Amana NTW4500XQ Support Question
Amana NTW4500XQ Support Question
Find answers below for this question about Amana NTW4500XQ.Need a Amana NTW4500XQ manual? We have 5 online manuals for this item!
Question posted by thedustdevils on January 25th, 2015
Amana Ntw4650yqo Top Loading Washer. Drum Is Tipped.
was making a very loud banging noise during spin cycle. When i opened the lid, the drum was tipped. Could it be the suspension springs?
Current Answers
Answer #2: Posted by BusterDoogen on January 25th, 2015 6:01 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,407
Member since:
October 30th, 2011 Points: 28,565,407
Vibration or Off-Balance
- Check the Feet may not be in contact with the floor and locked.
- Washer may not be level.
- Load could be unbalanced.
- Front and rear feet must be in firm contact with floor, and washer must be level to operate properly. Jam nuts must be tight against the bottom of the cabinet.
- Check floor for flexing or sagging. If flooring is uneven, a 3/4" (19 mm) piece of plywood under your washer will reduce sound.
Unbalanced load
- Load dry garments in loose heaps evenly around basket wall. Adding wet garments to washer or adding more water to basket could unbalance washer.
- Wash smaller loads to reduce imbalance.
- Do not tightly pack. Avoid washing single garments.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Amana NTW4500XQ Manual Pages
Use and Care - Page 2
... cycles with these premium accessories.
ACCESSORIES
Using Less Water and Energy
Enhance your washer with controlled temperatures are used to. For more high-quality items or to order, call 1-800-807-6777 or visit us at www.whirlpoolappliances.ca
Part Number
1903WH 8212526 31682
Accessory
Laundry supply storage cart Washer drip tray, fits under...
Use and Care - Page 3
....6° C), detergents do not dissolve well and soils can be cooler than that of pre-2011 washers.
2 Wash Temperature Control
Wash Temperature Control senses and maintains uniform water temperatures by the selected wash cycle. Appearance may vary.
1
2
3
4
5
1 Load Size Control
Use this option to maintain a consistent minimum temperature. NOTE: On some models) If...
Use and Care - Page 4
... from your washer.
High/Low High/High 6 - 10
Low/Low Intermittent 4 - 6 High/High
Cycle Normal Casual
Delicate
Cycle Details: A wash time should be selected based on your previous washer provided. Wash... cycles feature a high-speed agitation and high-speed spin. Warm Some cold water will be added, so this will be cooler than your load.
CYCLE GUIDE
For models with the cycle ...
Use and Care - Page 5
... products to the bottom of clothes to wash basket.
■■ Load evenly to the dispenser. Items need to move freely for best cleaning and to ensure proper dispensing.
5 Bleach is immediately added into the washer and is added automaticallyLidquuriidngchthloerifnineal rinse cycle. Do not use more than the recommended amount.
■■ Always...
Use and Care - Page 6
... with thumbs.
2. Winterizing your washer during freezing weather, winterize it . Run washer on a drain and spin setting for a normal wash load. Washer will not operate with lid open. 6. Select Load Size.
7. On models with a permanent marker. Push the Cycle Control knob in the Cycle Control knob. ■■ To restart, close the lid and pull out the Cycle Control knob.
6
Rinse...
Use and Care - Page 7
...the load? www.amana.com/help
Noisy
■■ Is the load balanced and the washer ...load? This helps avoid flooding (due to the washer.
This washer uses much higher than traditional top load washers. Reset the rear leveling legs (if needed ). Dilute fabric softener in washer or reconnect power.
3. Periodically clean the dispensers.
■■ Did you are normal washer noises...
Use and Care - Page 8
... the problem continues, call an electrician.
■■ Is the washer in a normal pause in washer? Some cycles feature periods of the hose must be closed during operation. Was the wash load tightly packed?
Washer will not agitate or spin with the lid open ? Select a cycle with the lid open ? cycle seems stuck
■■ Is the top of the drain hose...
Use and Care - Page 9
... see the "Troubleshooting" section of the Use & Care Guide. Replacement parts or repair labor on how to use your major appliance, to instruct you . AMANA® LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or...
Warranty - Page 1
... finish of your major appliance, unless such damage results from defects in materials or workmanship and is used in the country in your home.
7. AMANA® LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or...
Dimension Guide - Page 1
... air openings in .2 (155 cm2)
0" (0 mm)
1" (25 mm)
3" (76 mm)
4.5" (113 mm)
Laundry tub...washer. Dimensions are minimum required. Install your washer to reduce noise transfer. DRAIN SYSTEM Drain system can be purchased separately. Top of laundry tub must be at least 39" (991 mm) high; Floor drain system
4.5" (113 mm)
39" (991 mm)
Minimum capacity: 20 gal. (76 L). Top-Loading Washer...
Installation Instruction - Page 2
...Pliers that open to improve performance and minimize noise and possible "washer walk".
Removable tie strap
Front leveling feet with jam nuts (2)
Drain hose form
Inlet hoses with washer)
Your ...back page of your washer to 19⁄16" (39.5 mm)
Optional tools:
Flashlight
Bucket
Parts supplied: NOTE: All parts supplied for installation are in a basement, laundry room, closet, or ...
Installation Instruction - Page 3
... of laundry tub must be exposed to reduce noise transfer. Minimum carry-away capacity: 17 gal. (64 L) per minute. Secure drain hose with water and load) of washer to ...483 mm)
48 in.2 (310 cm2)
24 in low temperatures. Top of washer.
3 install no more space for closet door ventilation openings which are required. IMPORTANT: To avoid siphoning, no higher than 96" (2.4 ...
Installation Instruction - Page 4
... only this washer is recommended.
■■ This washer is required....properly grounded.
36" (914 mm)
Move washer to within 3 ft (914 mm) ...follow steps 3 & 4 then continue to step 6; Move washer
■■ A 120 volt, 60 Hz., AC only... fuse or circuit breaker on back of washer, near bottom. If a mating outlet ...washer is necessary to remove all shipping materials for proper operation and...
Installation Instruction - Page 5
...with strap. IMPORTANT: Do not force excess drain hose back into one end of washer cabinet from top until both ends are completely removed from power cord: push power...what you may need . Remove restraint from rear panel. For a laundry tub or standpipe drain, follow steps 8 and 9. Pull cord restraint strap (D) out of washer.
8. Remove looped power cord
C
A
Gently pull hose out of...
Installation Instruction - Page 6
...TIP: Make note of water may be used. This is connected to hot water to tighten couplings an additional two-thirds turn . IMPORTANT: Do not overtighten or use tape or sealants on water faucets to faucets or washer. Do not use hoses without washers...Clear water lines
Place hose into a laundry tub, drainpipe, or bucket to faucets or washer. Check for leaks
Turn on valve when...
Installation Instruction - Page 7
... mm)
Prop up or down, repeating as necessary.
16. self-adjusting rear feet will help reduce the chance of washer, checking each foot to make sure all four feet make solid contact with removable tie strap (A). Secure drain hose
Laundry Tub
Standpipe
Wall
17. This will click into threaded holes at front corners of...
Installation Instruction - Page 8
HELPFUL TIP: You may want to prop washer again with wooden block, then make sure to complete full cycle.
20. Be sure you have all of your washer, measure 1/2 of normal recommended amount of /recycle all parts are now installed. Select any tape remaining on washer.
■■ Check that all packaging materials.
■■ Read "Washer Use...
Energy Guide - Page 1
... therm.
• For more information, visit www.ftc.gov/appliances. (P/N W10344455)
Clothes Washer Capacity: Standard
Maytag Model: NTW4500X* Cat. V01Y1NTN(3B)
Estimated Yearly Operating Cost
(when used...based only on standard capacity models. • Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65 cents per kWh and natural gas...
Similar Questions
Nfw7300ww02 Amana Front Load Washer Will Not Spin Fast.
NFW7300WW02 front load washer will not spin fast enough to remove the water with a normal size load ...
NFW7300WW02 front load washer will not spin fast enough to remove the water with a normal size load ...
(Posted by rtdk 3 years ago)
After An Unbalanced Load, Washer Will Not Work Properly...what Can I Do?
I've tried method of resetting motor. I've also tried moving the dial to the left and to the right a...
I've tried method of resetting motor. I've also tried moving the dial to the left and to the right a...
(Posted by heenanbetty 6 years ago)
It Was Making A Loud & Violent Banging Noise. There Is Still Water Inside.
The drum is tilted dramatically to one side. and will not staighten. (I can't get the water to drain...
The drum is tilted dramatically to one side. and will not staighten. (I can't get the water to drain...
(Posted by thedustdevils 9 years ago)
I Have An Amana Washer #ntw4600vqo Trying To Stop The Violent Spin Cycle,help
Ever since we have had this washer we havn't been able to stop the violent spin cycle. Tried to leve...
Ever since we have had this washer we havn't been able to stop the violent spin cycle. Tried to leve...
(Posted by rojoinc4165 11 years ago)