisoning or chemical burns, keep all laundry chemicals and aids in electric shock. Do not use...b. Precautions should be conveyed with all water connections to whether the washer is applied to the manufacturers' instructions.
29.
d WARNING d
...
Installation and Use & Care (all languages) - Page 6
... local authority about the best means of suffocation from locking themselves ...Information concerning waste disposal
Disposing of accessory parts supplied with the Canadian Electric Code... away from environmentally friendly recycling. Disposing of laundry and water hardness, and follow the detergent manufacturer...high efficiency and front loading washers. - door) when lifting. In addition ...
Installation and Use & Care (all languages) - Page 7
...distances according to the floor. q Units are not designed for under counter installation
Pedestal Mounting If mounting the washer on the Bosch pedestal (accessory no.
in (155 sq. Socket wrench (1/2" / 13mm). 3. Bubble Level...64 mm)
Front
1/4" (6 mm)
Ventilation: Top: 48 sq.
Closet If installing the washer in a corner of the floor surface where it is to be installed on a solid ...
Installation and Use & Care (all languages) - Page 8
...be discharged per minute. - Loosen them until they can
no longer be operated with the washer and bushing attached. Storing the transport bolts Always keep the transport bolts for future use .
...reaching through the open . q Completely remove all 4 transport bolt assemblies (bolt, spring, washer and bushings) by hand when connecting the water supply hoses to the back of an unpressurized...
Installation and Use & Care (all languages) - Page 13
... locked for reasons of safety or program is running -
The display shows the Delay Start time. Switch off . Display The Ready in time...Spin Selection button For changing the spin speed (if required). Rinse Plus: Additional rinsing cycle.
Heavy duty: Increased wash time for heavily ...segment runs. Indicator lights flash: Operation error! Delay Start button The Start time can be selected).
The indicator...
Installation and Use & Care (all languages) - Page 15
... light recognizable staining. - detergent into the detergent chamber I . i The display shows the run the washer a complete cycle, without smoke staining) that the water valves for up to one... bed linen that
are still fresh. Children's outer clothing or sportswear with Ć out laundry)
Your appliance was tested before leaving the factory. Blood, egg, milk, starch (containing ...
Installation and Use & Care (all languages) - Page 20
... speed (but
not no final spin). i If the program is interrupted at a high
temperature, leave the laundry to touch.
q Close the door. q Turn the program selector to Off. Changing a program
q Turn ... appliance has cooled down until the desired Start time is not recommended to Refresh. Display shows the run time of the drum early or interrupt the program at a standstill. i ...
Installation and Use & Care (all languages) - Page 23
...to Page 25). Check whether laundry is too high. Clean and dry the detergent dispenser; Clean the water inlet strainers; drum. Use less detergent for your High Efficiency washer produce fewer suds and will ...be heard).
see Page 21.
Run any program to Page 25). Plug is flashing E:01" Spin speed cannot be carried out by an authorized technician. Power failure. Select speed before...
Installation and Use & Care (all languages) - Page 26
...; (4) a failure to comply with any applicable state, local, city, or county electrical, plumbing and/or building codes, regulations, or laws, including failure to install the product in strict conformity with local fire and building codes and regulations; (5) ordinary wear and tear, spills of food, liquid, grease accumulations, or other connecting facilities, for...
Installation and Use & Care (all languages) - Page 27
... local electrical and plumbing codes. Any and all replaced and/or repaired parts shall assume the identity of the original for home use of your clothes washer, to replace house fuses...Limited Warranty From Date of Installation*
Bosch will repair or replace, free of charge, any clothes washer that proves defective under conditions of normal home use
for two years from the date of original...
Similar Questions
Error Code E:27
Error code E:27 in the manual says that there is a door lock problem. I have removed the door lock a...
Error code E:27 in the manual says that there is a door lock problem. I have removed the door lock a...
(Posted by tamarshall50 7 years ago)
E20 And E09 Error Codes
changed the inverter board to no avail check wiring all seems okay motor winding 6.2 tach 170 ohms. ...
changed the inverter board to no avail check wiring all seems okay motor winding 6.2 tach 170 ohms. ...
(Posted by Iankerr72 8 years ago)
Bosch Washer Nexxt 300 E01 Error Code
Hi... I've encountered the error code E:01 on my bosch Nexxt 300 series washer. I've researched that...
Hi... I've encountered the error code E:01 on my bosch Nexxt 300 series washer. I've researched that...
(Posted by Rbbestwina 9 years ago)
