Alpine MRP-M350 Support Question
Find answers below for this question about Alpine MRP-M350.Need a Alpine MRP-M350 manual? We have 1 online manual for this item!
Question posted by robertbeebe1974 on August 26th, 2023
How To Wire In The 4 Prong Plug
Current Answers
Answer #1: Posted by INIMITABLE on August 26th, 2023 12:56 AM
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers
-INIMITABLE
Answer #2: Posted by Hanna0809 on August 26th, 2023 3:37 AM
1. Connect red wire to +12V.
2. Connect black wire to ground.
3. Attach blue wire to switched 12V.
4. Connect speaker wires correctly.
5. Plug RCA cables into inputs.
6. Adjust gain and crossover.
7. Add fuse near battery.
8. Double-check everything before powering on.
Answer #3: Posted by SonuKumar on August 26th, 2023 10:43 AM
A 4-prong speaker wire harness
A crimping tool
A wire stripper
Instructions:
Strip about 1/2 inch of insulation from the end of each speaker wire.
Crimp a connector onto each speaker wire.
Connect the speaker wires to the corresponding terminals on the amplifier.
Secure the connectors with the screws provided.
Here is a diagram of the amplifier's terminals:
1: Ground
2: Positive (+)
3: Negative (-)
4: Remote
The ground terminal is the one with the green stripe. The positive terminal is the one with the red stripe. The negative terminal is the one with the black stripe. The remote terminal is the one with the white stripe.
Once you have connected the speaker wires to the amplifier, you can test the amplifier by connecting it to a power source and a speaker.
Here are some safety precautions to keep in mind when wiring the amplifier:
Always disconnect the power before working on the amplifier.
Be careful not to strip too much insulation from the speaker wires.
Make sure that the connectors are properly crimped.
Do not overtighten the screws.
I hope this helps!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Similar Questions
I have a alpine map 300f amp. 4 channel, do I hook each speaker to it's on channel ? My radio has rc...
how to install a alpine flip out head unit without a tuner unit
I HAVE A ALPINE V-POWER MONO AMP MRP-M500 CAN I HOOK THIS UP TO MY ALPINE HEAD UNIT AND 2 FRONT SPEA...
my radio has front rca for right and left speakers and rear rca for right and left speakers, how to ...